Important!

This replacement procedure can be used for:
FORD Fiesta Mk6 Saloon 1.6 Ti, FORD Fiesta Mk6 Saloon 1.6 Ti, FORD Fiesta Mk6 Saloon 1.6 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for Fiesta Mk6 Saloon and other FORD models

Suspension arm

        Suspension arm for Fiesta Mk6 Saloon Petrol (120 hp)
      
        Suspension arm for Fiesta Mk6 Saloon Petrol (105 hp)
      
        Suspension arm for Fiesta Mk6 Saloon Petrol (85 hp)

Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. Tools you need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner
                      
                        Copper grease
                      
                        Combination spanner #13
                      
                        Drive socket # 15
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Tap wrench
                      
                        Flat chisel
                      
                        Hammer
                      
                        Rubber mallet
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. AUTODOC experts recommend:

The replacement procedure is identical for the left and right lower control arms.
Warning! Shut down the engine before starting any work – FORD FIESTA Saloon JA8 JR8.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. FORD FIESTA Saloon JA8 JR8
Step 5

Remove the wheel.
Step 6

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.

Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. Tip:
After applying the spray, wait a few minutes.
Step 7

Unscrew the ball joint fastening to the steering knuckle. Use a combination spanner #13. Use a drive socket #15. Use a tap wrench.
Step 8

Remove the fastening bolt.
Step 9

Unscrew the front arm fastener. Use a drive socket #15. Use a tap wrench.
Step 10

Unscrew the rear fastener connecting the control arm to the subframe. Use a drive socket #13. Use a tap wrench.
Step 11

Remove the rear fastener of the control arm.
Step 12

Release the fastener connecting the ball joint to the steering knuckle. Use a flat metal-working chisel. Use a hammer.
Step 13

Disconnect the ball joint from the steering knuckle.
Step 14

Remove the front fastener of the control arm.
Step 15

Remove the arm.
Step 16

Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
Step 17

Install a new arm. Use a rubber mallet.

Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. AUTODOC recommends:
During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
Step 18

Install the control arm fasteners.
Step 19

Connect the ball joint to the steering knuckle.

Step 20

Support the arm. Use a hydraulic transmission jack.
Step 21

Install the fastening bolt.
Step 22

Screw the fasteners of the ball joint. Use a combination spanner #13. Use a drive socket #15. Use a ratchet wrench.
Step 23

Screw the front arm fastener. Use a drive socket #15. Use a ratchet wrench.
Step 24

Screw the rear fastener connecting the control arm to the subframe. Use a drive socket #15. Use a ratchet wrench.
Step 25

Tighten the rear fastener connecting the arm to the body subframe. Use a drive socket #15. Use a torque wrench. Tighten it to 65 Nm torque.+180°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 26

Tighten the front fastener connecting the control arm to the subframe. Use a drive socket #15. Use a torque wrench. Tighten it to 65 Nm torque.+180°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 27

Tighten the ball joint fastener. Use a drive socket #15. Use a torque wrench. Tighten it to 50 nm torque.
Step 28

Remove the support from under the arm.

AUTODOC recommends:
Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 29

Treat all joints of the arm. Use copper grease.
Step 30

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 31

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 32

Install the wheel.

Replacement: front lower arm – FORD FIESTA Saloon JA8 JR8. Tip from AUTODOC:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 33

Screw in the wheel bolts. Use wheel impact socket #19.
Step 34

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 110 nm torque.
Step 35

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Fiesta Mk6 Saloon model.

Browse tyres

How to change front anti roll bar links on FORD Fiesta Mk6 Saloon – replacement guide

Free download PDF
1.26 MB
How to change front brake pads on FORD Fiesta Mk6 Saloon – replacement guide

Free download PDF
1.44 MB
How to change front brake discs on FORD Fiesta Mk6 Saloon – replacement guide

Free download PDF
1.71 MB
How to change air filter on FORD Fiesta Mk6 Saloon – replacement guide

Free download PDF
972.8 KB
How to change pollen filter on FORD Fiesta Mk6 Saloon – replacement guide

Free download PDF
1.11 MB
How to change water pump & timing belt kit on Ford Fiesta JA8 – replacement guide

Free download PDF
7.83 MB

How to change front lower arm on Ford Fiesta JA8 – replacement guide

Free download PDF
2.11 MB
How to change front lower arm on Ford Fiesta V JH JD – replacement guide

Free download PDF
2.87 MB
How to change front lower arm on FORD Fiesta Mk6 Van – replacement guide

Free download PDF
2.07 MB
How to change control arm on a car – replacement tutorial

Universal

Free download PDF
1.07 MB
How to change front lower arm on Ford Focus MK2 – replacement guide

Free download PDF
2.51 MB
How to change front lower arm on Ford Mondeo BWY – replacement guide

Free download PDF
2.06 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Car checks you need to carry out on your car after the winter | AUTODOC tips

3K views

Published on: 23/03/2023
How to Make a DIY Foam Sprayer | AUTODOC tips

206K views

Published on: 23/06/2022
5 mistakes made when washing the engine | AUTODOC tips

29K views

Published on: 22/04/2021
How to find and change a fuse | AUTODOC

2K views

Published on: 15/08/2020