Important!

This replacement procedure can be used for:
FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi, FORD TRANSIT Bus 2.2 TDCi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Anti Roll Bar Bushes for TRANSIT Bus and other FORD models

Alternative products

Bearing Bush, stabiliser

271043 A.B.S. Bearing Bush, stabiliser

3,06 GBP

Shop

Replacement: anti roll bar bushes – FORD TRANSIT Bus. Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Ceramic grease
                    
                      Torque wrench
                    
                      20 mm combination spanner
                    
                      10 mm socket
                    
                      17 mm socket
                    
                      19 mm socket
                    
                      H5 Allen key
                    
                      21 mm wheel impact socket
                    
                      Ratchet wrench or power tool for removal/installation of threaded fasteners
                    
                      Tommy bar
                    
                      Car lift or jack with jack stands, and wheel chocks

Buy tools

Replacement: anti roll bar bushes – FORD TRANSIT Bus. AUTODOC experts recommend:

Replace the anti-roll bar links and bushes in pairs.
The replacement procedure is identical for the anti-roll bar links and bushes on both sides of the same axle.
Please note: all work on the car – FORD TRANSIT Bus – should be done with the engine switched off.

Carry out the replacement steps as follows:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel nuts on the front wheels. Use a 21 mm wheel impact socket. Use a tommy bar.
Step 3

Raise the vehicle.

Replacement: anti roll bar bushes – FORD TRANSIT Bus. AUTODOC recommends:
If you are using a jack, make sure the car is parked on a hard, flat surface.Make sure to additionally secure the car with jack stands.
Step 4

Unscrew the nuts on one of the wheels and remove it.

Caution!
To avoid injury, hold up the wheel when unscrewing the nuts.
Step 5

Remove the other wheel in the same way.
Step 6

Clean the fasteners of one of the anti-roll bar links. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the fastener connecting the anti-roll bar link to the anti-roll bar. Use a 19 mm combination spanner. Use an H5 Allen key to secure the ball stud. Use a ratchet wrench.
Step 8

Unscrew the fastener connecting the anti-roll bar link to the suspension strut. Use a 19 mm socket. Use a ratchet wrench.
Step 9

Remove the anti-roll bar link.
Step 10

Follow the same steps to remove the other anti-roll bar link.
Step 11

Clean the bracket fasteners of one of the anti-roll bar bushes. Use a wire brush. Use WD-40 spray.
Step 12

Unscrew the fasteners of the anti-roll bar bush bracket. Use a 10 mm socket. Use a ratchet wrench.
Step 13

Remove the fastening bolts.
Step 14

Remove the anti-roll bar bush bracket.
Step 15

Remove the anti-roll bar bush.
Step 16

Follow the same steps to remove the other anti-roll bar bush bracket and the bush.
Step 17

Clean the mounting seats of the anti-roll bar bushes. Use a wire brush. Use an all-purpose cleaning spray.
Step 18

Install a new anti-roll bar bush on one side of the axle.
Step 19

Install the anti-roll bar bush bracket.
Step 20

Install and screw in the fastening bolts.
Step 21

Follow the same steps to install a new anti-roll bar bush and the bracket on the other side.
Step 22

Tighten the fasteners on both anti-roll bar bush brackets. Use a 10 mm socket. Use a torque wrench. Tightening torque: 25 N·m.
Step 23

Clean the mounting seats of the anti-roll bar link on one side of the axle. Use a wire brush. Use an all-purpose cleaning spray.
Step 24

Install a new anti-roll bar link and its fasteners.
Step 25

Tighten the fastener connecting the anti-roll bar link to the anti-roll bar. Use a 20 mm combination spanner. Use a 17 mm socket. Use a torque wrench. Tightening torque: 55 N·m.
Step 26

Tighten the fastener connecting the anti-roll bar link to the suspension strut. Use a 20 mm combination spanner. Use a 17 mm socket. Use a torque wrench. Tightening torque: 55 N·m.
Step 27

Follow the same steps to install a new anti-roll bar link on the other side.
Step 28

Clean the mounting seat of one of the wheels. Use a wire brush. Use an all-purpose cleaning spray.
Step 29

Treat the wheel hub surface that contacts the wheel rim. Use ceramic grease.
Step 30

Install the wheel.

Replacement: anti roll bar bushes – FORD TRANSIT Bus. Professionals recommend:
To avoid injury, hold up the wheel when screwing on the fastening nuts.
Step 31

Screw on the wheel nuts. Use a 21 mm wheel impact socket. Use a ratchet wrench.
Step 32

Reinstall the other wheel in the same way.

Step 33

Lower the car and tighten the wheel nuts in a criss-cross order. Use a 21 mm wheel impact socket. Use a torque wrench. Tightening torque: 200 N·m.
Step 34

Remove the jack, jack stands, and wheel chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Transit Mk6 Minibus (V347, V348) model.

Ford Transit mk7 Minibus tyre size

How to change tie rod ends on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
1.57 MB
How to change a front wheel bearing on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
3.17 MB
How to change a front suspension arm on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
1.74 MB
How to change the front anti-roll bar links on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
1.45 MB
How to change a front suspension strut mount on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
4.45 MB
How to change the serpentine belt on the FORD Transit Mk6 Minibus (V347, V348) – replacement guide

Free download PDF
788.48 KB

How to change the front anti-roll bar bushes on the Ford Transit Mk7 van – replacement guide

Free download PDF
2.15 MB
How to change the front anti-roll bar bushes on the FORD Transit Mk5 Van (V184, V185) – replacement guide

Free download PDF
2.08 MB
How to change the front anti-roll bar bushes on the FORD Transit Mk6 Platform / Chassis (V347, V348) – replacement guide

Free download PDF
2.08 MB
How to change the front anti-roll bar bushes on the FORD Transit Mk5 Platform / Chassis (V184, V185) – replacement guide

Free download PDF
2.08 MB
How to change the front anti-roll bar bushes on the FORD Transit Mk5 Minibus (V184, V185) – replacement guide

Free download PDF
2.09 MB
How to change the front anti-roll bar bushes on the FORD Transit Tourneo (FC_ _) – replacement guide

Free download PDF
2.07 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

DIY car soundproofing | AUTODOC tips

82K views

Published on: 15/04/2021
Checking the starter without removing it | AUTODOC tips

21K views

Published on: 01/12/2020
How to clean an engine bay | AUTODOC

6K views

Published on: 11/09/2020
How to reduce fuel consumption | AUTODOC

4K views

Published on: 27/09/2022