Disclaimer
How to change front anti roll bar bushes on VW Polo Saloon (9A4, 9A2, 9N2, 9A6) – replacement guide
downloads:
1
Views:
26
Important!
This replacement procedure can be used for:
VW Polo Saloon (9A4, 9A2, 9N2, 9A6) 1.4 … View more
The steps may slightly vary depending on the car design.
VW Polo Saloon (9A4, 9A2, 9N2, 9A6) 1.4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Anti Roll Bar Bushes for Polo Saloon (9A4, 9A2, 9N2, 9A6) and other VW models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 13
Combination spanner #13
Wheel impact socket #17
Torque wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: anti roll bar bushes – VW POLO Saloon (9A4). AUTODOC experts recommend:
- Both stabilizer bushes should be replaced simultaneously.
- The replacement procedure is identical for the right and left stabilizer bushes.
- All work should be done with the engine stopped.
Replacement: anti roll bar bushes – VW POLO Saloon (9A4). Use the following procedure:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3Raise the front of the car and secure on supports.Step 4
Unscrew the wheel bolts.AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Clean the fasteners of the stabilizer bush brackets. Use a wire brush. Use WD-40 spray. - Step 7
Unscrew the fasteners of the stabilizer bush brackets. Use a combination spanner #13. - Step 8
Support the arm. Use a hydraulic transmission jack. - Step 9
Remove the fastening bolts (2 pieces). - Step 10
Lower the hydraulic transmission jack by 10-15 cm.AUTODOC recommends:Replacement: anti roll bar bushes – VW POLO Saloon (9A4). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms. - Step 11
Remove the stabilizer bush brackets. Use a crowbar. - Step 12
Remove the stabilizer bushes. - Step 13
Install the new stabilizer bushes. - Step 14
Install the stabilizer bush brackets.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Polo IV Saloon (9A4, 9A2, 9N2, 9A6) model
Popular maintenance tutorials for VW Polo 9A4
Complete guides for changing the Stabilizer bushes on different VW POLO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Polo Saloon (9A4, 9A2, 9N2, 9A6)
View more
Top 5 car noises you shouldn't ignore
How I started restoring a driveshaft | Drivetrain restoration – Part 1
Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips
Don’t Replace, Restore: Fixing Damaged Threads at Home
Most commonly replaced car parts on VW POLO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




























