Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
PEUGEOT 206 CC (2D) 1.6 HDi, PEUGEOT 206 CC (2D) 1.6 16V (2DNFUF, 2DNFUR), PEUGEOT 206 CC (2D) 2.0 S16 … View more

The steps may slightly vary depending on the car design.

How to change front brake pads / front brake pad set on PEUGEOT 206 1 (2D) [TUTORIAL AUTODOC]

Alternative products

Brake pad set

Replacement: brake pads – Peugeot 206 CC 2D. Tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Drive socket # 13 
                    
                      Wheel impact socket #19
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – Peugeot 206 CC 2D. AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – Peugeot 206 CC 2D. Recommended sequence of steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the front of the car and secure on supports.
Step 5

Unscrew the wheel bolts.

Replacement: brake pads – Peugeot 206 CC 2D. Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Spread the brake pads. Use a crowbar.
Step 8

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 9

Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
Step 10

Remove the brake caliper.

Replacement: brake pads – Peugeot 206 CC 2D. AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads.

Replacement: brake pads – Peugeot 206 CC 2D. Professionals recommend:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – Peugeot 206 CC 2D. After applying the spray, wait a few minutes.
Step 13

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake pads – Peugeot 206 CC 2D. Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 14

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – Peugeot 206 CC 2D. AUTODOC experts recommend:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 18

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – Peugeot 206 CC 2D. After applying the spray, wait a few minutes.
Step 19

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 20

Install the wheel.

Replacement: brake pads – Peugeot 206 CC 2D. AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 21

Screw in the wheel bolts. Use wheel impact socket #19.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 100 Nm torque.
Step 23

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – Peugeot 206 CC 2D. Check the brake fluid level in the reservoir and top up if necessary.
Step 24

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
Peugeot 206 CC 2D – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 25

Close the hood.

Replacement: brake pads – Peugeot 206 CC 2D. AUTODOC experts recommend:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 206 CC (2D) model

Peugeot 206 cc 2d tyre size

How to change rear brake pads on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.64 MB
How to change rear brake discs on Peugeot 206 CC 2D – replacement guide

Free download PDF
2.16 MB
How to change front brake discs on Peugeot 206 CC 2D – replacement guide

Free download PDF
2.05 MB
How to change rear wheel bearing on Peugeot 206 CC 2D – replacement guide

Free download PDF
2.27 MB
How to change front wheel bearing on PEUGEOT 206 CC (2D) – replacement guide

Free download PDF
3.65 MB
How to change serpentine belt on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.29 MB

How to change front brake pads on PEUGEOT 206 Hatchback (2A/C) – replacement guide

Free download PDF
1.26 MB
How to change rear brake pads on PEUGEOT 206 Hatchback (2A/C) – replacement guide

Free download PDF
1.46 MB
How to change rear brake pads on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.64 MB
How to change front brake pads on PEUGEOT 206 SW (2E/K) – replacement guide

Free download PDF
1.73 MB
How to change rear brake pads on PEUGEOT 206 SW (2E/K) – replacement guide

Free download PDF
1.46 MB
How to change front brake pads on PEUGEOT 206 Saloon – replacement guide

Free download PDF
1.25 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY manual gearbox restoration | Drivetrain restoration – Part 3

18K views

Published on: 14/11/2024
BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project

2K views

Published on: 04/03/2021
Deep interior cleaning | Car transformation by detailing

7K views

Published on: 05/09/2024
Top 7 signs of a bad starter

5K views

Published on: 20/03/2025