Important!

This replacement procedure can be used for:
VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI, VW SHARAN (7M8, 7M9, 7M6) 2.0, VW SHARAN (7M8, 7M9, 7M6) 2.8 VR6, VW SHARAN (7M8, 7M9, 7M6) 2.8 VR6 Syncro, VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI, VW SHARAN (7M8, 7M9, 7M6) 1.8 T 20V, VW SHARAN (7M8, 7M9, 7M6) 2.0 TDI, VW SHARAN (7M8, 7M9, 7M6) 2.8 V6 24V, VW SHARAN (7M8, 7M9, 7M6) 2.8 V6 24V 4motion, VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI 4motion, VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI, VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI, VW SHARAN (7M8, 7M9, 7M6) 2.0 TDI, VW SHARAN (7M8, 7M9, 7M6) 2.0 LPG, VW SHARAN (7M8, 7M9, 7M6) 1.9 TDI … View more

The steps may slightly vary depending on the car design.

How to change front suspension arm on VW SHARAN 1 [TUTORIAL AUTODOC]

Alternative products

Suspension arm

Replacement: front lower arm – VW Sharan 1. Tools you might need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Ceramic grease
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Drive socket # 21
                    
                      Wheel impact socket #19
                    
                      Ball joint puller
                    
                      Ratchet wrench
                    
                      Crow bar
                    
                      Hydraulic transmission jack
                    
                      Wheel chock

Buy tools

Replacement: front lower arm – VW Sharan 1. Professionals recommend:

The replacement procedure is identical for the left and right lower control arms.
Please note: all work on the car – VW Sharan 1 – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.

Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 3

Raise the car.

Replacement: front lower arm – VW Sharan 1. AUTODOC recommends:
If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW Sharan 1
Step 5

Remove the wheel.
Step 6

Clean the fastener that connects the suspension arm to the ball joint. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the fastener that connects the suspension arm to the ball joint. Use a drive socket #21. Use a ratchet wrench.
Step 8

Detach the suspension arm from the ball joint. Use a ball joint puller.
Step 9

Clean the fasteners that connect the suspension arm to the subframe. Use a wire brush. Use WD-40 spray.
Step 10

Support the subframe. Use a hydraulic transmission jack.
Step 11

Unscrew the rear fastener of the control arm. Use a drive socket #21. Use a ratchet wrench.
Step 12

Remove the fastening bolt.
Step 13

Unscrew the front fastener of the control arm. Use a drive socket #21. Use a ratchet wrench.
Step 14

Remove the fastening bolt.
Step 15

Remove the arm.
Step 16

Clean the suspension arm mounting seats. Use a wire brush. Use WD-40 spray.
Step 17

Install a new arm. Use a crowbar.

Replacement: front lower arm – VW Sharan 1. AUTODOC experts recommend:
During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
Step 18

Install the fastening bolts.
Step 19

Connect the control arm to the ball joint.
Step 20

Screw in the fastener connecting the suspension arm to the ball joint. Use a drive socket #21. Use a ratchet wrench.
Step 21

Screw in the rear fastener of the control arm. Use a drive socket #21. Use a ratchet wrench.
Step 22

Remove the support from under the subframe.

AUTODOC recommends:
Replacement: front lower arm – VW Sharan 1. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 23

Prop up the steering knuckle. Use a hydraulic transmission jack.

AUTODOC recommends:
For tightening the fasteners correctly, you have to jack up the suspension components to their working position.
Step 24

Tighten the front fastener of the arm. Use a drive socket #21. Use a torque wrench. Tighten it to 90 Nm torque.+90°
Step 25

Tighten the rear fastener of the control arm. Use a drive socket #21. Use a torque wrench. Tighten it to 150 Nm torque.+90°
Step 26

Remove the support from under the steering knuckle.

AUTODOC recommends:
Replacement: front lower arm – VW Sharan 1. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 27

Tighten the fastener that connects the suspension arm to the ball joint. Use a drive socket #21. Use a torque wrench. Tighten it to 30 Nm torque.+90°
Step 28

Treat all joints of the arm. Use copper grease.
Step 29

Clean the wheel rim mounting seat. Use a wire brush.
Step 30

Treat the surface where the brake disc contacts the wheel rim. Use ceramic grease.
Step 31

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 32

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VW Sharan 1
Step 33

Screw in the wheel bolts. Use wheel impact socket #19.
Step 34

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 170 Nm torque.
Step 35

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VW Sharan I (7M8, 7M9, 7M6) model

VW Sharan 1 tyre size

How to change front strut mount on VW Sharan 1 – replacement guide

Free download PDF
2.7 MB
How to change front wheel bearing on VW Sharan 1 – replacement guide

Free download PDF
3.99 MB
How to change rear anti roll bar bushes on VW Sharan 1 – replacement guide

Free download PDF
849.92 KB
How to change track rod end on VW Sharan 1 – replacement guide

Free download PDF
1.44 MB
How to change front anti roll bar links on VW Sharan 1 – replacement guide

Free download PDF
1.32 MB
How to change rear wheel bearing on VW Sharan 1 – replacement guide

Free download PDF
3.27 MB

How to change rear suspension lower trailing arm on VW Sharan II (7N1, 7N2) – replacement guide

Free download PDF
2.59 MB
How to change front lower arm on VW SHARAN (7N1, 7N2) – replacement guide

Free download PDF
2.13 MB
How to change control arm on a car – replacement tutorial

Universal

Free download PDF
1.07 MB
How to change front lower arm on VW Golf 5 – replacement guide

Free download PDF
2.89 MB
How to change front lower arm on VW Polo 9N – replacement guide

Free download PDF
2.45 MB
How to change rear suspension lower control arm on VW Golf 6 – replacement guide

Free download PDF
2.47 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Coolant comparison test | AUTODOC

14K views

Published on: 18/02/2021
Engine Overheating? Replace Your Cooling Fan to Fix It

7K views

Published on: 15/11/2020
5 possible reasons why your car heater isn't working

7K views

Published on: 21/11/2024
#DIY guide: Changing your car's color with a spray can | AUTODOC tips

6K views

Published on: 25/03/2021