When to replace the Oil Filter on your FORD SIERRA
Recommended replacement interval for the part category Oil filter : 1 year / 15000 km
Important!
This replacement procedure can be used for:
FORD SIERRA (GBG, GB4) 1.8, FORD SIERRA (GBG, GB4) 1.6 i View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for SIERRA (GBG, GB4) and other FORD models
Tools
Replacement: engine oil and filter – FORD SIERRA (GBG, GB4). Tools you might need:
All-purpose cleaning spray
Oil filter cup socket 76-30F
Impact socket №10
Impact socket №13
Ratchet wrench
Torque wrench
Flat screwdriver
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – FORD SIERRA (GBG, GB4). Tip from AUTODOC:
  • Replace the oil filter every time when changing motor oil.
  • All work should be done with the engine stopped.
  • Wear gloves to prevent contact with hot liquid.
Replacement: engine oil and filter – FORD SIERRA (GBG, GB4). Use the following procedure:
  1. Step 1
    Open the hood.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Oil Filter on Ford Sierra Saloon 1987 - free PDF and video manuals
    Unscrew the oil filler plug.
  2. Step 4
    Lift the car using a jack or place it over an inspection pit.
    AUTODOC recommends:
    The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
    Step 5
    How to replace FORD SIERRA (GBG, GB4) 2.0 i 1988 Oil Filter - step-by-step manuals and video guides
    Undo the fasteners of the oil pan lower cover.
  3. Step 6
    Ford Sierra Saloon 2.0 i DOHC 1989 Oil Filter replacement: free workshop manuals
    Remove the oil pan cover. Use a drive socket #10. Use a flat screwdriver. Use a ratchet wrench.
  4. Step 7
    Changing Oil Filter on FORD SIERRA (GBG, GB4) 2.0 RS Cosworth 1990 by yourself
    Put a waste oil container with at least 4 l capacity under the drainage hole.
  5. Step 8.1
    How to remove FORD SIERRA 2.0 16V Cosworth 4x4 (N5C) 1991 Oil Filter - online easy-to-follow instructions
    Unscrew the drain plug. Use a drive socket #13. Use a ratchet wrench.
    Step 8.2
    How to replace Oil Filter on FORD SIERRA (GBG, GB4) 1992: download PDF manuals and video instructions
    Drain the used oil.
    Replacement: engine oil and filter – FORD SIERRA (GBG, GB4). Tip:
    Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
  6. Step 9
    How hard is it to do yourself: Oil Filter replacement on Ford Sierra Saloon 2.0 i Cat 1993 - download illustrated guide
    Move the container under the oil filter.
  7. Step 10
    Need to know how to renew Oil Filter on FORD SIERRA 1987? This free workshop manual will help you to do it yourself
    Unscrew the oil filter.
  8. Step 11
    Changing of Oil Filter on Ford Sierra Saloon 1988 won't be an issue if you follow this illustrated step-by-step guide
    Prepare a container for the old oil filter. Put the old oil filter in the container.
    Replacement: engine oil and filter – FORD SIERRA (GBG, GB4). Tip from AUTODOC experts:
    Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
  9. Step 12
    FORD SIERRA 2.0 i DOHC Oil Filter replacement: online guides and video tutorials
    Clean the oil filter seat. Use all-purpose cleaning spray.
  10. Step 13
    Replacing Oil Filter on Ford Sierra Saloon 1990 2.0 i by yourself
    Lubricate the rubber seal of the new filter with a little amount of fresh oil.
  11. Step 14
    SIERRA (GBG, GB4) 2.0 16V Cosworth 4x4 (N5C) 1991 Oil Filter DIY replacement workshop manual
    Screw the new filter into its place. Use the 76-30F socket. Use a torque wrench. Tighten it to 18 nm torque.
  12. Step 15
    How to change Oil Filter on FORD SIERRA (GBG, GB4) 1992 - tips and tricks
    Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
FORD SIERRA (GBG, GB4) Oil Filter replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY FORD SIERRA (GBG, GB4) Oil Filter replacement - online guide
Tips & tricks for your FORD SIERRA (GBG, GB4)
View more
  • How to change Oil filters on FORD SIERRA (GBG, GB4) 2.0 - replacement tricks
    How to repair a bumper yourself | AUTODOC tips
  • Changing Engine oil filter Ford Sierra Saloon 2.0 i - Replacement Tips
    TOP 5 mistakes when replacing shock absorbers | AUTODOC tips
  • Maintenance Hacks - FORD SIERRA (GBG, GB4) 2.0 i DOHC Oil filters replacement guide
    DIY brake caliper restoration | AUTODOC tips
  • Replace Engine oil filter on Ford Sierra Saloon - free video tips
    Top 5 brake repair mistakes | AUTODOC tips