Important!
This replacement procedure can be used for:
FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 2.0 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6, FORD Focus II Hatchback (DA_, HCP, DP) 1.6, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 Ti, FORD Focus II Hatchback (DA_, HCP, DP) 2.0, FORD Focus II Hatchback (DA_, HCP, DP) 1.4, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 2.0 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 2.5 ST, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 Flexifuel, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 Flexifuel, FORD Focus II Hatchback (DA_, HCP, DP) 2.0 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8, FORD Focus II Hatchback (DA_, HCP, DP) 2.5 RS, FORD Focus II Hatchback (DA_, HCP, DP) 2.0 CNG, FORD Focus II Hatchback (DA_, HCP, DP) 2.0 LPG, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 LPG, FORD Focus II Hatchback (DA_, HCP, DP) 2.5 RS 500 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for Focus II Hatchback (DA_, HCP, DP) and other FORD models
Tools
Replacement: wheel bearing – FORD FOCUS II (DA_). Tools you need:
Wire brush
WD-40 spray
Brake cleaner
All-purpose cleaning spray
Electronic spray
Copper grease
Torque wrench
Combination spanner #13
Drive socket # 13
Torx bit T50
Wheel impact socket #19
Tap wrench
Crow bar
Flat Screwdriver
Rubber mallet
Water pump pliers
Wheel chock
Replacement: wheel bearing – FORD FOCUS II (DA_). AUTODOC recommends:
  • Do not re-use the bearing assembly of your FORD FOCUS II (DA_) car.
  • The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
  • All work should be done with the engine stopped.
Replacement: wheel bearing – FORD FOCUS II (DA_). Recommended sequence of steps:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Wheel Bearing on Ford Focus Mk2 2004 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  2. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    How to replace FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi 2005 Wheel Bearing - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. FORD FOCUS II (DA_)
  3. Step 5
    Ford Focus Mk2 1.8 TDCi 2006 Wheel Bearing replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Changing Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 2.5 ST 2007 by yourself
    Clean the fastener of the parking brake cable. Use a wire brush. Use all-purpose cleaning spray.
  5. Step 7
    How to remove FORD FOCUS 1.6 Ti 2008 Wheel Bearing - online easy-to-follow instructions
    Release the parking brake cable. Use water pump pliers.
  6. Step 8
    How to replace Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 2009: download PDF manuals and video instructions
    Spread the brake pads. Use a crowbar.
  7. Step 9
    How hard is it to do yourself: Wheel Bearing replacement on Ford Focus Mk2 1.8 Flexifuel 2010 - download illustrated guide
    Clean the brake caliper bracket fasteners. Use a wire brush. Use all-purpose cleaning spray.
  8. Step 10
    Need to know how to renew Wheel Bearing on FORD FOCUS 2011? This free workshop manual will help you to do it yourself
    Unscrew the caliper bracket fastening. Use a combination spanner #13.
  9. Step 11
    Changing of Wheel Bearing on Ford Focus Mk2 2012 won't be an issue if you follow this illustrated step-by-step guide
    Disconnect the brake hose. Use a crowbar.
  10. Step 12
    FORD FOCUS 2.0 Wheel Bearing replacement: online guides and video tutorials
    Remove the brake caliper together with its bracket. Use a crowbar.
    Replacement: wheel bearing – FORD FOCUS II (DA_). AUTODOC experts recommend:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Step 13
    Replacing Wheel Bearing on Ford Focus Mk2 2005 1.6 TDCi by yourself
    Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
  12. Step 14
    Focus II Hatchback (DA_, HCP, DP) 1.6 Ti 2006 Wheel Bearing DIY replacement workshop manual
    Remove the brake disc. Use a rubber mallet.
  13. Step 15
    How to change Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 2007 - tips and tricks
    Clean the fasteners of the wheel hub bearing. Use a wire brush. Use WD-40 spray.
  14. Step 16
    Step-by-step recommendations for DIY replacement Ford Focus Mk2 2008 1.6 Ti Wheel Bearing
    Clean the ABS sensor mounting seat. Use all-purpose cleaning spray.
  15. Step 17
    DIY replacement of Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 1.6 2009 is not an issue anymore with our step-by-step tutorial
    Detach the ABS sensor connector. Use a flat screwdriver.
  16. Step 18
    How to change Wheel Bearing on Ford Focus Mk2 2004 - free PDF and video manuals
    Unscrew the wheel hub bolts. Use Torx T50. Use a tap wrench.
  17. Step 19
    How to replace FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi 2005 Wheel Bearing - step-by-step manuals and video guides
    Remove the hub and the bearing together, since they are a sealed unit.
  18. Step 20
    Ford Focus Mk2 1.8 TDCi 2006 Wheel Bearing replacement: free workshop manuals
    Remove the brake disc baffle plate.
  19. Step 21
    Changing Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 2.5 ST 2007 by yourself
    Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray.
  20. Step 22
    How to remove FORD FOCUS 1.6 Ti 2008 Wheel Bearing - online easy-to-follow instructions
    Install the brake disc baffle plate.
  21. Step 23
    How to replace Wheel Bearing on FORD Focus II Hatchback (DA_, HCP, DP) 2009: download PDF manuals and video instructions
    Install the new wheel hub with a bearing.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Focus Mk2 Hatchback (DA_, HCP, DP) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
FORD Focus II Hatchback (DA_, HCP, DP) Wheel Bearing replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY FORD Focus II Hatchback (DA_, HCP, DP) Wheel Bearing replacement - online guide
Tips & tricks for your FORD Focus II Hatchback (DA_, HCP, DP)
View more
  • How to change Wheel bearings on FORD Focus II Hatchback (DA_, HCP, DP) 1.6 - replacement tricks
    How to easily repair a punctured tyre | AUTODOC tips
  • Changing Hub bearing Ford Focus Mk2 1.6 TDCi - Replacement Tips
    How to wash your car in winter | AUTODOC tips
  • Maintenance Hacks - FORD Focus II Hatchback (DA_, HCP, DP) 1.8 TDCi Wheel bearing kit replacement guide
    DIY jack restoration | AUTODOC tips
  • Replace Wheel hub bearing on Ford Focus Mk2 - free video tips
    How to save when buying car parts