Error code P0607 is displayed and the check engine light is on - what does this mean?
The DTC P0607 is recognized by the OBD system if there is an internal error in the control unit (ECM/PCM). This trouble code indicates a malfunction in the engine control unit itself, which can be interpreted differently by different manufacturers.
What causes can this error code have?
- Defective engine control unit (ECM/PCM)
- Corrupt software in the control unit
- Damaged internal circuits
- Overvoltage or undervoltage in the power supply
- Defective main circuit board in the control unit
- Faulty calibration data
- Water damage to the control unit
- Failure of electronic components due to ageing
Which symptoms occur in parallel with error code P0607?
- Engine performance: Significant loss of power or uneven engine running
- Starting behavior: Difficulty starting or complete failure to start
- Driving: Engine stalls while driving or runs in emergency running program
- Electronics: Other fault codes are stored at the same time
- Fuel consumption: Increased consumption due to faulty engine control unit
- Exhaust values: Deteriorated emission values and possible emissions test problems
How can the problem with fault code P0607 be rectified?
- There are several possible solutions for this EOBD fault code, which should be worked through systematically.
- Perform a control unit reset: Disconnect the battery for 30 minutes and then delete the fault memory to rectify temporary software faults
- Install a software update: Have the latest firmware for the engine control unit installed by the authorized dealer
- Check the power supply: Measure the vehicle electrical system voltage and replace defective fuses or cables to the control unit power supply
- Replace control unit: In the event of irreparable internal damage, have the ECM/PCM completely replaced by a specialist workshop
- Renew calibration: Have the control unit reprogrammed with vehicle-specific data and calibrated
- Check ground connections: Clean and tighten all earth connections to the control unit
FAQ - Frequently asked questions about DTC P0607
Can I continue driving with error code P0607?
Continuing to drive with code P0607 is not recommended, as the engine control unit is defective. This can lead to sudden engine failure or consequential damage.
How much does it cost to repair error code P0607?
The repair costs for DTC P0607 vary greatly: software update 100-200€, control unit replacement 800-2500€ depending on the vehicle model and manufacturer.
Is error code P0607 a common problem?
Trouble code P0607 occurs less frequently than other OBD codes, but is more common in older vehicles or after water damage.
Can I repair trouble code P0607 myself?
Self-repairs are only possible to a limited extent with this EOBD code. Only simple measures such as battery replacement should be carried out by yourself, control unit work should be carried out by a specialist workshop.
How long does it take to repair code P0607?
The repair time depends on the cause: software update 1-2 hours, control unit replacement with programming 4-8 hours.
Does error code P0607 reappear after the repair?
DTC P0607 does not normally reappear if the repair has been carried out correctly. Repeated occurrence indicates incomplete repair or further defects.