Important!

This replacement procedure can be used for:
FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.4 LPG, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.6 Ti, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.4 LPG, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.6 Ti, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.4, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.25, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.25, FORD Fiesta Mk6 Hatchback (JA8, JR8) 1.6 Ti … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Ignition Coil for Fiesta Mk6 Hatchback (JA8, JR8) and other FORD models

Ignition coil

        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (134 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (60 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (82 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (97 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (120 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol/Petroleum Gas (LPG) (97 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol (105 hp)
      
        Ignition coil for Fiesta Mk6 Hatchback (JA8, JR8) Petrol/Petroleum Gas (LPG) (92 hp)

Replacement: ignition coil – FORD FIESTA VI. Tools you might need:

                        Electronic spray
                      
                        Torque wrench
                      
                        Torx bit T20
                      
                        Ratchet wrench
                      
                        Fender cover

Buy tools

Replacement: ignition coil – FORD FIESTA VI. Tip from AUTODOC experts:

The replacement procedure is the same for the ignition coils of all cylinders.
All work should be done with the engine stopped.

Replacement: ignition coil – FORD FIESTA VI. Take the following steps:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Remove the engine cover.

AUTODOC recommends:
Replacement: ignition coil – FORD FIESTA VI. Do not use excessive force when removing the part as this may damage it.
Step 4

Detach the connector from the ignition coil.
Step 5

Make marks to indicate the order of installation of the spark plug wires.
Step 6

Disconnect the spark plug wires from the ignition coil.

AUTODOC recommends:
Be careful to avoid damaging spark plug wires.Remember the position of the spark plug wires.
Step 7

Unscrew the ignition coil bracket. Use Torx T20. Use a ratchet wrench.
Step 8

Remove the ignition coil.
Step 9

Install a new ignition coil.
Step 10

Tighten the ignition coil fastening. Use Torx T20. Use a torque wrench. Tighten it to 8 nm torque.
Step 11

Treat the ignition coil connector with electronic spray.
Step 12

Plug in the ignition coil connector.
Step 13

Connect the spark plug wires to the ignition coil.

AUTODOC recommends:
Follow the installation sequence.
Step 14

Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.

Step 15

Shut off the engine.

Step 16

Install the engine cover and secure it.

Replacement: ignition coil – FORD FIESTA VI. Tip from AUTODOC:
Make sure the engine cover is properly seated. It should not be displaced with respect to the guiding fasteners.When installing, do not use excessive force to avoid damage to the part.
Step 17

Remove the fender protection cover.

Step 18

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Fiesta Mk6 Hatchback (JA8, JR8) model.

Browse tyres

How to change water pump & timing belt kit on Ford Fiesta JA8 – replacement guide

Free download PDF
7.83 MB
How to change serpentine belt on Ford Fiesta JA8 – replacement guide

Free download PDF
1.16 MB
How to change EGR valve on FORD Fiesta Mk6 Hatchback (JA8, JR8) – replacement guide

Free download PDF
1.29 MB
How to change spark plugs on FORD Fiesta Mk6 Hatchback (JA8, JR8) – replacement guide

Free download PDF
1.49 MB
How to change front brake pads on Ford Fiesta JA8 – replacement guide

Free download PDF
1.61 MB
How to change front brake discs on Ford Fiesta JA8 – replacement guide

Free download PDF
1.88 MB

How to change ignition coil on FORD Fiesta Mk6 Van – replacement guide

Free download PDF
1 MB
How to change ignition coil on FORD Fiesta Mk5 Van – replacement guide

Free download PDF
1 MB
How to change ignition coil on a car – replacement tutorial

Universal

Free download PDF
1.98 MB
How to change ignition coil on Ford Mondeo Mk3 saloon – replacement guide

Free download PDF
1.25 MB
How to change ignition coil on FORD KA (RB_) – replacement guide

Free download PDF
1 MB
How to change ignition coil on FORD FUSION (JU_) – replacement guide

Free download PDF
1.01 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 tools that make car repair incredibly simple | AUTODOC tips

36K views

Published on: 25/01/2024
TOP 6 WD-40 lifehacks | AUTODOC tips

12K views

Published on: 15/07/2021
How to restore wheel rims | AUTODOC tips

6K views

Published on: 13/05/2021
Replacing your engine cooling fan | AUTODOC tips

2K views

Published on: 15/11/2020