Important!

This replacement procedure can be used for:
TOYOTA Yaris Verso (_P2_) 1.3 (NCP20_, NCP22_), TOYOTA Yaris Verso (_P2_) 1.5 (NCP21_), TOYOTA Yaris Verso (_P2_) 1.4 D-4D (NLP20_, NLP22_), TOYOTA Yaris Verso (_P2_) 1.3 (NCP20_, NCP22_), TOYOTA Yaris Verso (_P2_) 1.5 4WD (NCP25) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for Yaris Verso (_P2_) and other TOYOTA models

Suspension arm

        Suspension arm for Yaris Verso (P2) Petrol (86 hp)
      
        Suspension arm for Yaris Verso (P2) Petrol (106 hp)
      
        Suspension arm for Yaris Verso (P2) Diesel (75 hp)
      
        Suspension arm for Yaris Verso (P2) Petrol (84 hp)
      
        Suspension arm for Yaris Verso (P2) Petrol (106 hp)

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Combination spanner #10
                      
                        Combination spanner #13
                      
                        Combination spanner #17
                      
                        Combination spanner #19
                      
                        Drive socket # 17 
                      
                        Wheel impact socket #21
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Tap wrench
                      
                        Ball joint puller
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). AUTODOC recommends:

The replacement procedure is identical for the left and right lower control arms.
All work should be done with the engine stopped.

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Recommended sequence of steps:

Step 1

Secure the wheels with chocks.

Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. TOYOTA YARIS VERSO (_NLP2_, _NCP2_)
Step 5

Remove the wheel.
Step 6

Clean the fastener connecting the ball joint to the steering knuckle. Use a wire brush. Use WD-40 spray.

Step 7

Unscrew the ball joint fastening to the steering knuckle. Use a combination spanner #19.
Step 8

Disconnect the ball joint from the steering knuckle. Use a ball joint puller.
Step 9

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.

Step 10

Unscrew the fastener connecting the stabilizer bar with the control arm. Use a combination spanner #13. Use a combination spanner #10.
Step 11

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 12

Unscrew the front arm fastener. Use a drive socket #17. Use a tap wrench. Use a ratchet wrench.
Step 13

Support the engine in the oil pan area. Use a hydraulic transmission jack.

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Professionals recommend:
Make sure that the engine is supported.
Step 14

Unscrew the rear fastener connecting the control arm to the subframe. Use a combination spanner #17. Use a drive socket #17. Use a ratchet wrench.
Step 15

Remove the arm.
Step 16

Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
Step 17

Install a new arm.

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). AUTODOC experts recommend:
During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
Step 18

Screw the rear fastener connecting the control arm to the subframe. Use a combination spanner #17. Use a drive socket #17. Use a ratchet wrench. Use a tap wrench.
Step 19

Screw the front arm fastener. Use a drive socket #17. Use a ratchet wrench. Use a tap wrench.
Step 20

Remove the support from under the engine.

AUTODOC recommends:
Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 21

Connect the ball joint to the steering knuckle.
Step 22

Tighten the ball joint fastener. Use a combination spanner #19. Use a torque wrench. Tighten it to 98 nm torque.
Step 23

Prop up the steering knuckle. Use a hydraulic transmission jack.
Step 24

Tighten the fastener connecting the stabilizer bar with the control arm. Use a combination spanner #13. Use a combination spanner #10. Use a torque wrench. Tighten it to 18 Nm torque.
Step 25

Tighten the front fastener connecting the control arm to the subframe. Use a drive socket #17. Use a torque wrench. Tighten it to 88 Nm torque.

Step 26

Tighten the rear fastener connecting the arm to the body subframe. Use a drive socket #17. Use a torque wrench. Tighten it to 132 Nm torque.
Step 27

Remove the support from under the steering knuckle.

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Tip:
Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
Step 28

Treat all joints of the arm. Use copper grease.

Step 29

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 30

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). After applying the spray, wait a few minutes.
Step 31

Install the wheel.

Replacement: front lower arm – TOYOTA YARIS VERSO (_NLP2_, _NCP2_). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 32

Screw in the wheel bolts. Use wheel impact socket #21.

Step 33

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #21. Use a torque wrench. Tighten it to 103 Nm torque.

Step 34

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Yaris Verso (P2) model.

Toyota Yaris Verso tyre size

How to change front anti roll bar links on TOYOTA Yaris Verso (_P2_) – replacement guide

Free download PDF
1.6 MB
How to change front wheel bearing on TOYOTA Yaris Verso (_P2_) – replacement guide

Free download PDF
2.53 MB
How to change rear wheel bearing on TOYOTA Yaris Verso (_P2_) – replacement guide

Free download PDF
1.13 MB
How to change front strut mount on TOYOTA Yaris Verso (_P2_) – replacement guide

Free download PDF
1.85 MB
How to change track rod end on TOYOTA Yaris Verso (_P2_) – replacement guide

Free download PDF
1.34 MB
How to change front brake pads on TOYOTA Yaris Verso (P2) – replacement guide

Free download PDF
1.41 MB

How to change front lower arm on Toyota Yaris P1 – replacement guide

Free download PDF
1.71 MB
How to change control arm on a car – replacement tutorial

Universal

Free download PDF
1.07 MB
How to change front upper arm on Toyota Prado J120 – replacement guide

Free download PDF
2.74 MB
How to change rear suspension lower control arm on Toyota RAV4 III – replacement guide

Free download PDF
1.95 MB
How to change front lower arm on Toyota Auris E15 – replacement guide

Free download PDF
2.79 MB
How to change front lower arm on Toyota RAV4 III – replacement guide

Free download PDF
2.41 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 mistakes made when washing the engine | AUTODOC tips

29K views

Published on: 22/04/2021
Top 5 mistakes when replacing spark plugs | AUTODOC tips

9K views

Published on: 13/07/2023
What to do if your check engine light is on | AUTODOC tips

16K views

Published on: 19/08/2020
3 things to know before buying summer tyres | AUTODOC tips

3K views

Published on: 18/05/2023