Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
AUDI Allroad (4BH, C5) 2.5 TDI quattro, AUDI Allroad (4BH, C5) 2.7 T quattro, AUDI Allroad (4BH, C5) 4.2 V8 quattro, AUDI Allroad (4BH, C5) 2.5 TDI quattro, AUDI Allroad (4BH, C5) 2.7 quattro … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Allroad (4BH, C5) and other AUDI models

Brake pad set

        Brake pad set for Allroad C5 (4BH) Diesel (180 hp)
      
        Brake pad set for Allroad C5 (4BH) Petrol (250 hp)
      
        Brake pad set for Allroad C5 (4BH) Petrol (299 hp)
      
        Brake pad set for Allroad C5 (4BH) Diesel (163 hp)
      
        Brake pad set for Allroad C5 (4BH) Petrol (254 hp)

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Tools you need:

                        Wire brush
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        HEX bit no.H7.
                      
                        Wheel impact socket #17
                      
                        Brake caliper wind back tool
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – AUDI ALLROAD (4BH, C5). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Disconnect the brake pads wear sensor. Use a crowbar.

Please note!
Some cars are not equipped with the brake pad wear sensor.
Step 8

Spread the brake pads. Use a crowbar.
Step 9

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 10

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 11

Detach the brake caliper retaining spring. Use a crowbar.
Step 12

Remove the brake caliper.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 13

Remove the brake pads.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Professionals recommend:
After applying the spray, wait a few minutes.
Step 15

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – AUDI ALLROAD (4BH, C5). After applying the spray, wait a few minutes.
Step 16

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 17

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 18

Install new brake pads.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Tip from AUTODOC:
Make sure the pads are installed with linings facing the disc.
Step 19

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
Step 20

Install the dust boot caps of the brake caliper guide pins.
Step 21

Connect the brake pads wear sensor.
Step 22

Install the brake caliper retaining spring. Use a crowbar.
Step 23

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 24

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 25

Install the wheel.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 26

Screw in the wheel bolts. Use wheel impact socket #17.
Step 27

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.
Step 28

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – AUDI ALLROAD (4BH, C5). Check the brake fluid level in the reservoir and top up if necessary.
Step 29

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
AUDI ALLROAD (4BH, C5) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 30

Close the hood.

Replacement: brake pads – AUDI ALLROAD (4BH, C5). Professionals recommend:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the AUDI Allroad C5 (4BH) model.

Browse tyres

How to change rear brake pads on AUDI Allroad (4BH, C5) – replacement guide

Free download PDF
1.53 MB
How to change front wheel bearing on AUDI Allroad (4BH, C5) – replacement guide

Free download PDF
3.94 MB
How to change front windshield wipers on AUDI Allroad C5 (4BH) – replacement guide

Free download PDF
1.41 MB
How to change rear windshield wipers on AUDI Allroad (4BH, C5) – replacement guide

Free download PDF
501.76 KB
How to change front anti roll bar links on AUDI Allroad (4BH, C5) – replacement guide

Free download PDF
1.53 MB
How to change rear anti roll bar links on AUDI Allroad C5 (4BH) – replacement guide

Free download PDF
1.53 MB

How to change rear brake pads on AUDI Allroad (4BH, C5) – replacement guide

Free download PDF
1.53 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change rear brake pads on Audi A4 B8 – replacement guide

Free download PDF
1.81 MB
How to change rear brake pads on Audi A3 8PA – replacement guide

Free download PDF
1.55 MB
How to change front brake pads on Audi A4 B8 – replacement guide

Free download PDF
1.79 MB
How to change front brake pads on Audi A6 4F2 – replacement guide

Free download PDF
1.75 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 common car washing mistakes | AUTODOC tips

5K views

Published on: 23/09/2021
What to do if your check engine light is on | AUTODOC tips

16K views

Published on: 19/08/2020
How to paint a car with a spray can | AUTODOC tips

5K views

Published on: 25/03/2021
How to replace the suspension on a BMW E30 Turbo | SUPERCAR AUTODOC

1K views

Published on: 04/03/2021