When to replace the Brake Pads on your PEUGEOT 406
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
PEUGEOT 406 Break (8E/F) 1.9 D, PEUGEOT 406 Break (8E/F) 1.8 16V, PEUGEOT 406 Break (8E/F) 1.9 TD, PEUGEOT 406 Break (8E/F) 2.1 TD 12V, PEUGEOT 406 Break (8E/F) 2.0 Turbo, PEUGEOT 406 Break (8E/F) 2.0 16V, PEUGEOT 406 Break (8E/F) 3.0 24V, PEUGEOT 406 Break (8E/F) 1.8, PEUGEOT 406 Break (8E/F) 2.0 HDI 110, PEUGEOT 406 Break (8E/F) 2.0 HDI 90, PEUGEOT 406 Break (8E/F) 2.0 16V, PEUGEOT 406 Break (8E/F) 3.0 V6, PEUGEOT 406 Break (8E/F) 2.2, PEUGEOT 406 Break (8E/F) 1.8 16V, PEUGEOT 406 Break (8E/F) 2.0 16V, PEUGEOT 406 Break (8E/F) 2.2 HDI, PEUGEOT 406 Break (8E/F) 2.0 16V HPi, PEUGEOT 406 Break (8E/F) 1.8, PEUGEOT 406 Break (8E/F) 1.8 BiFuel View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 406 Break (8E/F) and other PEUGEOT models
Tools
Replacement: brake pads – PEUGEOT 406 Break (8E/F). List of the tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Anti-squeal paste
Wheel impact socket #19
Torque wrench
Round-nose pliers
Hammer
Pin punch
Crow bar
Wheel chock
Replacement: brake pads – PEUGEOT 406 Break (8E/F). AUTODOC recommends:
  • Replace the brake disks on the car PEUGEOT 406 Break (8E/F) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • Please note: all work on the car – PEUGEOT 406 Break (8E/F) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    How to change Brake Pads on Peugeot 406 Estate 1996 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 3
    How to replace PEUGEOT 406 Break (8E/F) 2.0 HDI 110 1997 Brake Pads - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  3. Step 4
    Raise the rear of the car and secure on supports.
    Step 5
    Peugeot 406 Estate 2.0 16V 1998 Brake Pads replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. PEUGEOT 406 Break (8E/F)
  4. Step 6
    Changing Brake Pads on PEUGEOT 406 Break (8E/F) 2.0 HDI 90 1999 by yourself
    Remove the wheel.
  5. Step 7
    How to remove PEUGEOT 406 2.2 2000 Brake Pads - online easy-to-follow instructions
    Remove the retaining springs of the brake pads. Use round-nose pliers.
  6. Step 8
    How to replace Brake Pads on PEUGEOT 406 Break (8E/F) 2001: download PDF manuals and video instructions
    Remove the brake pads retaining clips. Use a pin punch. Use a hammer.
  7. Step 9
    Spread the brake pads. Use a crowbar.
    Step 10
    How hard is it to do yourself: Brake Pads replacement on Peugeot 406 Estate 2.0 HDi 110 2002 - download illustrated guide
    Remove the brake pads. Use a crowbar. Use a pin punch.
    Replacement: brake pads – PEUGEOT 406 Break (8E/F). Professionals recommend:
    Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
  8. Step 11
    Need to know how to renew Brake Pads on PEUGEOT 406 2003? This free workshop manual will help you to do it yourself
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    Replacement: brake pads – PEUGEOT 406 Break (8E/F). Tip from AUTODOC:
    Make sure the disc surface is clean before installing the pads.
  9. Step 12
    Changing of Brake Pads on Peugeot 406 Estate 2004 won't be an issue if you follow this illustrated step-by-step guide
    Install new brake pads.
    Replacement: brake pads – PEUGEOT 406 Break (8E/F). AUTODOC recommends:
    Make sure the pads are installed with linings facing the disc.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 406 Estate model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
PEUGEOT 406 Break (8E/F) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY PEUGEOT 406 Break (8E/F) Brake Pads replacement - online guide
Tips & tricks for your PEUGEOT 406 Break (8E/F)
View more
  • How to change Brake pad set on PEUGEOT 406 Break (8E/F) 1.8 16V - replacement tricks
    How to fix your car with AUTODOC CLUB
  • Changing Disc pads Peugeot 406 Estate 2.0 HDI 110 - Replacement Tips
    5 Tips for New Drivers | AUTODOC tips
  • Maintenance Hacks - PEUGEOT 406 Break (8E/F) 2.0 16V Brake pad kit replacement guide
    5 common car washing mistakes | AUTODOC tips
  • Replace Disc brake pads on Peugeot 406 Estate - free video tips
    How to clean an engine bay | AUTODOC