Disclaimer
How to change lambda sensor on AUDI TT Coupe (8N3) – replacement guide
downloads:
33
Views:
504
Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T … View more
The steps may slightly vary depending on the car design.
AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for TT Coupe (8N3) and other AUDI models
Alternative products

Wire brush
WD-40 spray
Electronic spray
High-temperature ceramic grease
Torque wrench
Drive socket # 10
22-mm oxygen sensor socket
Thread tap
Ratchet wrench
Replacement: lambda sensor – AUDI TT (8N3). AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- Before getting down to work, start the engine and let it warm up to operating temperature.
- Please note: all work on the car – AUDI TT (8N3) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Lift the car using a jack or place it over an inspection pit.Step 2
Unscrew the fasteners of the oxygen sensor housing cover. Use a drive socket #10. Use a ratchet wrench. - Step 3
Remove the oxygen sensor housing cover. - Step 4
Detach the oxygen sensor connector. - Step 5
Disconnect the oxygen sensor wiring. - Step 6
Clean the oxygen sensor fastener. Use a wire brush. Use WD-40 spray. - Step 7
Unscrew the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a ratchet wrench. - Step 8
Remove the oxygen sensor. - Step 9
Clean the thread to prepare it for installing a new oxygen sensor. Use a thread tap. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI TT Coupe (8N3) model
Popular maintenance tutorials for Audi TT 8N
Complete guides for changing the Oxygen sensor on different AUDI TT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI TT Coupe (8N3)
View more
How to prevent car windows from fogging up | AUTODOC tips
7 signs of faulty fuel injectors | AUTODOC tips
Top 5 reasons why your car squeals | AUTODOC Tips
How to Get the Best Deals on Car Parts | Save Money with AUTODOC
Most commonly replaced car parts on AUDI TT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

























