Disclaimer
How to change rear brake discs on FIAT Panda Hatchback (312_, 319_) – replacement guide
downloads:
17
Views:
325
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXU1A), FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXS2A), FIAT Panda Hatchback (312_, 319_) 0.9 4x4 (312PXR2B), FIAT Panda Hatchback (312_, 319_) 0.9 4x4 (312PXG1A), FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXL1A) … View more
The steps may slightly vary depending on the car design.
FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXU1A), FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXS2A), FIAT Panda Hatchback (312_, 319_) 0.9 4x4 (312PXR2B), FIAT Panda Hatchback (312_, 319_) 0.9 4x4 (312PXG1A), FIAT Panda Hatchback (312_, 319_) 1.3 D Multijet 4x4 (312PXL1A) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for Panda Hatchback (312_, 319_) and other FIAT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #13
Combination spanner #17
Drive socket # 12
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Rubber mallet
Crow bar
Wheel chock
Replacement: brake discs – FIAT PANDA (312). AUTODOC experts recommend:
- Replace the brake disks on the car FIAT PANDA (312) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – FIAT PANDA (312) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.Replacement: brake discs – FIAT PANDA (312). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a drive socket #13. Use a combination spanner #17. Use a ratchet wrench. - Step 9
Remove the brake caliper.Replacement: brake discs – FIAT PANDA (312). AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 10
Remove the brake pads. Use a crowbar. - Step 11
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 12
Unscrew the caliper bracket fastening. Use a combination spanner #13. - Step 13
Remove the caliper bracket. - Step 14
Clean the brake disk surface. Use a wire brush. Use WD-40 spray. - Step 15
Unscrew the brake disc fastening. Use a drive socket #12. Use a ratchet wrench.Replacement: brake discs – FIAT PANDA (312). Tip from AUTODOC:If necessary, use a rubber mallet. - Step 16Remove the brake disc.Step 17
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 18
Install the brake disc. - Step 19
Tighten the brake disc fastening. Use a drive socket #12. Use a torque wrench. Tighten it to 9 Nm torque.
Comments –
2
- I.S.01.01.2025 17:22MemberIt's a bit more difficult than that.
@Graziana Venturi02.01.2025 13:39I.S.ModeratorWe cannot show all the nuances and problems during replacement, it is all individual and it is not always possible to solve them at home. To avoid this, we always recommend making replacements at specialized services.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 1
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FIAT Panda III Hatchback (312, 319) model
Popular maintenance tutorials for Fiat Panda 312
Complete guides for changing the Brake rotors on different FIAT PANDA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FIAT Panda Hatchback (312_, 319_)
View more
Top 5 mistakes when replacing spark plugs | AUTODOC tips
Fuse Replacement Made Simple: Step-by-Step Guide | AUTODOC
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Coolant comparison test | AUTODOC
Most commonly replaced car parts on FIAT PANDA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






























