Important!

This replacement procedure can be used for:
HYUNDAI SANTA FÉ II (CM) 2.2 CRDi

The steps may slightly vary depending on the car design.

How to change Rear Springs on HYUNDAI SANTA FÉ CM TUTORIAL | AUTODOC

Replacement: coil springs – Hyundai Santa Fe CM. Tools you need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Torque wrench
                      
                        Combination spanner #19
                      
                        Drive socket # 19
                      
                        Wheel impact socket #21
                      
                        Ratchet wrench
                      
                        Hydraulic transmission jack
                      
                        Crow bar
                      
                        Wheel chock

All the parts you need to replace – Springs for SANTA FÉ II (CM) and other HYUNDAI models

HYUNDAI SANTA FÉ II (CM) 2.2 CRDi

Replacement: coil springs – Hyundai Santa Fe CM. AUTODOC recommends:

Both coil springs of the rear suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right coil springs of the rear suspension.
Please note: all work on the car – Hyundai Santa Fe CM – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts.Use wheel impact socket #21.
Step 3

Raise the rear of the car and secure on supports.
Step 4

Unscrew the wheel bolts.

AUTODOC recommends:

Important! Hold the wheel while unscrewing the fastening bolts. Hyundai Santa Fe CM
Step 5

Remove the wheel.
Step 6

Support the arm. Use a hydraulic transmission jack.
Step 7

Clean the control arm fasteners.Use a wire brush.Use WD-40 spray.

Step 8

Unscrew the front arm fastener. Use a combination spanner #19.Use a drive socket #19.Use a ratchet wrench.
Step 9

Remove the front fastener of the control arm.

Step 10

Detach the control arm.

Step 11

Remove the support from under the arm.

AUTODOC recommends:

Replacement: coil springs – Hyundai Santa Fe CM. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 12

Pull down the suspension control arm.Use a crowbar.
Step 13

Take out the spring.
Step 14

Remove the rubber spring spacer.

Replacement: coil springs – Hyundai Santa Fe CM. Professionals recommend:

Inspect the rubber mounts of the suspension spring. Replace if necessary.

Step 15

Install the rubber spacer on the new coil spring.
Step 16

Pull down the suspension control arm.Use a crowbar.

Step 17

Install the coil spring together with the rubber mounts into the mounting seats.
Step 18

Support the arm. Use a hydraulic transmission jack.
Step 19

Attach the control arm.
Step 20

Install the front fastener of the arm.

Step 21

Tighten the lower arm fastener.Use a combination spanner #19.Use a drive socket #19.Use a torque wrench.Tighten it to 88 Nm torque.
Step 22

Remove the support from under the arm.

AUTODOC recommends:

Replacement: coil springs – Hyundai Santa Fe CM. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 23

Clean the wheel rim mounting seat.Use a wire brush.

Step 24

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.

AUTODOC recommends:

Replacement: coil springs – Hyundai Santa Fe CM. After applying the spray, wait a few minutes.
Step 25

Clean the brake disk surface.Use a brake cleaner.

Replacement: coil springs – Hyundai Santa Fe CM. Tip from AUTODOC experts:

After applying the spray, wait a few minutes.
Step 26

Install the wheel.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. Hyundai Santa Fe CM
Step 27

Screw in the wheel bolts.Use wheel impact socket #21.
Step 28

Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #21.Use a torque wrench.Tighten it to 120 Nm torque.
Step 29

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front suspension strut on Hyundai Santa Fe CM – replacement guide

Free download PDF

11.85 MB
How to change front wheel bearing on Hyundai Santa Fe CM – replacement guide

Free download PDF

9.18 MB
How to change rear brake discs on Hyundai Santa Fe CM – replacement guide

Free download PDF

8.01 MB
How to change fuel filter on Hyundai Santa Fe CM – replacement guide

Free download PDF

5.42 MB
How to change rear wheel bearing on Hyundai Santa Fe CM – replacement guide

Free download PDF

6.53 MB
How to change front lower arm on Hyundai Santa Fe CM – replacement guide

Free download PDF

6.78 MB
How to change rear shock absorbers on Hyundai Santa Fe CM – replacement guide

Free download PDF

5.72 MB
How to change rear brake pads on Hyundai Santa Fe CM – replacement guide

Free download PDF

6.67 MB
How to change front brake pads on Hyundai Santa Fe CM – replacement guide

Free download PDF

6.64 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your HYUNDAI SANTA FÉ II (CM)

How to remove a broken bolt without welding | AUTODOC tips

260K views

Published on: 11/03/2020
Noise from under the hood | AUTODOC TIPS

198K views

Published on: 25/08/2019
How to fix a knocking and creaking suspension | AUTODOC

181K views

Published on: 08/09/2019
6 SIGNS OF A BAD FUEL FILTER | AUTODOC

163K views

Published on: 24/07/2019