How to carry out replacement: Wheel Bearing 1.6 TDCi Focus C-Max (DM2)
Disclaimer
Change Focus C-Max (DM2) 2.0 TDCi Wheel Bearing yourself – manuals and video tutorials

How to change rear wheel bearing on FORD Focus C-Max (DM2) – replacement guide

downloads: 1
Views: 88
Download your free tutorial and fix FORD Focus C-Max (DM2) 1.6 TDCi problems yourself Download for free 2.25 MB Wheel Bearing for Focus C-Max (DM2) Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
FORD Focus C-Max (DM2) 2.0 TDCi, FORD Focus C-Max (DM2) 1.8, FORD Focus C-Max (DM2) 1.6 TDCi, FORD Focus C-Max (DM2) 2.0 TDCi, FORD Focus C-Max (DM2) 1.6, FORD Focus C-Max (DM2) 2.0, FORD Focus C-Max (DM2) 1.8, FORD Focus C-Max (DM2) 1.6 Ti, FORD Focus C-Max (DM2) 1.6 TDCi, FORD Focus C-Max (DM2) 1.8 TDCi, FORD Focus C-Max (DM2) 1.8 Flexifuel, FORD Focus C-Max (DM2) 1.8 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for Focus C-Max (DM2) and other FORD models
Alternative products
How to change Wheel bearing kit on Focus C-Max (DM2) 1.6 TDCi – step-by-step instructions for straightforward car repair Wheel bearing kit
Tools
Replacement: wheel bearing – FORD FOCUS C-MAX. Tools you need:
Wire brush
WD-40 spray
Brake cleaner
All-purpose cleaning spray
Electronic spray
Copper grease
Torque wrench
Combination spanner #13
Drive socket # 13
Torx bit T50
Wheel impact socket #19
Tap wrench
Crow bar
Flat Screwdriver
Rubber mallet
Water pump pliers
Wheel chock
Buy tools
Replacement: wheel bearing – FORD FOCUS C-MAX. AUTODOC recommends:
  • Do not re-use the bearing assembly of your FORD FOCUS C-MAX car.
  • The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
  • All work should be done with the engine stopped.
Replacement: wheel bearing – FORD FOCUS C-MAX. Recommended sequence of steps:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Wheel Bearing on Focus C-Max (DM2) 2003 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  2. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    How to replace FORD Focus C-Max (DM2) 1.6 TDCi 2004 Wheel Bearing - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. FORD FOCUS C-MAX
  3. Step 5
    Focus C-Max (DM2) 2.0 TDCi 2005 Wheel Bearing replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Changing Wheel Bearing on FORD Focus C-Max (DM2) 1.6 2006 by yourself
    Clean the fastener of the parking brake cable. Use a wire brush. Use all-purpose cleaning spray.
  5. Step 7
    How to remove FORD FOCUS 1.8 2007 Wheel Bearing - online easy-to-follow instructions
    Release the parking brake cable. Use water pump pliers.
  6. Step 8
    How to replace Wheel Bearing on FORD Focus C-Max (DM2) 2003: download PDF manuals and video instructions
    Spread the brake pads. Use a crowbar.
  7. Step 9
    How hard is it to do yourself: Wheel Bearing replacement on Focus C-Max (DM2) 2.0 2004 - download illustrated guide
    Clean the brake caliper bracket fasteners. Use a wire brush. Use all-purpose cleaning spray.
  8. Step 10
    Need to know how to renew Wheel Bearing on FORD FOCUS 2005? This free workshop manual will help you to do it yourself
    Unscrew the caliper bracket fastening. Use a combination spanner #13.
  9. Step 11
    Changing of Wheel Bearing on Focus C-Max (DM2) 2006 won't be an issue if you follow this illustrated step-by-step guide
    Disconnect the brake hose. Use a crowbar.
  10. Step 12
    FORD FOCUS 2.0 TDCi Wheel Bearing replacement: online guides and video tutorials
    Remove the brake caliper together with its bracket. Use a crowbar.
    Replacement: wheel bearing – FORD FOCUS C-MAX. AUTODOC experts recommend:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Step 13
    Replacing Wheel Bearing on Focus C-Max (DM2) 2003 1.6 TDCi by yourself
    Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
  12. Step 14
    Focus C-Max (DM2) 1.8 2004 Wheel Bearing DIY replacement workshop manual
    Remove the brake disc. Use a rubber mallet.
  13. Step 15
    How to change Wheel Bearing on FORD Focus C-Max (DM2) 2005 - tips and tricks
    Clean the fasteners of the wheel hub bearing. Use a wire brush. Use WD-40 spray.
  14. Step 16
    Step-by-step recommendations for DIY replacement Focus C-Max (DM2) 2006 1.8 Wheel Bearing
    Clean the ABS sensor mounting seat. Use all-purpose cleaning spray.
  15. Step 17
    DIY replacement of Wheel Bearing on FORD Focus C-Max (DM2) 1.8 TDCi 2007 is not an issue anymore with our step-by-step tutorial
    Detach the ABS sensor connector. Use a flat screwdriver.
  16. Step 18
    How to change Wheel Bearing on Focus C-Max (DM2) 2003 - free PDF and video manuals
    Unscrew the wheel hub bolts. Use Torx T50. Use a tap wrench.
  17. Step 19
    How to replace FORD Focus C-Max (DM2) 1.6 TDCi 2004 Wheel Bearing - step-by-step manuals and video guides
    Remove the hub and the bearing together, since they are a sealed unit.
  18. Step 20
    Focus C-Max (DM2) 2.0 TDCi 2005 Wheel Bearing replacement: free workshop manuals
    Remove the brake disc baffle plate.
  19. Step 21
    Changing Wheel Bearing on FORD Focus C-Max (DM2) 1.6 2006 by yourself
    Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray.
  20. Step 22
    How to remove FORD FOCUS 1.8 2007 Wheel Bearing - online easy-to-follow instructions
    Install the brake disc baffle plate.
  21. Step 23
    How to replace Wheel Bearing on FORD Focus C-Max (DM2) 2003: download PDF manuals and video instructions
    Install the new wheel hub with a bearing.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the FORD Focus C-Max (DM2) model

Focus C-Max (DM2) tyre size

Popular maintenance tutorials for Focus C-Max (DM2)

More manuals for Focus C-Max (DM2)

Complete guides for changing the Wheel bearings on different FORD FOCUS models

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY FORD Focus C-Max (DM2) Wheel Bearing replacement - online guide
Tips & tricks for your FORD Focus C-Max (DM2)
View more
  • How to change Wheel bearings on FORD Focus C-Max (DM2) 1.8 TDCi - replacement tricks
    What to do if your check engine light is on | AUTODOC tips
    19K views
    Published on: 19/08/2020
  • Changing Hub bearing Focus C-Max (DM2) 1.6 TDCi - Replacement Tips
    TOP 5 mistakes during DIY oil change | AUTODOC tips
    36K views
    Published on: 17/06/2021
  • Maintenance Hacks - FORD Focus C-Max (DM2) 2.0 TDCi Wheel bearing kit replacement guide
    7 signs of faulty fuel injectors | AUTODOC tips
    9K views
    Published on: 09/01/2025
  • Replace Wheel hub bearing on Focus C-Max (DM2) - free video tips
    Understanding Airbag Light Warnings | Essential Tips for Car Safety
    6K views
    Published on: 10/04/2023

Most commonly replaced car parts on FORD FOCUS

Professional manuals for the most common FORD models

Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
FORD Focus C-Max (DM2) Wheel Bearing replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME