
Disclaimer
How to change front brake pads on FIAT DOBLO Platform/Chassis (263) – replacement guide
downloads:
0
Views:
15

Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
FIAT DOBLO Platform/Chassis (263) 1.3 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet (263YXD1B, 263XYR1B, 263YXX1B, 263HXD1B,..., FIAT DOBLO Platform/Chassis (263) 2.0 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.4, FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet (263HXE1B, 263HXS1B, 263HXY1B, 263YXE1B,..., FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.3 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.4, FIAT DOBLO Platform/Chassis (263) 1.4 Natural Power … View more
The steps may slightly vary depending on the car design.
FIAT DOBLO Platform/Chassis (263) 1.3 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet (263YXD1B, 263XYR1B, 263YXX1B, 263HXD1B,..., FIAT DOBLO Platform/Chassis (263) 2.0 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.4, FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet (263HXE1B, 263HXS1B, 263HXY1B, 263YXE1B,..., FIAT DOBLO Platform/Chassis (263) 1.6 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.3 D Multijet, FIAT DOBLO Platform/Chassis (263) 1.4, FIAT DOBLO Platform/Chassis (263) 1.4 Natural Power … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for DOBLO Platform/Chassis (263) and other FIAT models
Brake pad set
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Copper grease
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Crow bar
Wheel chock
Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). Professionals recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- All work should be done with the engine stopped.
Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). Take the following steps:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 4Raise the front of the car and secure on supports.Step 5Unscrew the wheel bolts.Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). Tip:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 6Remove the wheel.
- Step 7Disconnect the brake pad wear sensor plug.Please note!Some cars are not equipped with the brake pad wear sensor.
- Step 8Spread the brake pads. Use a crowbar.
- Step 9Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 10Unscrew the brake caliper fastening. Use a drive socket #13. Use a ratchet wrench.
- Step 11Remove the brake caliper.Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
- Step 12Remove the brake pads. Use a crowbar.Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). Tip from AUTODOC experts:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
- Step 13Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). After applying the spray, wait a few minutes.
- Step 14Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). Tip:Make sure the disc surface is clean before installing the pads.
- Step 15Install new brake pads.Replacement: brake pads – FIAT DOBLO Platform/Chassis (263). AUTODOC experts recommend:Make sure the pads are installed with linings facing the disc.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FIAT Doblo II Platform/Chassis (263) model
Popular maintenance tutorials for FIAT DOBLO Platform/Chassis (263)
Complete guides for changing the Brake pad set on different FIAT DOBLO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FIAT DOBLO Platform/Chassis (263)
View more
- Discover the 4 Key Reasons Your CHECK ENGINE Light Could Be On | AUTODOC Tips
- Understanding Airbag Light Warnings | Essential Tips for Car Safety
- Can You Hear Your Brakes Squeaking? Learn the Causes and DIY Solutions! | AUTODOC Tips
- Transform Your Car's Look: 6 Simple Accessories You Need to Try!
Most commonly replaced car parts on FIAT DOBLO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME