Recommended replacement interval for the part category Spark Plug : 60000 km

Important!

This replacement procedure can be used for:
PEUGEOT 107 Hatchback (PM_, PN_) 1.0

The steps may slightly vary depending on the car design.

How to change spark plug on PEUGEOT 107 1 (PM, PN) [TUTORIAL AUTODOC]

Replacement: spark plugs – Peugeot 107 PM PN. List of the tools you'll need:

                        Electronic spray
                      
                        High-temperature anti-seize lubricant
                      
                        Drive socket # 10 
                      
                        Spark plug socket # 16
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Telescoping magnet 
                      
                        Clic-R collar pliers
                      
                        Flat Screwdriver
                      
                        Microfibre towel
                      
                        Fender cover

All the parts you need to replace – Spark Plug for 107 Hatchback (PM_, PN_) and other PEUGEOT models

PEUGEOT 107 Hatchback (PM_, PN_) 1.0

Replacement: spark plugs – Peugeot 107 PM PN. AUTODOC recommends:

The replacement procedure is the same for all spark plugs.
All work should be done with the engine stopped.

Replacement: spark plugs – Peugeot 107 PM PN. Use the following procedure:

Step 1

Open the bonnet.
Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3

Remove the fastening clamps of the air filter breather pipe and the air filter inlet pipe. Use clic-R collar pliers.
Step 4

Release the air filter cover clips.
Step 5

Take off the filter lid.
Step 6

Cover the throttle body with a microfibre towel to prevent dust and dirt from getting into the system.
Step 7

Clean the ignition coils.
Step 8

Unplug the connectors from the ignition coils.
Step 9

Unscrew the fasteners of the ignition coils.Use a drive socket #10.Use a ratchet wrench.
Step 10

Take out the ignition coils from the spark plug wells.

Replacement: spark plugs – Peugeot 107 PM PN. AUTODOC experts recommend:

Remember the sequence of steps for ignition coil demounting.
Step 11

Clean dirt, dust and debris from inside the spark plug wells.
Step 12

Unscrew the spark plugs. Use the spark plug socket #16.Use a ratchet wrench.
Step 13

Take out the spark plugs.Use a telescoping magnet.
Step 14

Apply a thin layer of a special high temperature anti-seize lubricant to the threads of the new spark plugs.Use a flat screwdriver.
Step 15

Install the new spark plugs into their mounting seats.Use the spark plug socket #16.
Step 16

Screw new spark plugs and tighten them.Use the spark plug socket #16.Use a torque wrench.Tighten it to 27 nm torque.

Replacement: spark plugs – Peugeot 107 PM PN. Tip from AUTODOC:

Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection. Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.
Step 17

Install the ignition coils to the spark plug wells.Make sure you hear a click indicating that it is locked in place.

AUTODOC recommends:

Replacement: spark plugs – Peugeot 107 PM PN. Follow the installation steps.
Step 18

Tighten the fasteners of the ignition coils.Use a drive socket #10.Use a ratchet wrench.
Step 19

Treat the ignition coil connector with electronic spray.The spray will protect the electrical contacts from corrosion, oxidation, and will reduce the contact resistance.
Step 20

Plug in the connectors of the ignition coils.
Step 21

Clean the air filter cover and housing.
Step 22

Remove the microfibre towel from the throttle body.
Step 23

Reinstall the air filter cover. Fasten it.
Step 24

Press the air filter cover clips into place.
Step 25

Install the fastening clamps of the air filter breather pipe and the air filter inlet pipe. Use clic-R collar pliers.
Step 26

Run the engine for a few minutes.This is necessary in order to make sure that the component operates properly.

Step 27

Shut off the engine.

Step 28

Remove the fender protection cover.
Step 29

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change: Peugeot 107 PM PN front windshield wipers – replacement guide

Free download PDF

2.23 MB
How to change: Peugeot 107 PM PN engine oil and filter – replacement guide

Free download PDF

6.67 MB
How to change: Peugeot 107 PM PN pollen filter – replacement guide

Free download PDF

2.21 MB
How to change: Peugeot 107 PM PN air filter – replacement guide

Free download PDF

4.54 MB
How to change: Peugeot 107 PM PN rear windshield wipers – replacement guide

Free download PDF

2.57 MB
How to change: Peugeot 107 PM PN front anti roll bar links – replacement guide

Free download PDF

7.04 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your PEUGEOT 107 Hatchback (PM_, PN_)

How to remove a broken bolt without welding | AUTODOC tips

260K views

Published on: 11/03/2020
Noise from under the hood | AUTODOC TIPS

198K views

Published on: 25/08/2019
How to fix a knocking and creaking suspension | AUTODOC

181K views

Published on: 08/09/2019
6 SIGNS OF A BAD FUEL FILTER | AUTODOC

163K views

Published on: 24/07/2019