Recommended replacement interval for the part category Breather Screw / Valve, wheel brake cylinder : 60000 km

Important!

This replacement procedure can be used for:
VW Lupo (6X1, 6E1) 1.4 TDI … View more

The steps may slightly vary depending on the car design.

How to change rear brake cylinder VW LUPO TUTORIAL | AUTODOC

All the parts you need to replace – Wheel Cylinder for Lupo (6X1, 6E1) and other VW models

Breather Screw / Valve, wheel brake cylinder

Wheel Brake Cylinder

VW Lupo (6X1, 6E1) 1.4 TDI

Replacement: wheel cylinder – VW Lupo 6X1. Tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Combination spanner #7
                      
                        Combination spanner #11
                      
                        Torx bit T30
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Flat Screwdriver
                      
                        Phillips screwdriver
                      
                        Wheel chock

Buy tools

Replacement: wheel cylinder – VW Lupo 6X1. Tip from AUTODOC:

Replace the wheel brake cylinders of the rear drum brakes in pairs.
The replacement procedure is identical for the right and left wheel brake cylinders of the rear drum brakes.
All work should be done with the engine stopped.

Replacement: wheel cylinder – VW Lupo 6X1. Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts.Use wheel impact socket #17.
Step 3

Raise the rear of the car and secure on supports.
Step 4

Unscrew the wheel bolts.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW Lupo 6X1
Step 5

Remove the wheel.
Step 6

Clean the brake drum fasteners.Use a wire brush.Use WD-40 spray.

Step 7

Unscrew the brake drum fastening.Use a Phillips screwdriver.
Step 8

Remove the brake drum.

Replacement: wheel cylinder – VW Lupo 6X1. Tip from AUTODOC experts:

Examine the brake drum. Replace it if necessary.
Step 9

Disconnect the hydraulic line from the wheel cylinder back.Use a combination spanner #11.

Replacement: wheel cylinder – VW Lupo 6X1. Tip from AUTODOC:

Immediately plug the brake line open end to prevent fluid leakage and ingress of dirt into the hydraulic system.
Step 10

Unscrew the brake cylinder fastening bolt.Use Torx T30.Use a ratchet wrench.
Step 11

Remove the brake cylinder from the backplate.Use a flat screwdriver.
Step 12

Clean the brake drum.Use a wire brush.Use WD-40 spray.

Step 13

Clean the brake pipe attachment spot and the brake drum fastening bolts on VW Lupo 6X1.

Step 14

Install a new brake cylinder.
Step 15

Screw the brake cylinder fastening bolts.Use Torx T30.Use a torque wrench.Tighten it to 21 nm torque.
Step 16

Connect the hydraulic line to the wheel cylinder back.Use a combination spanner #11.Use a torque wrench.Tighten it to 15 nm torque.
Step 17

Bleed the brake cylinder system.Use a combination spanner #7.

Replacement: wheel cylinder – VW Lupo 6X1. Professionals recommend:

Make sure to set the protection cap on the bleeder valve.
Step 18

Clean the hub.Use a wire brush.Treat the contacting surface.Use copper grease.
Step 19

Install a brake drum.
Step 20

Tigten the brake drum fasteners.Use a Phillips screwdriver.Use a torque wrench.Tighten it to 17 Nm torque.
Step 21

Clean the wheel rim mounting seat. Use a wire brush.

Step 22

Treat the surface where the wheel rim contacts the brake drum.Use copper grease.
Step 23

Install the wheel.

AUTODOC recommends:

Important! Hold the wheel while screwing in the fastening bolts. VW Lupo 6X1
Step 24

Screw in the wheel bolts.Use wheel impact socket #17.
Step 25

Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #17.Use a torque wrench.Tighten it to 120 nm torque.
Step 26

Remove the jacks and chocks.

AUTODOC recommends:

Bleed the brake system after replacing the cylinder on VW Lupo 6X1.Check the brake fluid level in the expansion tank and refill if necessary.Perform test braking when driving at an average speed, the VW Lupo 6X1 should not pull to one side.
Step 27

Adjust the gap between the brake shoes and the drum on VW Lupo 6X1, pressing the brake pedal 10-15 times.

Comment

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to replace the front brake pads of disc brake on VOLKSWAGEN LUPO

Free download PDF

1.19 MB
How to replace the front brake disc on VOLKSWAGEN LUPO

Free download PDF

1.19 MB
How to change rear brake shoes on VW Lupo 6X1 – replacement guide

Free download PDF

10.08 MB
How to change brake drum on VW Lupo 6X1 – replacement guide

Free download PDF

5.39 MB
How to replace the front hub bearing on VOLKSWAGEN LUPO

Free download PDF

2.03 MB
How to replace the tie rod end on VOLKSWAGEN LUPO

Free download PDF

1.11 MB
How to change rear wheel bearing on VW Lupo 6X1 – replacement guide

Free download PDF

6.44 MB
How to change engine oil and filter on VW Lupo 6X1 diesel – replacement guide

Free download PDF

6.92 MB
How to change front coil springs on VW Lupo 6X1 – replacement guide

Free download PDF

9.77 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your VW Lupo (6X1, 6E1)

TOP 4 car cleaning products | AUTODOC

2K views

Published on: 26/08/2021
How to swap the engine on a BMW E30 Turbo | SUPERCAR AUTODOC

2K views

Published on: 02/03/2021
Causes of a worn car boot damper | AUTODOC

1K views

Published on: 04/07/2021
Why does my power window move slowly? | AUTODOC tips

5K views

Published on: 08/07/2021