Important!

This replacement procedure can be used for:
SUZUKI SWIFT III (MZ, EZ) 1.5 (RS 415)

The steps may slightly vary depending on the car design.

How to change front anti roll bar link on SUZUKI SWIFT 3 Hatchback [TUTORIAL AUTODOC]

Replacement: anti roll bar links – Suzuki Swift MK3. Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Combination spanner #14
                      
                        HEX bit no.H6.
                      
                        Wheel impact socket #21
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Wheel chock

All the parts you need to replace – Anti Roll Bar Links for SWIFT III (MZ, EZ) and other SUZUKI models

SUZUKI SWIFT III (MZ, EZ) 1.5 (RS 415)

AUTODOC recommends:

Replace the stabiliser links on Suzuki Swift MK3 in pairs.
The replacement procedure is identical for both stabiliser links on the same axle.
Please note: all work on the car – Suzuki Swift MK3 – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts.Use wheel impact socket #21.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:

Important! Hold the wheel while unscrewing the fastening bolts. Suzuki Swift MK3
Step 5

Remove the wheel.
Step 6

Clean the stabiliser link fasteners.Use a wire brush.Use WD-40 spray.
Step 7

Unscrew the fastener connecting the stabilizer link to the shock strut.Use a combination spanner #14.Use HEX No.H6.Use a ratchet wrench.
Step 8

Unscrew the fastener connecting the stabilizer link to the stabilizer bar.Use a combination spanner #14.Use HEX No.H6.Use a ratchet wrench.
Step 9

Remove the stabilizer rod.
Step 10

Clean the mounting seats of the stabiliser link.Use a wire brush.Use WD-40 spray.
Step 11

Install a new rod, tighten the fasteners.
Step 12

Tighten the fastener connecting the stabilizer link to the stabilizer bar.Use a combination spanner #14.Use HEX No.H6.Use a torque wrench.Tighten it to 55 Nm torque.
Step 13

Tighten the fastener connecting the stabilizer link to the shock strut.Use a combination spanner #14.Use HEX No.H6.Use a torque wrench.Tighten it to 55 Nm torque.
Step 14

Treat all joints of the stabiliser link.Use copper grease.
Step 15

Treat the surface where the brake disc contacts the wheel rim.Use copper grease.
Step 16

Clean the brake disk surface.Use a brake cleaner.

AUTODOC recommends:

Replacement: anti roll bar links – Suzuki Swift MK3. After applying the spray, wait a few minutes.
Step 17

Install the wheel.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. Suzuki Swift MK3
Step 18

Screw in the wheel bolts.Use wheel impact socket #21.
Step 19

Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #21.Use a torque wrench.Tighten it to 125 nm torque.
Step 20

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change rear wheel bearing on Suzuki Swift MK3 – replacement guide

Free download PDF

6.06 MB
How to change track rod end on Suzuki Swift MK3 – replacement guide

Free download PDF

5.64 MB
How to change spark plugs on Suzuki Swift MK3 – replacement guide

Free download PDF

7.56 MB
How to change front brake pads on Suzuki Swift MK3 – replacement guide

Free download PDF

6.3 MB
How to change engine oil and filter on Suzuki Swift MK3 – replacement guide

Free download PDF

5.67 MB
How to change front suspension strut on Suzuki Swift MK3 – replacement guide

Free download PDF

11.38 MB
How to change pollen filter on Suzuki Swift MK3 – replacement guide

Free download PDF

3.23 MB
How to change rear shock absorbers on Suzuki Swift MK3 – replacement guide

Free download PDF

8.58 MB
How to change front brake discs on Suzuki Swift MK3 – replacement guide

Free download PDF

8.61 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your SUZUKI SWIFT III (MZ, EZ)

How to remove a broken bolt without welding | AUTODOC tips

260K views

Published on: 11/03/2020
Noise from under the hood | AUTODOC TIPS

198K views

Published on: 25/08/2019
How to fix a knocking and creaking suspension | AUTODOC

181K views

Published on: 08/09/2019
6 SIGNS OF A BAD FUEL FILTER | AUTODOC

163K views

Published on: 24/07/2019