Important!

This replacement procedure can be used for:
FORD FOCUS III Saloon 1.6 Ti, FORD FOCUS III Saloon 1.6 EcoBoost, FORD FOCUS III Saloon 1.6 EcoBoost, FORD FOCUS III Saloon 1.6 Flexifuel, FORD FOCUS III Saloon 1.6 Ti, FORD FOCUS III Saloon 1.6 Ti … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Ignition Coil for FOCUS III Saloon and other FORD models

Ignition coil

        Ignition coil for Focus Mk3 Saloon (DYB) Petrol (105 hp)
      
        Ignition coil for Focus Mk3 Saloon (DYB) Petrol (125 hp)
      
        Ignition coil for Focus Mk3 Saloon (DYB) Petrol/Ethanol (120 hp)
      
        Ignition coil for Focus Mk3 Saloon (DYB) Petrol (150 hp)
      
        Ignition coil for Focus Mk3 Saloon (DYB) Petrol (182 hp)
      
        Ignition coil for Focus Mk3 Saloon (DYB) Petrol (85 hp)

Replacement: ignition coil – FORD FOCUS III Saloon. Tools you might need:

                        Electronic spray
                      
                        Torque wrench
                      
                        Torx bit T20
                      
                        Ratchet wrench
                      
                        Fender cover

Buy tools

Replacement: ignition coil – FORD FOCUS III Saloon. Tip from AUTODOC experts:

The replacement procedure is the same for the ignition coils of all cylinders.
All work should be done with the engine stopped.

Replacement: ignition coil – FORD FOCUS III Saloon. Take the following steps:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Remove the engine cover.

AUTODOC recommends:
Replacement: ignition coil – FORD FOCUS III Saloon. Do not use excessive force when removing the part as this may damage it.
Step 4

Detach the connector from the ignition coil.
Step 5

Make marks to indicate the order of installation of the spark plug wires.
Step 6

Disconnect the spark plug wires from the ignition coil.

AUTODOC recommends:
Be careful to avoid damaging spark plug wires.Remember the position of the spark plug wires.
Step 7

Unscrew the ignition coil bracket. Use Torx T20. Use a ratchet wrench.
Step 8

Remove the ignition coil.
Step 9

Install a new ignition coil.
Step 10

Tighten the ignition coil fastening. Use Torx T20. Use a torque wrench. Tighten it to 8 nm torque.
Step 11

Treat the ignition coil connector with electronic spray.
Step 12

Plug in the ignition coil connector.
Step 13

Connect the spark plug wires to the ignition coil.

AUTODOC recommends:
Follow the installation sequence.
Step 14

Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.

Step 15

Shut off the engine.

Step 16

Install the engine cover and secure it.

Replacement: ignition coil – FORD FOCUS III Saloon. Tip from AUTODOC:
Make sure the engine cover is properly seated. It should not be displaced with respect to the guiding fasteners.When installing, do not use excessive force to avoid damage to the part.
Step 17

Remove the fender protection cover.

Step 18

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Focus Mk3 Saloon (DYB) model.

Browse tyres

How to change right engine mounts on FORD FOCUS III Saloon – replacement guide

Free download PDF
1.2 MB
How to change serpentine belt on FORD FOCUS III Saloon – replacement guide

Free download PDF
768 KB
How to change spark plugs on FORD FOCUS III Saloon – replacement guide

Free download PDF
931.84 KB
How to change water pump & timing belt kit on FORD Focus Mk3 Saloon (DYB) – replacement guide

Free download PDF
7.56 MB
How to change front brake pads on FORD Focus Mk3 Saloon (DYB) – replacement guide

Free download PDF
2.36 MB
How to change rear brake pads on FORD FOCUS III Saloon – replacement guide

Free download PDF
1.72 MB

How to change ignition coil on FORD FOCUS III – replacement guide

Free download PDF
1.01 MB
How to change ignition coil on FORD Focus II Hatchback (DA_, HCP, DP) – replacement guide

Free download PDF
1.01 MB
How to change ignition coil on FORD Focus C-Max (DM2) – replacement guide

Free download PDF
1 MB
How to change ignition coil on FORD FOCUS III Turnier – replacement guide

Free download PDF
1.01 MB
How to change ignition coil on FORD FOCUS II Convertible – replacement guide

Free download PDF
1.01 MB
How to change ignition coil on FORD Focus II Estate (DA_, FFS, DS) – replacement guide

Free download PDF
1 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 tools that make car repair incredibly simple | AUTODOC tips

36K views

Published on: 25/01/2024
Car checks you need to carry out on your car after the winter | AUTODOC tips

3K views

Published on: 23/03/2023
DIY alternator repair | AUTODOC tips

1M views

Published on: 30/11/2022
What to do if your car's air conditioning isn't working properly | AUTODOC tips

6K views

Published on: 05/08/2021