Important!

This replacement procedure can be used for:
AUDI A4 Saloon (8D2, B5) 1.8, AUDI A4 Saloon (8D2, B5) 1.8 T, AUDI A4 Saloon (8D2, B5) 2.6, AUDI A4 Saloon (8D2, B5) 2.8, AUDI A4 Saloon (8D2, B5) 1.9 TDI, AUDI A4 Saloon (8D2, B5) 1.9 TDI, AUDI A4 Saloon (8D2, B5) 2.8, AUDI A4 Saloon (8D2, B5) 2.4, AUDI A4 Saloon (8D2, B5) 2.5 TDI, AUDI A4 Saloon (8D2, B5) 1.9 TDI, AUDI A4 Saloon (8D2, B5) 1.8 T, AUDI A4 Saloon (8D2, B5) 1.9 TDI, AUDI A4 Saloon (8D2, B5) 1.8, AUDI A4 Saloon (8D2, B5) 1.6, AUDI A4 Saloon (8D2, B5) 2.4 … View more

The steps may slightly vary depending on the car design.

How to change rear springs on AUDI A4 B5 Saloon [TUTORIAL AUTODOC]

All the parts you need to replace – Springs for A4 Saloon (8D2, B5) and other AUDI models

Alternative products

Coil spring

Replacement: coil springs – Audi A4 B5 saloon. Tools you might need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Combination spanner #16
                    
                      Drive socket # 13
                    
                      Drive socket # 16
                    
                      Drive socket # 17
                    
                      Shock absorber socket DD#5,2
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Clip removal tool
                    
                      Hydraulic strut spring compressor
                    
                      Hydraulic transmission jack
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: coil springs – Audi A4 B5 saloon. AUTODOC experts recommend:

Both coil springs of the rear suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right coil springs of the rear suspension.
Please note: all work on the car – Audi A4 B5 saloon – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Remove the rear seat backrest.
Step 2

Remove the side plastic cover.

Step 3

Remove the retainer of the side trim panel. Use a clip removal tool.
Step 4

Move the side trim panel aside.
Step 5

Loosen the upper fasteners of the suspension strut. Use a drive socket #13. Use a ratchet wrench.
Step 6

Secure the wheels with chocks.

Step 7

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 8

Raise the rear of the car and secure on supports.
Step 9

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Audi A4 B5 saloon
Step 10

Remove the wheel.
Step 11

Support the rear suspension beam. Use a hydraulic transmission jack.
Step 12

Clean the lower fastener connecting the suspension strut to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 13

Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Step 14

Lower the hydraulic transmission jack by 10-15 cm.
Step 15

Remove the fastening bolt.
Step 16

Unscrew the upper fasteners of the shock strut.

AUTODOC recommends:
Audi A4 B5 saloon – To avoid injury, hold the suspension strut while unscrewing the fastening bolts.
Step 17

Remove the suspension strut. Use a crowbar.
Step 18

Set the shock absorber strut on the spring compressor tool.

Replacement: coil springs – Audi A4 B5 saloon. Professionals recommend:
Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
Step 19

Compress the spring.
Step 20

Remove the shock strut mount cap. Use a crowbar.
Step 21

Treat the shock strut rod. Use a wire brush. Use WD-40 spray.
Step 22

Remove the strut piston rod nut. Use a drive socket #17. Use a shock absorber socket DD№5,2. Use a ratchet wrench.
Step 23

Remove the top strut mount.
Step 24

Remove the shock absorber dust cap and the bump stop.

AUTODOC recommends:
Replacement: coil springs – Audi A4 B5 saloon. Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 25

Release the coil spring.
Step 26

Remove the spring.
Step 27

Install the spring on the shock absorber.
Step 28

Compress the spring.
Step 29

Install the boot and a bump stop onto the shock absorber.
Step 30

Install the upper strut mount and the strut mount bearing.
Step 31

Tighten the shock strut piston rod nut. Use a drive socket #16. Use a shock absorber socket DD№5,2. Use a torque wrench. Tighten it to 25 Nm torque.

Replacement: coil springs – Audi A4 B5 saloon. Tip from AUTODOC:
Check to make sure the spring is positioned correctly. Avoid its misalignment.
Step 32

Decompress the spring.
Step 33

Treat the shock strut rod. Use copper grease.

Step 34

Install the shock strut mount cap.
Step 35

Remove the assembled shock strut.
Step 36

Clean the mounting seats of the shock strut. Use a wire brush. Use WD-40 spray.
Step 37

Install the shock strut into the wheel arch.
Step 38

Install the fastening bolt.
Step 39

Secure the upper fasteners of the shock strut. Use a crowbar. Do not tighten it.

AUTODOC recommends:
Audi A4 B5 saloon – To avoid injury, hold the suspension strut while screwing in the fastening bolts.
Step 40

Screw in the lower fastener of the shock strut. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Step 41

Raise the hydraulic transmission jack by 10-15 cm.
Step 42

Tighten the lower fastening of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 50 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 43

Remove the support from under the rear axle beam.

AUTODOC recommends:
Audi A4 B5 saloon – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car.
Step 44

Treat the shock strut fasteners. Use copper grease.
Step 45

Clean the wheel rim mounting seat. Use a wire brush.
Step 46

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 47

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: coil springs – Audi A4 B5 saloon. After applying the spray, wait a few minutes.
Step 48

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. Audi A4 B5 saloon
Step 49

Screw in the wheel bolts. Use wheel impact socket #17.
Step 50

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 Nm torque.
Step 51

Remove the jacks and chocks.
Step 52

Tighten the upper fasteners of the shock strut. Use a drive socket #13. Use a torque wrench. Tighten it to 25 nm torque.
Step 53

Treat the fasteners of the shock strut mount. Use copper grease.

Step 54

Return the side trim panel to its initial position.
Step 55

Install the side trim panel retainer.
Step 56

Install the side plastic panel.
Step 57

Reinstall the rear seat backrest.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the AUDI A4 B5 Saloon (8D2) model

Audi A4 B5 tyre size

How to change rear suspension strut on Audi A4 B5 saloon – replacement guide

Free download PDF
2.77 MB
How to change front suspension strut on Audi A4 B5 saloon – replacement guide

Free download PDF
4.67 MB
How to change front coil springs on Audi A4 B5 saloon – replacement guide

Free download PDF
4.27 MB
How to change rear brake pads on Audi A4 B5 saloon – replacement guide

Free download PDF
1.51 MB
How to change front brake pads on Audi A4 B5 saloon – replacement guide

Free download PDF
1.51 MB
How to change rear brake discs on Audi A4 B5 saloon – replacement guide

Free download PDF
1.98 MB

How to change front coil springs on Audi A4 B8 – replacement guide

Free download PDF
5.41 MB
How to change front coil springs on AUDI A4 B8 Avant (8K5) – replacement guide

Free download PDF
5.4 MB
How to change front coil springs on AUDI A4 Convertible (8H7, B6, 8HE, B7) – replacement guide

Free download PDF
3.95 MB
How to change front coil springs on Audi A4 B7 Avant – replacement guide

Free download PDF
3.27 MB
How to change front coil springs on Audi A4 B7 – replacement guide

Free download PDF
4.01 MB
How to change front coil springs on Audi A4 B6 Avant – replacement guide

Free download PDF
4.25 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

5 mistakes when replacing consumables

5K views

Published on: 06/02/2025
How to easily repair a punctured tyre | AUTODOC tips

3K views

Published on: 25/02/2021
Transform Your Old Engine Valve Cover: Quick Polishing Tips for a Shiny Finish | AUTODOC Tips

10K views

Published on: 30/11/2023
5 more brake repair mistakes | Stop making these brake repair mistakes

9K views

Published on: 22/01/2025