When to replace the Brake Pads on your TOYOTA AYGO
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
TOYOTA AYGO (WNB1_, KGB1_) 1.0 GPL (KGB10_), TOYOTA AYGO (WNB1_, KGB1_) 1.4 D-4D (WNB10_) View more

The steps may slightly vary depending on the car design.

How to change front brake pads / front brake pad set on TOYOTA AYGO 1 (AB10) [TUTORIAL AUTODOC]

video
All the parts you need to replace – Brake Pads for AYGO (WNB1_, KGB1_) and other TOYOTA models
Tools
Replacement: brake pads – Toyota Aygo AB1. List of the tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Anti-squeal paste
Drive socket # 13
Wheel impact socket #19
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Crow bar
Wheel chock
Replacement: brake pads – Toyota Aygo AB1. Tip from AUTODOC experts:
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • All work should be done with the engine stopped.
Replacement: brake pads – Toyota Aygo AB1. Use the following procedure:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    How to change Brake Pads on Toyota Aygo AB10 2005 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 3
    How to replace TOYOTA AYGO (WNB1_, KGB1_) 1.0 (KGB10_) 2006 Brake Pads - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  3. Step 4
    Toyota Aygo AB10 1.4 D-4D (WNB10_) 2007 Brake Pads replacement: free workshop manuals
    Raise the front of the car and secure on supports.
  4. Step 5
    Changing Brake Pads on TOYOTA AYGO (WNB1_, KGB1_) 1.0 (KGB10_) 2008 by yourself
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Important! Hold the wheel while unscrewing the fastening bolts. Toyota Aygo AB1
  5. Step 6
    How to remove TOYOTA AYGO 1.4 D-4D (WNB10_) 2009 Brake Pads - online easy-to-follow instructions
    Remove the wheel.
  6. Step 7
    How to replace Brake Pads on TOYOTA AYGO (WNB1_, KGB1_) 2010: download PDF manuals and video instructions
    Spread the brake pads. Use a crowbar.
  7. Step 8
    How hard is it to do yourself: Brake Pads replacement on Toyota Aygo AB10 1.0 (KGB10_) 2011 - download illustrated guide
    Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
  8. Step 9
    Need to know how to renew Brake Pads on TOYOTA AYGO 2012? This free workshop manual will help you to do it yourself
    Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
  9. Step 10
    Changing of Brake Pads on Toyota Aygo AB10 2013 won't be an issue if you follow this illustrated step-by-step guide
    Remove the brake caliper.
    AUTODOC recommends:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  10. Step 11
    TOYOTA AYGO 1.0 GPL (KGB10_) Brake Pads replacement: online guides and video tutorials
    Remove the brake pads.
    Replacement: brake pads – Toyota Aygo AB1. Tip:
    Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
  11. Step 12
    Replacing Brake Pads on Toyota Aygo AB10 2005 1.0 (KGB10_) by yourself
    Remove the brake pads retaining clips. Use a crowbar.
  12. Step 13
    AYGO (WNB1_, KGB1_) 1.4 D-4D (WNB10_) 2006 Brake Pads DIY replacement workshop manual
    Clean the brake caliper bracket from dirt and dust. Use a wire brush.
  13. Step 14
    How to change Brake Pads on TOYOTA AYGO (WNB1_, KGB1_) 2007 - tips and tricks
    Install the brake pads retaining clips.
  14. Step 15
    Step-by-step recommendations for DIY replacement Toyota Aygo AB10 2008 1.4 D-4D (WNB10_) Brake Pads
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    Replacement: brake pads – Toyota Aygo AB1. Professionals recommend:
    Make sure the disc surface is clean before installing the pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
TOYOTA AYGO (WNB1_, KGB1_) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY TOYOTA AYGO (WNB1_, KGB1_) Brake Pads replacement - online guide
Tips & tricks for your TOYOTA AYGO (WNB1_, KGB1_)
View more
  • How to change Brake pad set on TOYOTA AYGO (WNB1_, KGB1_) 1.0 GPL (KGB10_) - replacement tricks
    How to Make a DIY Foam Sprayer | AUTODOC tips
  • Changing Disc pads Toyota Aygo AB10 1.0 (KGB10_) - Replacement Tips
    How to check your head gasket | AUTODOC
  • Maintenance Hacks - TOYOTA AYGO (WNB1_, KGB1_) 1.4 D-4D (WNB10_) Brake pad kit replacement guide
    Important differences between car tools | AUTODOC tips
  • Replace Disc brake pads on Toyota Aygo AB10 - free video tips
    DIY jack restoration | AUTODOC tips