Important!

This replacement procedure can be used for:
VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.9 SDI, VW POLO (9N_) 1.2, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.4 FSI, VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.8 GTI, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.6 16V, VW POLO (9N_) 1.6, VW POLO (9N_) 1.8 GTi Cup Edition, VW POLO (9N_) 1.2, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.4, VW POLO (9N_) 2.0 … View more

The steps may slightly vary depending on the car design.

How to change strut mount on VW POLO 4 [TUTORIAL AUTODOC]

Alternative products

Top strut mount

Replacement: strut mount – VW Polo 9N. Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #16
                    
                      Drive socket # 16 
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Hydraulic transmission jack
                    
                      Wheel chock

Buy tools

Replacement: strut mount – VW Polo 9N. Tip from AUTODOC experts:

The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
Both mounts of the rear shock struts should be replaced simultaneously.
Be sure to replace all self-locking nuts and bolts during installation.
All work should be done with the engine stopped.

Replacement: strut mount – VW Polo 9N. Use the following procedure:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the rear of the car and secure on supports.
Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. VW Polo 9N
Step 5

Remove the wheel.
Step 6

Support the rear suspension beam. Use a hydraulic transmission jack.
Step 7

Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Step 9

Remove the fastening bolt.

Step 10

Detach the lower part of the shock absorber. Use a crowbar.
Step 11

Unscrew the upper fastener of the shock absorber. Use a drive socket #16. Use a ratchet wrench.

AUTODOC recommends:
Important! Hold the shock absorber while unscrewing the fastening bolts. VW Polo 9N
Step 12

Remove the shock absorber.
Step 13

Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.

Step 14

Remove the shock absorber piston rod fastening. Use a drive socket #16. Use a ratchet wrench.
Step 15

Remove the top strut mount.

Replacement: strut mount – VW Polo 9N. AUTODOC recommends:
Examine the shock absorber dust cap and the bump stop. Replace them if necessary.
Step 16

Install a new strut mount.
Step 17

Screw the shock strut piston rod upper fastening. Use a drive socket #16. Use a torque wrench. Tighten it to 25 nm torque.
Step 18

Treat the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.

Step 19

Place the shock absorber in the wheel arch and secure it.

AUTODOC recommends:
Important! Hold the shock absorber while screwing in the fastening bolts. VW Polo 9N
Step 20

Tighten the top shock absorber fastening. Use a drive socket #16. Use a torque wrench. Tighten it to 30 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 21

Attach the lower part of the shock absorber.

Step 22

Install the fastening bolt.

Step 23

Tighten the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 40 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 24

Remove the mounting from under the rear axle beam.

AUTODOC recommends:
Replacement: strut mount – VW Polo 9N. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 25

Treat the shock absorber fasteners. Use copper grease.
Step 26

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 27

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: strut mount – VW Polo 9N. After applying the spray, wait a few minutes.
Step 28

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VW Polo 9N
Step 29

Screw in the wheel bolts. Use wheel impact socket #17.
Step 30

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 nm torque.
Step 31

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VW Polo IV Hatchback (9N) model

VW Polo Mk4 tyre size

How to change front lower arm on VW Polo 9N – replacement guide

Free download PDF
2.45 MB
How to change track rod end on VW Polo 9N – replacement guide

Free download PDF
2.23 MB
How to change front anti roll bar links on VW Polo 9N – replacement guide

Free download PDF
1.99 MB
How to change front strut mount on VW Polo 9N – replacement guide

Free download PDF
2.08 MB
How to change rear wheel bearing on VW Polo 9N – replacement guide

Free download PDF
1.41 MB
How to change front anti roll bar bushes on VW POLO (9N_) – replacement guide

Free download PDF
1.64 MB

How to change front strut mount on VW Polo Hatchback (6R1, 6C1) – replacement guide

Free download PDF
2.8 MB
How to change rear strut mount on VW Polo Hatchback (6R1, 6C1) – replacement guide

Free download PDF
1.97 MB
How to change front strut mount on VW Polo 9N – replacement guide

Free download PDF
2.08 MB
How to change front strut mount on VW POLO (6N2) – replacement guide

Free download PDF
3.31 MB
How to change rear strut mount on VW POLO (AW1, BZ1) – replacement guide

Free download PDF
2.65 MB
How to change front strut mount on VW POLO (AW1, BZ1) – replacement guide

Free download PDF
3.41 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top 5 Car Interior Cleaning Mistakes You Should Avoid | AUTODOC Tips

7K views

Published on: 26/05/2022
Discover the 4 Key Reasons Your CHECK ENGINE Light Could Be On | AUTODOC Tips

7K views

Published on: 30/03/2022
How to Safely Wash Your Car in Winter Without Damage | AUTODOC tips

3K views

Published on: 31/01/2024
Why Checking Your Oil is Crucial for Engine Performance

6K views

Published on: 23/02/2023