Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
FIAT QUBO (225) 1.3 D Multijet (225AXG1A, 225CXG1A, 225AXG11, 225CXG11), FIAT QUBO (225) 1.3 D Multijet (225CXB1A, 225AXB1A, 225CXB11, 225AXB11,..., FIAT QUBO (225) 1.3 D Multijet (225AXE1A, 225CXE1A, 225AXH1A, 225AXL1A,... … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for QUBO (225) and other FIAT models

Alternative products

Brake pad set

Replacement: brake pads – FIAT QUBO (225). Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Drive socket # 13 
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Brake caliper wind back tool
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – FIAT QUBO (225). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – FIAT QUBO (225). Take the following steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – FIAT QUBO (225). Tip from AUTODOC:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
Step 9

Spread the brake pads. Use a crowbar.
Step 10

Remove the brake caliper.

Replacement: brake pads – FIAT QUBO (225). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 11

Remove the brake pads. Use a crowbar.

Replacement: brake pads – FIAT QUBO (225). Professionals recommend:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FIAT QUBO (225). After applying the spray, wait a few minutes.
Step 13

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake pads – FIAT QUBO (225). Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

Replacement: brake pads – FIAT QUBO (225). Tip:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 27 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 20

Install the wheel.

Replacement: brake pads – FIAT QUBO (225). AUTODOC experts recommend:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 21

Screw in the wheel bolts. Use wheel impact socket #17.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 98 Nm torque.

Replacement: brake pads – FIAT QUBO (225). Professionals recommend:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 23

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
FIAT QUBO (225) – Without starting the engine, press the brake pedal several times until it feels firm.
Step 24

Remove the jacks and chocks.

Replacement: brake pads – FIAT QUBO (225). Tip from AUTODOC experts:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the FIAT Qubo (225) model

Fiat Qubo tyre size

How to change front brake discs on FIAT QUBO (225) – replacement guide

Free download PDF
2.29 MB
How to change rear wheel bearing on FIAT QUBO (225) – replacement guide

Free download PDF
2.44 MB
How to change serpentine belt on FIAT Qubo (225) – replacement guide

Free download PDF
1.39 MB
How to change spark plugs on FIAT QUBO (225) – replacement guide

Free download PDF
1.46 MB
How to change front anti roll bar links on FIAT QUBO (225) – replacement guide

Free download PDF
1.7 MB
How to change engine oil and filter on FIAT QUBO (225) – replacement guide

Free download PDF
1.88 MB

How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on Fiat Panda 169 – replacement guide

Free download PDF
2.51 MB
How to change rear brake pads on Fiat 500 312 – replacement guide

Free download PDF
1.86 MB
How to change front brake pads on Fiat Punto 199 – replacement guide

Free download PDF
1.7 MB
How to change front brake pads on Fiat Doblo Cargo – replacement guide

Free download PDF
1.74 MB
How to change front brake pads on Fiat Punto 188 – replacement guide

Free download PDF
1.61 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Deep interior cleaning | Car transformation by detailing

7K views

Published on: 05/09/2024
Save Money on Fuel with These Easy Tips | AUTODOC

5K views

Published on: 27/09/2022
Why Is the Windscreen Washer Not Spraying? Solution

3K views

Published on: 25/04/2025
How to tighten cylinder head bolts

7K views

Published on: 06/03/2025