Important!

This replacement procedure can be used for:
PEUGEOT PARTNER Box 1.6 BlueHDi 4x4, PEUGEOT PARTNER Box 1.6 HDi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for PARTNER Box and other PEUGEOT models

Alternative products

Suspension arm

Replacement: front lower arm – PEUGEOT PARTNER Box. Tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #13
                    
                      Combination spanner #17
                    
                      Drive socket # 13 
                    
                      Drive socket # 16 
                    
                      Drive socket # 17 
                    
                      Drive socket # 18 
                    
                      Wheel impact socket #19
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Tap wrench
                    
                      Hydraulic transmission jack
                    
                      Wheel chock

Buy tools

Replacement: front lower arm – PEUGEOT PARTNER Box. Professionals recommend:

The replacement procedure is identical for the left and right lower control arms.
All work should be done with the engine stopped.

Replacement: front lower arm – PEUGEOT PARTNER Box. Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. PEUGEOT PARTNER Box
Step 5

Remove the wheel.
Step 6

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.

Replacement: front lower arm – PEUGEOT PARTNER Box. AUTODOC recommends:
After applying the spray, wait a few minutes.Wear protective goggles.
Step 7

Unscrew the ball joint fastening to the steering knuckle. Use a drive socket #17. Use a combination spanner #17.
Step 8

Remove the fastening bolt.
Step 9

Disconnect the lower arm from the steering knuckle. Use a crowbar.
Step 10

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 11

Unscrew the front arm fastener. Use a drive socket #18. Use a tap wrench.
Step 12

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 13

Unscrew the rear fastener connecting the control arm to the subframe. Use a drive socket #13. Use a drive socket #16. Use a tap wrench.
Step 14

Remove the rear fastener of the control arm.
Step 15

Remove the front fastener of the control arm.
Step 16

Remove the arm. Use a crowbar.
Step 17

Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
Step 18

Install a new arm. Use a crowbar.

Replacement: front lower arm – PEUGEOT PARTNER Box. Tip from AUTODOC:
During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
Step 19

Install the rear fastener of the arm.
Step 20

Install the front fastener of the arm.
Step 21

Screw the rear arm fastener. Use a combination spanner #13. Use a drive socket #16. Use a ratchet wrench.
Step 22

Tighten the rear fastener of the control arm. Use a drive socket #16. Use a torque wrench. Tighten it to 40 Nm torque.
Step 23

Connect the lower arm to the steering knuckle.
Step 24

Install the fastening bolt.
Step 25

Screw the fasteners of the ball joint. Use a drive socket #17. Use a ratchet wrench.

Step 26

Tighten the ball joint fastener. Use a combination spanner #17. Use a drive socket #17. Use a torque wrench. Tighten it to 44 Nm torque.
Step 27

Support the arm. Use a hydraulic transmission jack.
Step 28

Tighten the front fastener connecting the control arm to the subframe. Use a drive socket #18. Use a torque wrench. Tighten it to 74 nm torque.
Step 29

Remove the support from under the arm.

AUTODOC recommends:
Replacement: front lower arm – PEUGEOT PARTNER Box. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 30

Treat all joints of the arm. Use copper grease.
Step 31

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 32

Clean the brake disk surface. Use a brake cleaner.

Replacement: front lower arm – PEUGEOT PARTNER Box. AUTODOC experts recommend:
After applying the spray, wait a few minutes.
Step 33

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. PEUGEOT PARTNER Box
Step 34

Screw in the wheel bolts. Use wheel impact socket #19.
Step 35

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 100 Nm torque.
Step 36

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT Partner II Van model

Peugeot Partner K9 tyre size

How to change front wheel bearing on PEUGEOT PARTNER Box – replacement guide

Free download PDF
4.73 MB
How to change rear wheel bearing on PEUGEOT PARTNER Box – replacement guide

Free download PDF
2.03 MB
How to change front anti roll bar links on PEUGEOT Partner II Van – replacement guide

Free download PDF
1.33 MB
How to change front ball joint on PEUGEOT Partner II Van – replacement guide

Free download PDF
2.45 MB
How to change rear brake pads on PEUGEOT Partner II Van – replacement guide

Free download PDF
2.47 MB
How to change front brake pads on PEUGEOT PARTNER Box – replacement guide

Free download PDF
1.42 MB

How to change front lower arm on PEUGEOT PARTNER Box (5) – replacement guide

Free download PDF
1.94 MB
How to change front lower arm on PEUGEOT Partner Origin Combispace (G_) – replacement guide

Free download PDF
1.94 MB
How to change control arm on a car – replacement tutorial

Universal

Free download PDF
1.07 MB
How to change front lower arm on Peugeot 208 1 – replacement guide

Free download PDF
2.84 MB
How to change front lower arm on Peugeot 206 CC 2D – replacement guide

Free download PDF
2.64 MB
How to change front lower arm on Peugeot 107 PM PN – replacement guide

Free download PDF
2.19 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips

6K views

Published on: 20/10/2020
Prevent Breakdowns: Key Car Checks After Winter | AUTODOC Guide

3K views

Published on: 23/03/2023
Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips

6K views

Published on: 14/03/2024
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit

8K views

Published on: 14/12/2023