Disclaimer
How to change front brake discs on Renault Scenic 2 – replacement guide
downloads:
4
Views:
83
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
RENAULT SCÉNIC II (JM0/1_) 1.9 D, RENAULT SCÉNIC II (JM0/1_) 2.0 (JM05, JM0U, JM1N, JM1U, JM2V), RENAULT SCÉNIC II (JM0/1_) 2.0 16V Turbo (JM0W), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi (JM14), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi (JM15), RENAULT SCÉNIC II (JM0/1_) 1.5 dCi (JM16), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi, RENAULT SCÉNIC II (JM0/1_) 2.0 (JM0S, JM2N), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi, RENAULT SCÉNIC II (JM0/1_) 1.6 (JM0C, JM0J, JM1B) … View more
The steps may slightly vary depending on the car design.
RENAULT SCÉNIC II (JM0/1_) 1.9 D, RENAULT SCÉNIC II (JM0/1_) 2.0 (JM05, JM0U, JM1N, JM1U, JM2V), RENAULT SCÉNIC II (JM0/1_) 2.0 16V Turbo (JM0W), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi (JM14), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi (JM15), RENAULT SCÉNIC II (JM0/1_) 1.5 dCi (JM16), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi, RENAULT SCÉNIC II (JM0/1_) 2.0 (JM0S, JM2N), RENAULT SCÉNIC II (JM0/1_) 1.9 dCi, RENAULT SCÉNIC II (JM0/1_) 1.6 (JM0C, JM0J, JM1B) … View more
The steps may slightly vary depending on the car design.
How to change front brake discs / front brake rotors on RENAULT SCENIC 2 (JM) [TUTORIAL AUTODOC]

All the parts you need to replace – Brake Discs for SCÉNIC II (JM0/1_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Drive socket # 13
Drive socket # 18
Torx bit T30
Wheel impact socket #19
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Tap wrench
Impact screwdriver
Rubber mallet
Crow bar
Wheel chock
Replacement: brake discs – Renault Scenic 2. AUTODOC experts recommend:
- Replace the brake disks on the car Renault Scenic 2 in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- All work should be done with the engine stopped.
Replacement: brake discs – Renault Scenic 2. Use the following procedure:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 4
Raise the front of the car and secure on supports. - Step 5
Unscrew the wheel bolts.Replacement: brake discs – Renault Scenic 2. Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench. - Step 9
Spread the brake pads. Use a crowbar. - Step 10
Remove the brake caliper.Replacement: brake discs – Renault Scenic 2. AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 11
Remove the brake pads. Use a crowbar. - Step 12
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 13
Unscrew the caliper bracket fastening. Use a drive socket #18. Use a tap wrench. - Step 14
Remove the caliper bracket. - Step 15
Clean the brake disk surface. Use a wire brush. Use WD-40 spray. - Step 16
Unscrew the brake disc fastening. Use Torx T30. Use an impact screwdriver.Replacement: brake discs – Renault Scenic 2. Tip from AUTODOC:If necessary, use a rubber mallet. - Step 17
Remove the brake disc. Use a rubber mallet. - Step 18
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 19
Install the brake disc. - Step 20
Tighten the brake disc fastening. Use Torx T30. Use a torque wrench. Tighten it to 15 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Scénic II (JM) model
Popular maintenance tutorials for Renault Scenic 2
Complete guides for changing the Brake rotors on different RENAULT SCÉNIC models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT SCÉNIC II (JM0/1_)
View more
Prevent Breakdowns: Key Car Checks After Winter | AUTODOC Guide
TOP 6 WD-40 lifehacks | AUTODOC tips
What to do if the ABS light comes on: DIY Diagnostics Tips
Understanding Car Tools: The Key Differences You Need to Know | AUTODOC tips
Most commonly replaced car parts on RENAULT SCÉNIC
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































