Disclaimer
How to change front brake discs on Renault Clio 2 – replacement guide
downloads:
31
Views:
650
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2 (BB0A, BB0F, BB10, BB1K, BB28, BB2D, BB2H, CB0A,..., RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.9 D (B/CB0E, BB0J), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB07), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB08), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2, RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB03), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2 LPG (BB0A, CB0A), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/C2J), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB3M), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi … View more
The steps may slightly vary depending on the car design.
RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2 (BB0A, BB0F, BB10, BB1K, BB28, BB2D, BB2H, CB0A,..., RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.9 D (B/CB0E, BB0J), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB07), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB08), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2, RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB03), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.2 LPG (BB0A, CB0A), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/C2J), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi (B/CB3M), RENAULT CLIO II (BB0/1/2_, CB0/1/2_) 1.5 dCi … View more
The steps may slightly vary depending on the car design.
How to change front brake discs / front brake rotors on RENAULT CLIO 2 (C65) [TUTORIAL AUTODOC]

All the parts you need to replace – Brake Discs for CLIO II (BB0/1/2_, CB0/1/2_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #13
Combination spanner #17
Drive socket # 18
Torx bit T40
Wheel impact socket #19
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Tap wrench
Impact screwdriver
Rubber mallet
Crow bar
Wheel chock
Replacement: brake discs – Renault Clio 2. Tip:
- Replace the brake disks on the car Renault Clio 2 in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – Renault Clio 2 – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 4
Raise the front of the car and secure on supports. - Step 5
Unscrew the wheel bolts.Replacement: brake discs – Renault Clio 2. AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #17. - Step 9
Spread the brake pads. Use a crowbar. - Step 10
Remove the brake caliper.Replacement: brake discs – Renault Clio 2. AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. - Step 11
Remove the brake pads. - Step 12
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 13
Unscrew the caliper bracket fastening. Use a drive socket #18. Use a ratchet wrench. Use a tap wrench. - Step 14
Remove the caliper bracket. - Step 15
Clean the brake disk surface. Use a wire brush. Use WD-40 spray. - Step 16
Unscrew the brake disc fastening. Use Torx T40. Use an impact screwdriver.Replacement: brake discs – Renault Clio 2. Tip from AUTODOC:If necessary, use a rubber mallet. - Step 17
Remove the brake disc. - Step 18
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 19
Install the brake disc. - Step 20
Tighten the brake disc fastening. Use Torx T40. Use a torque wrench. Tighten it to 15 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Clio II Hatchback (BB, CB) model
Popular maintenance tutorials for Renault Clio 2
Complete guides for changing the Brake rotors on different RENAULT CLIO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT CLIO II (BB0/1/2_, CB0/1/2_)
View more
5 Essential Tips to Prepare Your Car for Winter | AUTODOC tips
Why Is the Windscreen Washer Not Spraying? Solution
How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
How to easily repair a punctured tyre | AUTODOC tips
Most commonly replaced car parts on RENAULT CLIO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


































