Important!

This replacement procedure can be used for:
PEUGEOT 107 Hatchback (PM_, PN_) 1.4 HDi … View more

The steps may slightly vary depending on the car design.

How to change tie rod end / track rod end on PEUGEOT 107 1 (PM, PN) [TUTORIAL AUTODOC]

All the parts you need to replace – Track Rod End for 107 Hatchback (PM_, PN_) and other PEUGEOT models

Alternative products

Track rod end

Replacement: track rod end – Peugeot 107 PM PN. List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #17
                    
                      Combination spanner #19
                    
                      Drive socket # 17 
                    
                      Drive socket # 19 
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Tap wrench
                    
                      Flat Screwdriver
                    
                      Nippers
                    
                      Vernier caliper
                    
                      Crow bar
                    
                      Ball joint puller
                    
                      Wheel chock

Buy tools

Replacement: track rod end – Peugeot 107 PM PN. Tip from AUTODOC experts:

Replace tie rod ends in pairs.
The replacement procedure is identical for the right and left tie rod ends.
All work should be done with the engine stopped.

Replacement: track rod end – Peugeot 107 PM PN. Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.
Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. Peugeot 107 PM PN
Step 5

Remove the wheel.
Step 6

Remove the cotter pin fixing the tie rod end fastening. Use a crowbar. Use a flat screwdriver. Use nippers.
Step 7

Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 8

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Step 9

Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #17.
Step 10

Unscrew the end fastening nut to the steering knuckle. Use a drive socket #17. Use a tap wrench.
Step 11

Disconnect the tie rod end from the steering knuckle. Use a ball joint puller.
Step 12

Screw the end out of the tie rod.
Step 13

Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray.
Step 14

Screw on a new tie rod end.

Replacement: track rod end – Peugeot 107 PM PN. Professionals recommend:
While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Step 15

Connect the tie rod end to the steering knuckle.
Step 16

Screw on the fastening nut that connects the tie rod end to the steering knuckle. Use a drive socket #19. Use a ratchet wrench.
Step 17

Screw on the tie rod end jam nut. Use a combination spanner #17. Use a combination spanner #19.
Step 18

Tighten the tie rod end locknut. Use a combination spanner #17. Use a combination spanner #19. Use a torque wrench. Tighten it to 47 nm torque.
Step 19

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Step 20

Tighten the fastening nut connecting the tie rod end to the steering knuckle. Use a drive socket #19. Use a torque wrench. Tighten it to 33 nm torque.
Step 21

Treat the fastener connecting the tie rod end to the steering knuckle. Use copper grease.
Step 22

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 23

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: track rod end – Peugeot 107 PM PN. After applying the spray, wait a few minutes.
Step 24

Install the wheel.

Replacement: track rod end – Peugeot 107 PM PN. AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 25

Screw in the wheel bolts. Use wheel impact socket #17.
Step 26

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 nm torque.

Replacement: track rod end – Peugeot 107 PM PN. AUTODOC experts recommend:
Check and adjust wheel alignment if necessary.
Step 27

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 107 Hatchback (PM, PN) model

Peugeot 107 PN tyre size

How to change front lower arm on Peugeot 107 PM PN – replacement guide

Free download PDF
2.19 MB
How to change front anti roll bar links on Peugeot 107 PM PN – replacement guide

Free download PDF
1.75 MB
How to change rear wheel bearing on PEUGEOT 107 Hatchback (PM, PN) – replacement guide

Free download PDF
1.67 MB
How to change front brake pads on Peugeot 107 PM PN – replacement guide

Free download PDF
1.62 MB
How to change front brake discs on Peugeot 107 PM PN – replacement guide

Free download PDF
2.12 MB
How to change spark plugs on Peugeot 107 PM PN – replacement guide

Free download PDF
1.79 MB

How to change track rod end on a car – replacement tutorial

Universal

Free download PDF
1.31 MB
How to change track rod end on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.52 MB
How to change track rod end on Peugeot 307 SW – replacement guide

Free download PDF
1.71 MB
How to change track rod end on Peugeot 207 hatchback – replacement guide

Free download PDF
1.5 MB
How to change track rod end on Peugeot 407 saloon – replacement guide

Free download PDF
1.64 MB
How to change track rod end on Peugeot 406 saloon – replacement guide

Free download PDF
2.26 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How to prevent car windows from fogging up | AUTODOC tips

13K views

Published on: 04/02/2021
3 essential tips for choosing summer tyres | Get ready for warmer weather

4K views

Published on: 18/05/2023
The Ultimate Guide to Engine Bay Cleaning | AUTODOC

6K views

Published on: 11/09/2020
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs

10K views

Published on: 08/04/2021