Recommended replacement interval for the part category Brake disc : 50000 km

Important!

This replacement procedure can be used for:
FIAT Bravo II Van (198) 1.6 JTD Multijet (198AXH1B) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Discs for Bravo II Van (198) and other FIAT models

Alternative products

Brake disc

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Drive socket # 12 
                    
                      Drive socket # 13 
                    
                      Drive socket # 17 
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Tap wrench
                    
                      Rubber mallet
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Tip:

Replace the brake disks on the car FIAT Bravo II Kastenwagen (198) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
The replacement procedure is identical for both brake disks on the same axle.
When changing the brake discs, always replace the brake pads.
All work should be done with the engine stopped.

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
Step 9

Remove the brake caliper. Use a crowbar.

AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 10

Remove the brake pads.
Step 11

Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
Step 12

Unscrew the caliper bracket fastening. Use a drive socket #17. Use a tap wrench.
Step 13

Remove the caliper bracket.
Step 14

Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
Step 15

Unscrew the brake disc fastening. Use a drive socket #12. Use a ratchet wrench.
Step 16

Remove the brake disc. Use a rubber mallet.
Step 17

Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
Step 18

Install the brake disc.
Step 19

Tighten the brake disc fastening. Use a drive socket #12. Use a torque wrench. Tighten it to 10 Nm torque.
Step 20

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake discs – FIAT Bravo II Kastenwagen (198). After applying the spray, wait a few minutes.
Step 21

Install the brake caliper bracket.
Step 22

Tighten the brake caliper bracket. Use a drive socket #17. Use a torque wrench. Tighten it to 62 Nm torque.
Step 23

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 24

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 25

Install the brake pads.
Step 26

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 27

Clean the brake disk surface. Use a wire brush.

Step 28

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 29

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake discs – FIAT Bravo II Kastenwagen (198). After applying the spray, wait a few minutes.
Step 30

Install the wheel.

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 31

Screw in the wheel bolts. Use wheel impact socket #17.
Step 32

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.

AUTODOC recommends:
Important! Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Check the brake fluid level in the reservoir and top up if necessary.
Step 33

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake discs – FIAT Bravo II Kastenwagen (198). Professionals recommend:
Without starting the engine, press the brake pedal several times until you feel significant resistance.
Step 34

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the FIAT Bravo II Van (198) model

FIAT Bravo II Kastenwagen (198) tyre size

How to change front brake pads on FIAT Bravo II Van (198) – replacement guide

Free download PDF
1.61 MB
How to change front brake discs on FIAT Bravo II Van (198) – replacement guide

Free download PDF
2.29 MB
How to change front anti roll bar links on FIAT Bravo II Van (198) – replacement guide

Free download PDF
1.7 MB
How to change engine oil and filter on FIAT Bravo II Van (198) – replacement guide

Free download PDF
2.01 MB
How to change front lower arm on FIAT Bravo II Van (198) – replacement guide

Free download PDF
2.48 MB
How to change air filter on FIAT Bravo II Van (198) – replacement guide

Free download PDF
870.4 KB

How to change front brake discs on Fiat Bravo 2 – replacement guide

Free download PDF
2.48 MB
How to change rear brake discs on Fiat Bravo 2 – replacement guide

Free download PDF
2.29 MB
How to change front brake discs on FIAT BRAVO I (182) – replacement guide

Free download PDF
2.06 MB
How to change rear brake discs on FIAT BRAVO I (182) – replacement guide

Free download PDF
1.92 MB
How to change front brake discs on FIAT Bravo II Van (198) – replacement guide

Free download PDF
2.29 MB
How to change brake discs on a car – replacement tutorial

Universal

Free download PDF
2.92 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Preventing Engine Failure: Head Gasket Inspection Tutorial | AUTODOC

11K views

Published on: 13/10/2020
Transform Your Engine Bay: Affordable Valve Cover Restoration with AUTODOC

7K views

Published on: 29/06/2023
K2 ROTON wheel cleaner overview

3K views

Published on: 27/03/2025
DIY car soundproofing | AUTODOC tips

104K views

Published on: 15/04/2021