
Disclaimer
How to change engine oil and filter on HONDA Accord IX Coupe – replacement guide
downloads:
1
Views:
5

Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
HONDA ACCORD IX Coupe 2.4 … View more
The steps may slightly vary depending on the car design.
HONDA ACCORD IX Coupe 2.4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for ACCORD IX Coupe and other HONDA models
Oil filter
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 17
Oil filter cup socket 65/14-F
Ratchet wrench
Funnel
Oil drain pan
Replacement: engine oil and filter – HONDA ACCORD IX Coupe. AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Use only new O-rings during installation.
- Please note: all work on the car – HONDA ACCORD IX Coupe – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – HONDA ACCORD IX Coupe. AUTODOC experts recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Unscrew the oil filler plug.Step 2Put a waste oil container with at least 4 l capacity under the drainage hole.
- Step 3Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
- Step 4Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
- Step 5Drain the used oil.AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
- Step 6Clean the area of the oil pan drainage hole.
- Step 7Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 39 nm torque.
- Step 8Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
- Step 9Unscrew the oil filter. Use the 65/14-F socket. Use a ratchet wrench.
- Step 10Put the old oil filter in the container.Step 11Clean the oil filter seat. Use all-purpose cleaning spray.
- Step 12Screw the new filter into its place. Use the 65/14-F socket. Observe the recommended tightening torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the HONDA Accord IX Coupe model
Popular maintenance tutorials for HONDA ACCORD IX Coupe
Complete guides for changing the Oil filters on different HONDA ACCORD models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your HONDA ACCORD IX Coupe
View more
- How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
- How to Use Sandblasting Equipment: Step-by-Step Guide | AUTODOC Tips
- How I started restoring a driveshaft | Drivetrain restoration – Part 1
- How to inspect and troubleshoot your car heater when it’s not working
Most commonly replaced car parts on HONDA ACCORD
Time to replace parts? Get even better deals in our Shop app.

SCAN ME