Error code P1495 is displayed and the check engine light is on - what does this mean?
The DTC P1495 is a manufacturer-specific fault code that is recognized by the OBD system if there is a problem in the fuel pump control or fuel system. This trouble code mainly occurs in BMW vehicles and indicates a fault in the fuel pump relay control.
What causes can this error code have?
- Defective fuel pump relay
- Damaged wiring to the fuel pump
- Faulty fuel pump
- Loose or corroded plug connections
- Defective engine control unit (ECU)
- Short circuit in the fuel pump circuit
- Interrupted ground connection
- Defective fuel pressure sensor
What symptoms occur in parallel with fault code P1495?
- Starting problems: The vehicle is difficult or impossible to start
- Engine stuttering: Irregular engine running, especially at low engine speeds
- Loss of power: Reduced engine power while driving
- Check engine light: Permanent or intermittent warning display
- Fuel smell: Fuel smell in the vehicle interior or engine compartment
- Irregular idling: Engine runs irregularly at idle speed
How can the problem with error code P1495 be rectified?
- Repairing this EOBD fault code requires a systematic diagnosis of the fuel system.
- Check the fuel pump relay and replace if necessary - often the most common and cost-effective solution
- Check wiring to fuel pump system for damage, corrosion or loose connections and repair
- Test fuel pump for proper function and replace defective pump completely
- Clean, tighten or replace plug connections on the fuel pump circuit
- Check fuel pressure sensor and replace if malfunctioning
- Diagnose the engine control unit and have it repaired or replaced if defective
- Check and restore the ground connections of the fuel system
FAQ - Frequently asked questions about DTC P1495
Can I continue driving with error code P1495?
Continuing to drive with code P1495 is not recommended, as fuel problems can lead to engine damage or sudden stalling. A prompt repair is urgently required.
How much does it cost to repair fault code P1495?
The repair costs for fault code P1495 vary depending on the cause: relay replacement 20-50 euros, fuel pump 300-800 euros, wiring repair 100-300 euros, ECU repair 500-1500 euros.
How can I diagnose fault code P1495 myself?
To self-diagnose DTC P1495, you can replace the fuel pump relay, check fuses and listen for unusual noises from the fuel pump. More complex diagnoses require professional OBD scanners.
Is fault code P1495 a serious problem?
Code P1495 should be taken seriously as it relates to the fuel supply. Without a functioning fuel pump, the engine may not work properly or may fail completely.
What tools do I need to repair P1495?
To fix error code P1495, you will need an OBD scanner, multimeter, basic tools, possibly special tools for the fuel pump and safety equipment due to the risk of fire.
How often does fault code P1495 occur?
DTC P1495 is a relatively rare, manufacturer-specific trouble code that mainly occurs in BMW vehicles with higher mileage or older models.