Important!

This replacement procedure can be used for:
TOYOTA Yaris III Van (XP13) 1.0 VVTi (KSP130), TOYOTA Yaris III Van (XP13) 1.5 VVTi (NSP131), TOYOTA Yaris III Van (XP13) 1.4 D4d (NLP130), TOYOTA Yaris III Van (XP13) 1.0 VVTi (KSP130), TOYOTA Yaris III Van (XP13) 1.3 VVTi (NSP130) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for Yaris III Van (XP13) and other TOYOTA models

Alternative products

Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Tools you'll need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Brake cleaner 
                    
                      Electronic spray
                    
                      Anti-squeal paste
                    
                      Ceramic grease
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Drive socket # 14
                    
                      HEX bit No.H7
                    
                      Wheel impact socket #21
                    
                      Ratchet wrench
                    
                      Flat screwdriver
                    
                      Hammer
                    
                      Crow bar
                    
                      Hydraulic transmission jack
                    
                      Wheel chock

Buy tools

AUTODOC recommends:

Do not re-use the bearing assembly of your TOYOTA Yaris III Kastenwagen (XP13) car.
The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
Please note: all work on the car – TOYOTA Yaris III Kastenwagen (XP13) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 4

Raise the car.

Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Tip from AUTODOC experts:
If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. TOYOTA Yaris III Kastenwagen (XP13)
Step 6

Remove the wheel.
Step 7

Detach the brake caliper retaining spring. Use a crowbar.
Step 8

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 9

Unscrew the brake caliper fasteners. Use HEX No.H7. Use a ratchet wrench.
Step 10

Remove the brake caliper. Use a crowbar.

Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Tip:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 11

Remove the brake pads.
Step 12

Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
Step 13

Unscrew the brake caliper bracket fasteners. Use a drive socket #14. Use a ratchet wrench.
Step 14

Remove the fastening bolts.
Step 15

Remove the caliper bracket.
Step 16

Remove the brake disc.
Step 17

Clean the ABS sensor fastener. Use a nylon cleaning brush. Use all-purpose cleaning spray.
Step 18

Detach the ABS sensor connector. Use a flat screwdriver.
Step 19

Clean the wheel hub fastener. Use a wire brush. Use WD-40 spray.
Step 20

Support the rear suspension beam. Use a hydraulic transmission jack.
Step 21

Unscrew the wheel hub bearing fasteners. Use a drive socket #14. Use a ratchet wrench.
Step 22

Remove the fastening bolts.
Step 23

Remove the hub and the bearing together, since they are made as an assembly. Use a crowbar. Use a hammer.
Step 24

Clean the hub bearing mounting seat. Use a wire brush. Use all-purpose cleaning spray.
Step 25

Treat the wheel hub mounting seat. Use copper grease.
Step 26

Install the new wheel hub together with the bearing.
Step 27

Install the fastening bolts.
Step 28

Tighten the wheel hub bearing fasteners. Use a drive socket #14. Use a torque wrench. Tighten it to 90 nm torque.
Step 29

Treat the fasteners of the wheel hub bearing. Use copper grease.
Step 30

Remove the support from under the rear axle beam.

AUTODOC recommends:
Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 31

Treat the hub where it contacts the brake disk. Use ceramic grease.
Step 32

Install the brake disc.
Step 33

Treat the ABS sensor connector. Use dielectric grease.
Step 34

Attach the ABS sensor connector.
Step 35

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). After applying the spray, wait a few minutes.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 36

Install the brake caliper bracket.
Step 37

Install the fastening bolts.
Step 38

Tighten the brake caliper bracket fasteners. Use a drive socket #14. Use a torque wrench. Tighten it to 57 Nm torque.
Step 39

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Tip from AUTODOC experts:
Make sure the disc surface is clean before installing the pads.
Step 40

Install the brake pads.
Step 41

Install the brake caliper and fix it.
Step 42

Tighten the brake caliper fasteners. Use HEX No.H7. Use a torque wrench. Tighten it to 34 nm torque.
Step 43

Install the dust boot caps of the brake caliper guide pins.
Step 44

Install the brake caliper retaining spring.
Step 45

Clean the wheel rim mounting seat. Use a wire brush.
Step 46

Treat the surface where the brake disc contacts the wheel rim. Use ceramic grease.
Step 47

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). After applying the spray, wait a few minutes.
Step 48

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. TOYOTA Yaris III Kastenwagen (XP13)
Step 49

Screw in the wheel bolts. Use wheel impact socket #21.
Step 50

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #21. Use a torque wrench. Tighten it to 103 Nm torque.
Step 51

Remove the jacks and chocks.

Replacement: wheel bearing – TOYOTA Yaris III Kastenwagen (XP13). Tip from AUTODOC experts:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Check the brake fluid level in the expansion tank and refill if necessary.
Step 52

Tighten the brake fluid reservoir cap. Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Yaris III Van (XP13) model

TOYOTA Yaris III Kastenwagen (XP13) tyre size

How to change front wheel bearing on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
3.91 MB
How to change front brake pads on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
1.57 MB
How to change rear brake pads on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
1.6 MB
How to change front brake discs on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
1.93 MB
How to change rear brake discs on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
1.95 MB
How to change spark plugs on TOYOTA Yaris III Van (XP13) – replacement guide

Free download PDF
1.06 MB

How to change front wheel bearing on Toyota Yaris Mk2 – replacement guide

Free download PDF
3.78 MB
How to change rear wheel bearing on Toyota Yaris Mk2 – replacement guide

Free download PDF
2.64 MB
How to change front wheel bearing on Toyota Yaris P1 – replacement guide

Free download PDF
2.53 MB
How to change rear wheel bearing on Toyota Yaris P1 – replacement guide

Free download PDF
1.13 MB
How to change front wheel bearing on TOYOTA Yaris III Hatchback (XP13) – replacement guide

Free download PDF
3.91 MB
How to change front wheel bearing on TOYOTA Yaris Hatchback (_P13_) – replacement guide

Free download PDF
3.71 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How to repair a bumper yourself | AUTODOC tips

16K views

Published on: 01/06/2023
TOP 5 mistakes when replacing shock absorbers | AUTODOC tips

14K views

Published on: 15/06/2023
Kolbenschmidt plastic gauge overview

2K views

Published on: 23/04/2025
How to fix your car with AUTODOC CLUB

17K views

Published on: 30/11/2021