Important!

This replacement procedure can be used for:
AUDI A3 Hatchback (8P1) 1.6 E-Power, AUDI A3 Hatchback (8P1) 2.0 FSI, AUDI A3 Hatchback (8P1) 1.6, AUDI A3 Hatchback (8P1) 2.0 TDI 16V, AUDI A3 Hatchback (8P1) 1.9 TDI, AUDI A3 Hatchback (8P1) 2.0 TDI, AUDI A3 Hatchback (8P1) 3.2 V6 quattro, AUDI A3 Hatchback (8P1) 1.6 FSI, AUDI A3 Hatchback (8P1) 2.0 TDI quattro, AUDI A3 Hatchback (8P1) 2.0 TFSI, AUDI A3 Hatchback (8P1) 2.0 TFSI quattro, AUDI A3 Hatchback (8P1) 2.0 TDI 16V quattro, AUDI A3 Hatchback (8P1) 2.0 TDI, AUDI A3 Hatchback (8P1) 2.0 TDI quattro, AUDI A3 Hatchback (8P1) S3 quattro, AUDI A3 Hatchback (8P1) 2.0 TDI, AUDI A3 Hatchback (8P1) 2.0 TDI quattro, AUDI A3 Hatchback (8P1) 1.8 TFSI, AUDI A3 Hatchback (8P1) 1.4 TFSI, AUDI A3 Hatchback (8P1) S3 quattro, AUDI A3 Hatchback (8P1) 1.8 TFSI quattro, AUDI A3 Hatchback (8P1) 1.6 TDI, AUDI A3 Hatchback (8P1) 1.6 TDI, AUDI A3 Hatchback (8P1) 2.0 TDI, AUDI A3 Hatchback (8P1) 1.2 TSI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Track Rod End for A3 Hatchback (8P1) and other AUDI models

Alternative products

Track rod end

Replacement: track rod end – AUDI A3 (8P1). List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #23
                    
                      Combination spanner #24
                    
                      Drive socket # 18 
                    
                      Drive socket # 19 
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Tap wrench
                    
                      Vernier caliper
                    
                      Ball joint puller
                    
                      Wheel chock

Buy tools

Replacement: track rod end – AUDI A3 (8P1). AUTODOC recommends:

Replace tie rod ends in pairs.
The replacement procedure is identical for the right and left tie rod ends.
All work should be done with the engine stopped.

Replacement: track rod end – AUDI A3 (8P1). Take the following steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: track rod end – AUDI A3 (8P1). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the end fastening nut to the steering knuckle. Use a drive socket #18. Use a tap wrench.
Step 8

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Step 9

Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #23. Use a combination spanner #24.
Step 10

Disconnect the tie rod end from the steering knuckle. Use a ball joint puller.
Step 11

Screw the end out of the tie rod.
Step 12

Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray.
Step 13

Screw on a new tie rod end.

Replacement: track rod end – AUDI A3 (8P1). AUTODOC experts recommend:
While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Step 14

Connect the tie rod end to the steering knuckle.
Step 15

Screw on the fastening nut that connects the tie rod end to the steering knuckle. Use a drive socket #19. Use a ratchet wrench.
Step 16

Tighten the tie rod end locknut. Use a combination spanner #24 (2 pieces). Use a torque wrench. Tighten it to 50 nm torque.
Step 17

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Step 18

Tighten the fastening nut connecting the tie rod end to the steering knuckle. Use a drive socket #19. Use a torque wrench. Tighten it to 20 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 19

Treat the fastener connecting the tie rod end to the steering knuckle. Use copper grease.
Step 20

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 21

Clean the brake disk surface. Use a brake cleaner.

Replacement: track rod end – AUDI A3 (8P1). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 22

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. AUDI A3 (8P1)
Step 23

Screw in the wheel bolts. Use wheel impact socket #17.
Step 24

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 nm torque.

Replacement: track rod end – AUDI A3 (8P1). Professionals recommend:
Check and adjust wheel alignment if necessary.
Step 25

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the AUDI A3 Hatchback (8P1) model

Audi A3 8P tyre size

How to change front strut mount on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
3.78 MB
How to change rear strut mount on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
1.69 MB
How to change rear suspension lower trailing arm on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
1.67 MB
How to change rear wheel bearing on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
2.05 MB
How to change front lower arm on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
1.9 MB
How to change rear suspension lower control arm on AUDI A3 Hatchback (8P1) – replacement guide

Free download PDF
1.63 MB

How to change track rod end on Audi A3 8PA – replacement guide

Free download PDF
1.4 MB
How to change track rod end on AUDI A3 Sportback (8VA, 8VF) – replacement guide

Free download PDF
1.47 MB
How to change track rod end on AUDI A3 Hatchback (8V1, 8VK) – replacement guide

Free download PDF
1.47 MB
How to change track rod end on AUDI A3 Saloon (8VS, 8VM) – replacement guide

Free download PDF
1.47 MB
How to change track rod end on AUDI A3 Hatchback (8L1) – replacement guide

Free download PDF
1.38 MB
How to change track rod end on AUDI A3 Convertible (8P7) – replacement guide

Free download PDF
1.47 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

What to do if your car’s bonnet won’t open | AUTODOC tips

7K views

Published on: 12/09/2024
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide

4K views

Published on: 07/04/2022
Top 5 reasons why the suspension knocks | AUTODOC tips

2M views

Published on: 09/09/2022
5 Essential Tips for beginner drivers: Avoid Common Mistakes

4K views

Published on: 31/01/2023