
Disclaimer
How to change front anti roll bar links on NISSAN Micra C+C III (K12) – replacement guide
downloads:
3
Views:
26
Important!
This replacement procedure can be used for:
NISSAN Micra C+C III (K12) 1.6 160 SR, NISSAN Micra C+C III (K12) 1.4 16V … View more
The steps may slightly vary depending on the car design.
NISSAN Micra C+C III (K12) 1.6 160 SR, NISSAN Micra C+C III (K12) 1.4 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Anti Roll Bar Links for Micra C+C III (K12) and other NISSAN models
Anti-roll bar link
Alternative products

Wire brush
WD-40 spray
All-purpose cleaning spray
Ceramic grease
Torque wrench
Combination spanner #17
Drive socket # 17
HEX bit no.H5.
Wheel impact socket #17
Ratchet wrench
Tap wrench
Wheel chock
AUTODOC recommends:
- Replace the stabiliser links on NISSAN MICRA C+C (K12) in pairs.
- The replacement procedure is identical for both stabiliser links on the same axle.
- All work should be done with the engine stopped.
Replacement: anti roll bar links – NISSAN MICRA C+C (K12). Take the following steps:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel bolts. Use wheel impact socket #17. Use a tap wrench.
- Step 3Raise the car.Replacement: anti roll bar links – NISSAN MICRA C+C (K12). AUTODOC recommends:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.Step 4Unscrew the wheel bolts.AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 5Remove the wheel.
- Step 6Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use HEX No.H5. Use a ratchet wrench.
- Step 8Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #17. Use HEX No.H5. Use a ratchet wrench.
- Step 9Remove the stabiliser link.
- Step 10Clean the mounting seats of the stabiliser link. Use a wire brush. Use all-purpose cleaning spray.
- Step 11Install a new stabiliser link and tighten the fasteners.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Micra C+C III (K12) model
Popular maintenance tutorials for Nissan Micra k12 Convertible
Complete guides for changing the Drop links on different NISSAN MICRA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN Micra C+C III (K12)
View more
- What to do if your check engine light is on | AUTODOC tips
- DIY vehicle AC compressor restoration
- DIY alternator repair | AUTODOC tips
- TOP 5 mistakes during DIY oil change | AUTODOC tips
Most commonly replaced car parts on NISSAN MICRA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME