Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
TOYOTA Urban Cruiser (_P1_) 1.33 (NSP110_), TOYOTA Urban Cruiser (_P1_) 1.33 (NSP110_), TOYOTA Urban Cruiser (_P1_) 1.4 D-4D (NLP110_), TOYOTA Urban Cruiser (_P1_) 1.4 D-4D 4WD (NLP115_) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Urban Cruiser (_P1_) and other TOYOTA models

Brake pad set

        Brake pad set for Urban Cruiser (XP110) Petrol (99 hp)
      
        Brake pad set for Urban Cruiser (XP110) Petrol (101 hp)
      
        Brake pad set for Urban Cruiser (XP110) Diesel (90 hp)
      
        Brake pad set for Urban Cruiser (XP110) Diesel (90 hp)

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). List of the tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        Combination spanner #14
                      
                        Combination spanner #17
                      
                        Drive socket # 14 
                      
                        Wheel impact socket #21
                      
                        Brake caliper wind back tool
                      
                        Torque wrench
                      
                        Water pump pliers
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Professionals recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Warning! Shut down the engine before starting any work – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_).

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Detach the parking brake cable from the bracket on the brake caliper. Use water pump pliers.
Step 9

Unscrew the brake caliper fastening. Use a combination spanner #14. Use a combination spanner #17.
Step 10

Spread the brake pads. Use a crowbar.

Step 11

Remove the brake caliper.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 12

Remove the brake pads.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 13

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). After applying the spray, wait a few minutes.
Step 14

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Tip:
Make sure the disc surface is clean before installing the pads.
Step 15

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 16

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 17

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 18

Install the brake caliper and fix it. Use a combination spanner #17. Use a drive socket #14. Use a torque wrench. Tighten it to 35 Nm torque.
Step 19

Install the parking brake cable into the brake caliper bracket.
Step 20

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 21

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). After applying the spray, wait a few minutes.
Step 22

Install the wheel.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Tip:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 23

Screw in the wheel bolts. Use wheel impact socket #21.
Step 24

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 103 Nm torque.
Step 25

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Check the brake fluid level in the reservoir and top up if necessary.
Step 26

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 27

Close the hood.

Replacement: brake pads – TOYOTA URBAN CRUISER (NSP1_, NLP1_, ZSP1_, NCP11_). Tip from AUTODOC experts:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Urban Cruiser (XP110) model.

Toyota Urban Cruiser XP11 tyre size

How to change front brake pads on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
1.56 MB
How to change front wheel bearing on TOYOTA Urban Cruiser (XP110) – replacement guide

Free download PDF
3.91 MB
How to change front wheel bearing on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
3.7 MB
How to change spark plugs on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
1.06 MB
How to change engine oil and filter on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
1.1 MB
How to change air filter on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
952.32 KB

How to change front brake pads on TOYOTA Urban Cruiser (_P1_) – replacement guide

Free download PDF
1.56 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on Toyota Prado J120 – replacement guide

Free download PDF
2.08 MB
How to change rear brake pads on Toyota Auris E15 – replacement guide

Free download PDF
1.53 MB
How to change rear brake pads on Toyota RAV4 III – replacement guide

Free download PDF
1.96 MB
How to change front brake pads on Toyota Aygo AB1 – replacement guide

Free download PDF
2.47 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Things you should never do with your manual transmission | AUTODOC tips

6K views

Published on: 20/10/2020
How to easily repair a punctured tyre | AUTODOC tips

3K views

Published on: 25/02/2021
Coolant comparison test | AUTODOC

11K views

Published on: 18/02/2021
3 things to know before buying summer tyres | AUTODOC tips

3K views

Published on: 18/05/2023