Important!
This replacement procedure can be used for:
PEUGEOT 206 CC (2D) 2.0 S16, PEUGEOT 206 CC (2D) 1.6 HDi 110 View more

The steps may slightly vary depending on the car design.

How to change front suspension arm / front control arm on PEUGEOT 206 1 (2D) [TUTORIAL AUTODOC]

video
All the parts you need to replace – Control Arm for 206 CC (2D) and other PEUGEOT models
How to change Suspension arm on Peugeot 206 cc 2d 1.6 16V (2DNFUF, 2DNFUR) – step-by-step instructions for straightforward car repair
Suspension arm
How to change Link Set, wheel suspension on Peugeot 206 cc 2d 1.6 16V (2DNFUF, 2DNFUR) – step-by-step instructions for straightforward car repair
Link Set, wheel suspension
Tools
Replacement: front lower arm – Peugeot 206 CC 2D. List of the tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #17
Combination spanner #21
Drive socket # 17
Drive socket # 21
Drive socket # 32
Wheel impact socket #19
Torque wrench
Tap wrench
Hammer
Pin punch
Flat chisel
Crow bar
Hydraulic transmission jack
Fender cover
Wheel chock
Replacement: front lower arm – Peugeot 206 CC 2D. AUTODOC recommends:
  • The replacement procedure is identical for the left and right lower control arms.
  • Warning! Shut down the engine before starting any work – Peugeot 206 CC 2D.
Carry out replacement in the following order:
  1. Step 1
    Open the bonnet.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Control Arm on Peugeot 206 cc 2d 2000 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 4
    How to replace PEUGEOT 206 CC (2D) 1.6 16V (2DNFUF, 2DNFUR) 2001 Control Arm - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  3. Step 5
    Peugeot 206 cc 2d 2.0 S16 2002 Control Arm replacement: free workshop manuals
    Raise the front of the car and secure on supports.
  4. Step 6
    Changing Control Arm on PEUGEOT 206 CC (2D) 1.6 2003 by yourself
    Unscrew the wheel bolts.
    Replacement: front lower arm – Peugeot 206 CC 2D. Tip:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  5. Step 7
    How to remove PEUGEOT 206 1.6 16V (2DNFUF, 2DNFUR) 2004 Control Arm - online easy-to-follow instructions
    Remove the wheel.
  6. Step 8
    How to replace Control Arm on PEUGEOT 206 CC (2D) 2005: download PDF manuals and video instructions
    Clean the fastener of the driveshaft. Use a wire brush.
  7. Step 9
    How hard is it to do yourself: Control Arm replacement on Peugeot 206 cc 2d 1.6 HDi 110 2006 - download illustrated guide
    Remove the cotter pin. Use a crowbar.
  8. Step 10
    Need to know how to renew Control Arm on PEUGEOT 206 2007? This free workshop manual will help you to do it yourself
    Loosen the fastener of the driveshaft. Use a drive socket #32. Use a tap wrench. Use a crowbar.
  9. Step 11
    Changing of Control Arm on Peugeot 206 cc 2d 2008 won't be an issue if you follow this illustrated step-by-step guide
    Detach the driveshaft from the steering knuckle. Use a pin punch. Use a hammer.
  10. Step 12
    PEUGEOT 206 1.6 16V (2DNFUF, 2DNFUR) Control Arm replacement: online guides and video tutorials
    Clean the fastener connecting the ball joint to the steering knuckle. Use a wire brush. Use WD-40 spray.
  11. Step 13
    Replacing Control Arm on Peugeot 206 cc 2d 2001 1.6 16V (2DNFUF, 2DNFUR) by yourself
    Unscrew the ball joint fastening to the steering knuckle. Use a combination spanner #17. Use a drive socket #17.
  12. Step 14
    206 CC (2D) 1.6 16V (2DNFUF, 2DNFUR) 2002 Control Arm DIY replacement workshop manual
    Remove the fastening bolt.
  13. Step 15
    How to change Control Arm on PEUGEOT 206 CC (2D) 2003 - tips and tricks
    Release the fastener that connects the control arm ball joint to the steering knuckle. Use a flat metal-working chisel. Use a hammer.
  14. Step 16
    Step-by-step recommendations for DIY replacement Peugeot 206 cc 2d 2004 1.6 16V (2DNFUF, 2DNFUR) Control Arm
    Prop up the steering knuckle. Use a hydraulic transmission jack.
  15. Step 17
    DIY replacement of Control Arm on PEUGEOT 206 CC (2D) 1.6 HDi 110 2005 is not an issue anymore with our step-by-step tutorial
    Disconnect the lower arm from the steering knuckle. Use a crowbar.
  16. Step 18
    How to change Control Arm on Peugeot 206 cc 2d 2000 - free PDF and video manuals
    Remove the support from under the steering knuckle.
    AUTODOC recommends:
    Replacement: front lower arm – Peugeot 206 CC 2D. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
  17. Step 19
    How to replace PEUGEOT 206 CC (2D) 1.6 16V (2DNFUF, 2DNFUR) 2001 Control Arm - step-by-step manuals and video guides
    Pull the drive shaft out of the steering knuckle and lifting it, tie to the body.
    Replacement: front lower arm – Peugeot 206 CC 2D. AUTODOC recommends:
    Make sure that the drive shaft is not unloaded (when the car is jacked).
  18. Step 20
    Peugeot 206 cc 2d 2.0 S16 2002 Control Arm replacement: free workshop manuals
    Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
    Replacement: front lower arm – Peugeot 206 CC 2D. Tip from AUTODOC:
    After applying the spray, wait a few minutes.
  19. Step 21
    Changing Control Arm on PEUGEOT 206 CC (2D) 1.6 2003 by yourself
    Unscrew the front arm fastener. Use a drive socket #21. Use a tap wrench.
  20. Step 22
    How to remove PEUGEOT 206 1.6 16V (2DNFUF, 2DNFUR) 2004 Control Arm - online easy-to-follow instructions
    Unscrew the rear arm fastener. Use a drive socket #21. Use a tap wrench.
  21. Step 23
    How to replace Control Arm on PEUGEOT 206 CC (2D) 2005: download PDF manuals and video instructions
    Remove the fastening bolts.
  22. Step 24
    How hard is it to do yourself: Control Arm replacement on Peugeot 206 cc 2d 1.6 HDi 110 2006 - download illustrated guide
    Remove the arm.
  23. Step 25
    Need to know how to renew Control Arm on PEUGEOT 206 2007? This free workshop manual will help you to do it yourself
    Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
  24. Step 26
    Changing of Control Arm on Peugeot 206 cc 2d 2008 won't be an issue if you follow this illustrated step-by-step guide
    Install a new arm.
    Replacement: front lower arm – Peugeot 206 CC 2D. AUTODOC experts recommend:
    During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
  25. Step 27
    PEUGEOT 206 1.6 16V (2DNFUF, 2DNFUR) Control Arm replacement: online guides and video tutorials
    Install the control arm fasteners.
  26. Step 28
    Replacing Control Arm on Peugeot 206 cc 2d 2001 1.6 16V (2DNFUF, 2DNFUR) by yourself
    Screw the front arm fastener. Use a combination spanner #21. Use a drive socket #21.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
PEUGEOT 206 CC (2D) Control Arm replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY PEUGEOT 206 CC (2D) Control Arm replacement - online guide
Tips & tricks for your PEUGEOT 206 CC (2D)
View more
  • How to change Control arm on PEUGEOT 206 CC (2D) 1.6 HDi 110 - replacement tricks
    How to remove rust | AUTODOC tips
  • Changing Wishbone Peugeot 206 cc 2d 1.6 16V (2DNFUF, 2DNFUR) - Replacement Tips
    What causes engine misfire? | AUTODOC
  • Maintenance Hacks - PEUGEOT 206 CC (2D) 2.0 S16 Control arms replacement guide
    How do EGR valves work? | AUTODOC
  • Replace Trailing arm on Peugeot 206 cc 2d - free video tips
    The most common problems when buying a used car | AUTODOC