Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
FORD Kuga Mk1 (C394) TDCi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for Kuga Mk1 (C394) and other FORD models

Oil filter

Oil filter for Kuga Mk1 (C394) Diesel (140 hp)

Replacement: engine oil and filter – FORD Kuga Mk1 (C394). Tools you'll need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Torque wrench
                      
                        13 mm socket
                      
                        30 mm socket
                      
                        Ratchet wrench
                      
                        Flat screwdriver
                      
                        Funnel
                      
                        Oil drain pan
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – FORD Kuga Mk1 (C394). AUTODOC experts recommend:

Replace the oil filter every time you change the engine oil.
Before getting down to work, warm up the engine to reduce the viscosity of the oil.
Wear gloves to prevent contact with hot liquid.
Warning! Shut down the engine before starting any work – FORD Kuga Mk1 (C394).

Carry out the replacement steps as follows:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to avoid damaging the paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler cap.
Step 4

Pull up the oil dipstick.
Step 5

Raise the car using a car lift or place it over an inspection pit.

Warning!
The vehicle must be level, but if it is at an angle, the drain plug must be at the lowest point.
Step 6

Put an oil drain pan with a capacity of at least 7 litres under the drain hole.

Step 7

Clean the area of the oil pan drain hole. Use a wire brush. Use an all-purpose cleaning spray.
Step 8

Unscrew the drain plug. Use a 13 mm socket. Use a ratchet wrench.
Step 9

Drain the used oil.

Caution!
The oil may be hot.Wait until the oil has completely flowed out of the drain hole.
Step 10

Clean the oil filter cap. Use an all-purpose cleaning spray.
Step 11

Unscrew the filter cap together with the old filter element. Use a 30 mm socket. Use a ratchet wrench.

Caution!
The oil may be hot.
Step 12

Remove the filter element from the filter cap. Remove the old O-ring of the oil filter cap. Use a flat screwdriver.
Step 13

Remove the O-ring from the drain plug. Use a flat screwdriver.
Step 14

Clean the oil filter cap. Use an all-purpose cleaning spray.
Step 15

Clean the drain plug. Use an all-purpose cleaning spray.
Step 16

Install a new O-ring on the drain plug.
Step 17

Install a new O-ring on the oil filter cap.
Step 18

Lubricate the new O-ring with a small amount of fresh oil.
Step 19

Install a new filter element into the oil filter cap.
Step 20

Clean the oil filter mounting seat. Use an all-purpose cleaning spray.
Step 21

Install the oil filter cap and screw it in. Use a 30 mm socket. Use a torque wrench. Tightening torque: 20 N·m.
Step 22

Clean the area of the oil pan drain hole. Use an all-purpose cleaning spray.
Step 23

Screw in the drain plug and tighten it. Use a 13 mm socket. Use a torque wrench. Tightening torque: 23 N·m.
Step 24

Lower the car back to the ground.

Step 25

Remove the oil filler cap.
Step 26

Insert the funnel.
Step 27

Pour oil into the engine through the filler. Required amount of oil: 6.14 L.

Important!
Use the oil recommended by the manufacturer.
Step 28

Check the oil level using the dipstick.

Replacement: engine oil and filter – FORD Kuga Mk1 (C394). AUTODOC recommends:
The oil level should be between the Min and Max marks.Top up oil if necessary.
Step 29

Remove the funnel and screw in the oil filler cap.
Step 30

Run the engine for a few minutes.

Replacement: engine oil and filter – FORD Kuga Mk1 (C394). Tip from AUTODOC experts:
The oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the passages, and the light will go out.
Step 31

Check the oil level with a dipstick in 5 minutes after turning the engine off and add oil if necessary.

Warning!
The oil level should be between the Min and Max marks.
Step 32

Make sure that the oil filler cap is properly tightened. Check the threaded plug of the drain hole and the oil filter seal for tightness. If necessary, tighten them up carefully.

Step 33

Remove the fender cover.

Step 34

Close the bonnet.

AUTODOC recommendation:
To protect the environment from pollution, be sure to dispose of the used filters and oil at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Kuga Mk1 (C394) model.

Browse tyres

How to change front brake pads on FORD Kuga Mk1 (C394) – replacement guide

Free download PDF
1.46 MB
How to change front brake caliper on FORD Kuga Mk1 (C394) – replacement guide

Free download PDF
2.11 MB
How to change front strut mount on FORD Kuga Mk1 (C394) – replacement guide

Free download PDF
2.78 MB
How to change water pump & timing belt kit on Ford Fiesta JA8 – replacement guide

Free download PDF
7.83 MB
How to change serpentine belt on Ford Fiesta V JH JD – replacement guide

Free download PDF
2.14 MB
How to change engine oil and filter on Ford Focus MK2 diesel – replacement guide

Free download PDF
2.92 MB

How to change engine oil and filter on FORD Kuga Mk2 (DM2) – replacement guide

Free download PDF
2.39 MB
How to change the oil filter and engine oil on the FORD Kuga Mk1 Off-Road – replacement guide

Free download PDF
1.66 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on Ford Focus MK2 diesel – replacement guide

Free download PDF
2.92 MB
How to change engine oil and filter on Ford Focus MK2 petrol – replacement guide

Free download PDF
2.64 MB
How to change engine oil and filter on Ford Fiesta V JH JD – replacement guide

Free download PDF
2.72 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Coolant comparison test | AUTODOC

4K views

Published on: 13/10/2022
5 Tips for New Drivers | AUTODOC tips

3K views

Published on: 31/01/2023
How to repair a chipped or cracked windscreen | AUTODOC tips

7K views

Published on: 14/12/2023
What to do if the airbag light is on | AUTODOC tips

5K views

Published on: 10/04/2023