Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
TOYOTA CELICA (ZZT23_) 1.8, TOYOTA CELICA (ZZT23_) 1.8 16V VT-i (ZZT230_) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for CELICA (ZZT23_) and other TOYOTA models

Alternative products

Brake pad set

Replacement: brake pads – TOYOTA CELICA (ZZT23_). Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Combination spanner #13
                    
                      Combination spanner #17
                    
                      Drive socket # 13 
                    
                      Wheel impact socket #21
                    
                      Brake caliper wind back tool
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – TOYOTA CELICA (ZZT23_). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). Tip from AUTODOC:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Spread the brake pads. Use a crowbar.
Step 8

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 9

Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #17.
Step 10

Remove the brake caliper.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). Tip:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads. Use a crowbar.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). AUTODOC experts recommend:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use WD-40 spray.
Step 13

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – TOYOTA CELICA (ZZT23_). After applying the spray, wait a few minutes.
Step 14

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). Tip from AUTODOC experts:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 35 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). AUTODOC experts recommend:
After applying the spray, wait a few minutes.
Step 20

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. TOYOTA CELICA (ZZT23_)
Step 21

Screw in the wheel bolts. Use wheel impact socket #21.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 103 Nm torque.
Step 23

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – TOYOTA CELICA (ZZT23_). Check the brake fluid level in the reservoir and top up if necessary.
Step 24

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
TOYOTA CELICA (ZZT23_) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 25

Close the hood.

Replacement: brake pads – TOYOTA CELICA (ZZT23_). AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Celica VII Coupe (T230) model

Toyota Celica T23 tyre size

How to change rear wheel bearing on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
1.5 MB
How to change spark plugs on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
1.39 MB
How to change rear windshield wipers on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
532.48 KB
How to change front windshield wipers on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
1.5 MB
How to change front anti roll bar links on TOYOTA CELICA (ZZT23_) – replacement guide

Free download PDF
1.44 MB
How to change engine oil and filter on TOYOTA Celica VII Coupe (T230) – replacement guide

Free download PDF
2.04 MB

How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on Toyota Prado J120 – replacement guide

Free download PDF
2.08 MB
How to change rear brake pads on Toyota Auris E15 – replacement guide

Free download PDF
1.53 MB
How to change rear brake pads on Toyota Prado J120 – replacement guide

Free download PDF
1.93 MB
How to change front brake pads on Toyota Aygo AB1 – replacement guide

Free download PDF
2.47 MB
How to change rear brake pads on Toyota RAV4 III – replacement guide

Free download PDF
1.96 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Prevent Engine Damage: How to Identify Rocker Cover Gasket Issues and Proper Replacement | AUTODOC

5K views

Published on: 03/12/2020
DIY brake caliper restoration | AUTODOC tips

746K views

Published on: 02/06/2022
Transform Your Old Engine Valve Cover: Quick Polishing Tips for a Shiny Finish | AUTODOC Tips

10K views

Published on: 30/11/2023
Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips

6K views

Published on: 14/03/2024