Disclaimer
How to change track rod end on RENAULT Scénic I (JA0/1, FA0) – replacement guide
downloads:
8
Views:
61
Important!
This replacement procedure can be used for:
RENAULT Scénic I (JA0/1_, FA0_) 1.4 16V (JA0D, JA1H, Ja0W, JA10), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V (JA1D, JA17), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V RX4, RENAULT Scénic I (JA0/1_, FA0_) 1.9 dCi RX4, RENAULT Scénic I (JA0/1_, FA0_) 1.9 dTi (JA0N), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V (JA1B, JA1D, JA0C), RENAULT Scénic I (JA0/1_, FA0_) 1.9 dCi (JA05, JA1F), RENAULT Scénic I (JA0/1_, FA0_) 1.9 dTi (JA1U), RENAULT Scénic I (JA0/1_, FA0_) 1.8 16V (JA12, JA1R, JA1M, JA1A), RENAULT Scénic I (JA0/1_, FA0_) 1.6, RENAULT Scénic I (JA0/1_, FA0_) 1.8 4x4 … View more
The steps may slightly vary depending on the car design.
RENAULT Scénic I (JA0/1_, FA0_) 1.4 16V (JA0D, JA1H, Ja0W, JA10), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V (JA1D, JA17), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V RX4, RENAULT Scénic I (JA0/1_, FA0_) 1.9 dCi RX4, RENAULT Scénic I (JA0/1_, FA0_) 1.9 dTi (JA0N), RENAULT Scénic I (JA0/1_, FA0_) 2.0 16V (JA1B, JA1D, JA0C), RENAULT Scénic I (JA0/1_, FA0_) 1.9 dCi (JA05, JA1F), RENAULT Scénic I (JA0/1_, FA0_) 1.9 dTi (JA1U), RENAULT Scénic I (JA0/1_, FA0_) 1.8 16V (JA12, JA1R, JA1M, JA1A), RENAULT Scénic I (JA0/1_, FA0_) 1.6, RENAULT Scénic I (JA0/1_, FA0_) 1.8 4x4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Track Rod End for Scénic I (JA0/1_, FA0_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #13
Combination spanner #21
Combination spanner #22
Drive socket # 13
Drive socket # 17
Drive socket # 18
Wheel impact socket #17
Ratchet wrench
Torque wrench
Vernier caliper
Ball joint puller
Wheel chock
Replacement: track rod end – RENAULT SCÉNIC I (JA0/1_). AUTODOC experts recommend:
- Replace tie rod ends in pairs.
- The replacement procedure is identical for the right and left tie rod ends.
- During the installation process, use only new bolts and nuts.
- Please note: all work on the car – RENAULT SCÉNIC I (JA0/1_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3Raise the front of the car and secure on supports.Step 4
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. RENAULT SCÉNIC I (JA0/1_) - Step 5
Remove the wheel. - Step 6
Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray. - Step 7
When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper. - Step 8
Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #21. Use a combination spanner #22. - Step 9
Unscrew the end fastening nut to the steering knuckle. Use a drive socket #17. Use a ratchet wrench. - Step 10
Loosen the fastener connecting the tie rod end to the tie rod. Use a drive socket #13. Use a ratchet wrench. - Step 11
Disconnect the tie rod end from the steering knuckle. Use a ball joint puller. - Step 12
Screw the end out of the tie rod. Use a combination spanner #13. Use a combination spanner #21. - Step 13
Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray. - Step 14
Treat the threaded part of the tie rod. Use copper grease. - Step 15
Screw on a new tie rod end.Replacement: track rod end – RENAULT SCÉNIC I (JA0/1_). AUTODOC recommends:While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements. - Step 16
Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray. - Step 17
Connect the tie rod end to the steering knuckle.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Scénic I (JA0/1, FA0) model
Popular maintenance tutorials for Renault Scenic 1
Complete guides for changing the Tie rod end on different RENAULT SCÉNIC models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT Scénic I (JA0/1_, FA0_)
View more
How to Fix P0401 ✅ error code Insufficient EGR flow
Top Automatic Transmission Blunders You Must Dodge | AUTODOC Insights
Top 4 Car Cleaning Products to Protect Your Car's Body | AUTODOC Tips
The Ultimate Guide to Engine Bay Cleaning | AUTODOC
Most commonly replaced car parts on RENAULT SCÉNIC
ОЕ number
Time to replace parts? Get even better deals in our Shop app.

SCAN ME
































