Replace the stabiliser links on Volvo V50 MW in pairs.
The replacement procedure is identical for both stabiliser links on the same axle.
All work should be done with the engine stopped.
Replacement: anti roll bar links – Volvo V50 MW. Recommended sequence of steps:
Step 1
Secure the wheels with chocks.
Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 3
Raise the front of the car and secure on supports.
Step 4
Unscrew the wheel bolts.
AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. Volvo V50 MW
Step 5
Remove the wheel.
Step 6
Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 7
Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #15. Use a combination spanner #17.
Step 8
Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 9
Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use a drive socket #15. Use a ratchet wrench.
Step 10
Remove the stabilizer rod.
Replacement: anti roll bar links – Volvo V50 MW. AUTODOC recommends:
Examine stabiliser bushes. Replace them if needed.
Step 11
Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray.
Step 12
Install a new rod, tighten the fasteners.
Step 13
Tighten the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #15. Use a combination spanner #17. Use a torque wrench. Tighten it to 70 Nm torque.
Step 14
Tighten the fastener connecting the stabilizer link to the shock strut. Use a drive socket #15. Use a torque wrench. Tighten it to 60 Nm torque.
Step 15
Treat all joints of the stabiliser link. Use copper grease.
Step 16
Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 17
Clean the brake disk surface. Use a brake cleaner.
AUTODOC recommends:
Replacement: anti roll bar links – Volvo V50 MW. After applying the spray, wait a few minutes.
Step 18
Install the wheel.
AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. Volvo V50 MW
Step 19
Screw in the wheel bolts. Use wheel impact socket #19.
Step 20
Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 110 nm torque.
Step 21
Remove the jacks and chocks.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?
Find out which tyre and wheel sizes are compatible with the VOLVO V50 (MW, 545) model.
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your VOLVO V50 (545)
View more
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!
How to Order Car Parts Online: Avoid These 5 Common Pitfalls
How to replace a timing chain yourself
5 possible reasons why your car heater isn't working