Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
PEUGEOT 108 1.0 VTi, PEUGEOT 108 1.2, PEUGEOT 108 1.0 VTi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 108 and other PEUGEOT models

Alternative products

Brake pad set

Replacement: brake pads – PEUGEOT 108. List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Drive socket # 13 
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – PEUGEOT 108. AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – PEUGEOT 108. Take the following steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. PEUGEOT 108
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Spread the brake pads. Use a crowbar.
Step 9

Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
Step 10

Remove the brake caliper.

Replacement: brake pads – PEUGEOT 108. AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads.

Replacement: brake pads – PEUGEOT 108. Tip:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – PEUGEOT 108. After applying the spray, wait a few minutes.
Step 13

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 14

Install new brake pads.

Replacement: brake pads – PEUGEOT 108. Professionals recommend:
Make sure the pads are installed with linings facing the disc.
Step 15

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake pads – PEUGEOT 108. Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 16

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 17

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – PEUGEOT 108. AUTODOC experts recommend:
After applying the spray, wait a few minutes.
Step 20

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. PEUGEOT 108
Step 21

Screw in the wheel bolts. Use wheel impact socket #17.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 Nm torque.
Step 23

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – PEUGEOT 108. Check the brake fluid level in the reservoir and top up if necessary.
Step 24

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
PEUGEOT 108 – Without starting the engine, press the brake pedal several times until it feels firm.
Step 25

Close the hood.

Replacement: brake pads – PEUGEOT 108. AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 108 Hatchback model

PEUGEOT 108 tyre size

How to change front brake discs on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
1.94 MB
How to change serpentine belt on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
716.8 KB
How to change spark plugs on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
1.36 MB
How to change front windshield wipers on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
563.2 KB
How to change front anti roll bar links on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
1.78 MB
How to change engine oil and filter on PEUGEOT 108 Hatchback – replacement guide

Free download PDF
1.16 MB

How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on Peugeot 307 SW – replacement guide

Free download PDF
1.68 MB
How to change rear brake pads on Peugeot 207 hatchback – replacement guide

Free download PDF
2.56 MB
How to change front brake pads on Peugeot 208 1 – replacement guide

Free download PDF
2.11 MB
How to change rear brake pads on Peugeot 407 saloon – replacement guide

Free download PDF
1.48 MB
How to change rear brake pads on Peugeot 307 SW – replacement guide

Free download PDF
1.59 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Prevent Engine Damage: How to Identify Rocker Cover Gasket Issues and Proper Replacement | AUTODOC

5K views

Published on: 03/12/2020
Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights

7K views

Published on: 27/07/2023
Easy Steps to Fix Minor Scratches on Your Vehicle | AUTODOC tips

8K views

Published on: 12/05/2022
DIY car soundproofing | AUTODOC tips

104K views

Published on: 15/04/2021