How to change front brake pads on TOYOTA Corolla IX Hatchback (E120) – replacement guide
downloads:
6
Views:
65
0
Users voted – 0
Recommended replacement interval for the part category Brake pad set : 30000km
Important!
This replacement procedure can be used for:
TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_) 1.6 VVT-i (ZZE121_),
TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_) 1.8 VVTi (ZZE122_),
TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_) 1.8 4WD (ZZE124),
TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_) 1.8 (ZZE122_),
TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_) 1.5 RUNX VVT-i (NZE121_)
…
View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for COROLLA (ZZE12_, NDE12_, ZDE12_) and other TOYOTA models
Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.
Replacement: brake pads – TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_). Use the following procedure:
Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2
Secure the wheels with chocks.
Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 4
Raise the front of the car and secure on supports.
Step 5
Unscrew the wheel bolts.
Replacement: brake pads – TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_). Tip from AUTODOC:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6
Remove the wheel.
Step 7
Spread the brake pads. Use a crowbar.
Step 8
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 9
Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #17.
Step 10
Remove the brake caliper.
Replacement: brake pads – TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_). Tip:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your TOYOTA COROLLA (ZZE12_, NDE12_, ZDE12_)
View more
5 car tips for a winter's day | AUTODOC tips
Checking the starter without removing it | AUTODOC tips
5 most common causes of oil leaks | AUTODOC tips
Top 5 tips to prevent car rust | AUTODOC tips
Most commonly replaced car parts on TOYOTA COROLLA