Important!

This replacement procedure can be used for:
TOYOTA CELICA (ZZT23_) 1.8 16V VT-i (ZZT230_), TOYOTA CELICA (ZZT23_) 1.8 16V TS (ZZT231_) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for CELICA (ZZT23_) and other TOYOTA models

Wheel bearing kit

Wheel bearing kit for Celica VII Coupe (T230) Petrol (143 hp)

Simple DIY car repair steps – Replacing Wheel bearing kit on Celica VII Coupe (T230)

Wheel bearing kit for Celica VII Coupe (T230) Petrol (192 hp)

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Drive socket # 10 
                      
                        Wheel impact socket #21
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Tap wrench
                      
                        Flat Screwdriver
                      
                        Wheel chock

Buy tools

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). AUTODOC recommends:

Do not re-use the bearing assembly of your TOYOTA CELICA (ZZT23_) car.
The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
All work should be done with the engine stopped.

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). Take the following steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 3

Raise the rear of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. TOYOTA CELICA (ZZT23_)
Step 5

Remove the wheel.
Step 6

Clean the brake drum. Use a wire brush. Use WD-40 spray.
Step 7

Remove the brake drum.

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). AUTODOC experts recommend:
Examine the brake drum. Replace it if necessary.
Step 8

Clean the wheel hub fastener. Use a wire brush. Use WD-40 spray.
Step 9

Detach the ABS sensor connector. Use a flat screwdriver.
Step 10

Disconnect the ABS sensor wiring.
Step 11

Unscrew the hub bearing mounting. Use a drive socket #10. Use a ratchet wrench. Use a tap wrench.
Step 12

Remove the hub and the bearing together, since they are a sealed unit.
Step 13

Clean the hub bearing mounting seat. Use a wire brush.
Step 14

Install the new wheel hub with a bearing.
Step 15

Tighten the fastener of the wheel hub bearing. Use a drive socket #10. Use a torque wrench. Tighten it to 61 nm torque.

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). Professionals recommend:
The wheel bearing unit must not tilt on the axle pin.
Step 16

Treat the fasteners of the wheel hub bearing. Use copper grease.
Step 17

Connect the ABS sensor wiring.
Step 18

Attach the ABS sensor connector.
Step 19

Treat the wheel hub in the area where it contacts the brake drum. Use copper grease.
Step 20

Install the brake drum and fasten it.
Step 21

Treat the surface where the wheel rim contacts the brake drum. Use copper grease.
Step 22

Install the wheel.

Replacement: wheel bearing – TOYOTA CELICA (ZZT23_). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 23

Screw in the wheel bolts. Use wheel impact socket #21.
Step 24

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 103 nm torque.
Step 25

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Celica VII Coupe (T230) model.

Browse tyres

How to change front anti roll bar links on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
1.44 MB
How to change front brake pads on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
1.42 MB
How to change spark plugs on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
1.39 MB
How to change rear windshield wipers on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
532.48 KB
How to change front windshield wipers on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
1.5 MB
How to change engine oil and filter on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
2.04 MB

How to change wheel bearing on a car – replacement tutorial

Universal

Free download PDF
2.41 MB
How to change front wheel bearing on Toyota RAV4 III – replacement guide

Free download PDF
2.46 MB
How to change front wheel bearing on Toyota Yaris P1 – replacement guide

Free download PDF
2.53 MB
How to change front wheel bearing on Toyota Yaris Mk2 – replacement guide

Free download PDF
3.78 MB
How to change rear wheel bearing on Toyota Auris E15 – replacement guide

Free download PDF
2.26 MB
How to change rear wheel bearing on Toyota Yaris P1 – replacement guide

Free download PDF
1.13 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Causes of a worn car boot damper | AUTODOC

3K views

Published on: 04/07/2021
How to Make a DIY Foam Sprayer | AUTODOC tips

208K views

Published on: 23/06/2022
How and why to check your oil | AUTODOC tips

5K views

Published on: 23/02/2023
DIY jack restoration | AUTODOC tips

12K views

Published on: 22/09/2022