Important!

This replacement procedure can be used for:
FORD Tourneo Custom V362 Minibus (F3) 2.2 TDCi, FORD Tourneo Custom V362 Minibus (F3) 2.2 TDCi, FORD Tourneo Custom V362 Minibus (F3) 2.2 TDCi, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue mHEV, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue mHEV, FORD Tourneo Custom V362 Minibus (F3) 1.0 EcoBoost PHEV, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue, FORD Tourneo Custom V362 Minibus (F3) 2.0 EcoBlue mHEV … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Anti Roll Bar Links for Tourneo Custom V362 Minibus (F3) and other FORD models

Alternative products

Anti-roll bar link

Replacement: anti roll bar links – FORD TOURNEO CUSTOM Bus. Tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Ceramic grease
                    
                      Torque wrench
                    
                      20 mm combination spanner
                    
                      10 mm socket
                    
                      17 mm socket
                    
                      19 mm socket
                    
                      H5 Allen key
                    
                      21 mm wheel impact socket
                    
                      Ratchet wrench or power tool for removal/installation of threaded fasteners
                    
                      Tommy bar
                    
                      Car lift or jack with jack stands, and wheel chocks

Buy tools

Replacement: anti roll bar links – FORD TOURNEO CUSTOM Bus. AUTODOC recommends:

Replace the anti-roll bar links and bushes in pairs.
The replacement procedure is identical for the anti-roll bar links and bushes on both sides of the same axle.
All the work should be carried out with the ignition switched off.

Replacement: anti roll bar links – FORD TOURNEO CUSTOM Bus. Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel nuts on the front wheels. Use a 21 mm wheel impact socket. Use a tommy bar.
Step 3

Raise the vehicle.

Warning!
If you are using a jack, make sure the car is parked on a hard, flat surface.Make sure to additionally secure the car with jack stands.
Step 4

Unscrew the nuts on one of the wheels and remove it.

Replacement: anti roll bar links – FORD TOURNEO CUSTOM Bus. Tip:
To avoid injury, hold up the wheel when unscrewing the nuts.
Step 5

Remove the other wheel in the same way.
Step 6

Clean the fasteners of one of the anti-roll bar links. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the fastener connecting the anti-roll bar link to the anti-roll bar. Use a 19 mm combination spanner. Use an H5 Allen key to secure the ball stud. Use a ratchet wrench.
Step 8

Unscrew the fastener connecting the anti-roll bar link to the suspension strut. Use a 19 mm socket. Use a ratchet wrench.
Step 9

Remove the anti-roll bar link.
Step 10

Follow the same steps to remove the other anti-roll bar link.
Step 11

Clean the mounting seats of the anti-roll bar link on one side of the axle. Use a wire brush. Use an all-purpose cleaning spray.
Step 12

Install a new anti-roll bar link and its fasteners.
Step 13

Tighten the fastener connecting the anti-roll bar link to the anti-roll bar. Use a 20 mm combination spanner. Use a 17 mm socket. Use a torque wrench. Tightening torque: 55 N·m.
Step 14

Tighten the fastener connecting the anti-roll bar link to the suspension strut. Use a 20 mm combination spanner. Use a 17 mm socket. Use a torque wrench. Tightening torque: 55 N·m.
Step 15

Follow the same steps to install a new anti-roll bar link on the other side.
Step 16

Clean the mounting seat of one of the wheels. Use a wire brush. Use an all-purpose cleaning spray.
Step 17

Treat the wheel hub surface that contacts the wheel rim. Use ceramic grease.
Step 18

Install the wheel.

Replacement: anti roll bar links – FORD TOURNEO CUSTOM Bus. Tip from AUTODOC:
To avoid injury, hold up the wheel when screwing on the fastening nuts.
Step 19

Screw on the wheel nuts. Use a 21 mm wheel impact socket. Use a ratchet wrench.
Step 20

Reinstall the other wheel in the same way.

Step 21

Lower the car and tighten the wheel nuts in a criss-cross order. Use a 21 mm wheel impact socket. Use a torque wrench. Tightening torque: 200 N·m.
Step 22

Remove the jack, jack stands, and wheel chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the FORD Tourneo Custom V362 Minibus (F3) model

Ford Tourneo Custom Minibus tyre size

How to change tie rod ends on the FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
1.57 MB
How to change front ball joint on FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
12.3 MB
How to change the serpentine belt on the FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
788.48 KB
How to change rear windshield wipers on FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
593.92 KB
How to change engine oil and filter on FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
1.47 MB
How to change the engine thermostat on the FORD Tourneo Custom V362 Minibus (F3) – replacement guide

Free download PDF
1.35 MB

How to change anti roll bar links on a car – replacement tutorial

Universal

Free download PDF
972.8 KB
How to change front anti roll bar links on Ford Focus MK2 – replacement guide

Free download PDF
1.99 MB
How to change front anti roll bar links on Ford Mondeo Mk3 saloon – replacement guide

Free download PDF
1.29 MB
How to change front anti roll bar links on Ford Fiesta JA8 – replacement guide

Free download PDF
1.31 MB
How to change front anti roll bar links on Ford Focus DAW – replacement guide

Free download PDF
1.27 MB
How to change rear anti roll bar links on Ford Mondeo Mk3 saloon – replacement guide

Free download PDF
1.23 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide

4K views

Published on: 07/04/2022
5 possible reasons why your car heater isn't working

6K views

Published on: 21/11/2024
5 Essential Tips to Prepare Your Car for Winter | AUTODOC tips

6K views

Published on: 05/02/2024
Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips

7K views

Published on: 20/05/2021