Disclaimer
How to change rear shock absorbers on Citroën Berlingo M – replacement guide
downloads:
4
Views:
107
Important!
This replacement procedure can be used for:
CITROËN Berlingo / Berlingo First Van (M_) 1.1 i (MAHDZ, MBHDZ, MBHFX), CITROËN Berlingo / Berlingo First Van (M_) 1.4 i (MBKFX, MBKFW), CITROËN Berlingo / Berlingo First Van (M_) 1.8 D (MBA9A, MCA9A), CITROËN Berlingo / Berlingo First Van (M_) 1.9 D 70 (MBWJZ, MCWJZ), CITROËN Berlingo / Berlingo First Van (M_) 1.9 D 70 4WD (MBWJZ, MCWJZ), CITROËN Berlingo / Berlingo First Van (M_) 2.0 HDI, CITROËN Berlingo / Berlingo First Van (M_) 1.4 i bivalent (MBKFW), CITROËN Berlingo / Berlingo First Van (M_) 1.4 bivalent, CITROËN Berlingo / Berlingo First Van (M_) 1.8 i, CITROËN Berlingo / Berlingo First Van (M_) 2.0 HDI 4WD, CITROËN Berlingo / Berlingo First Van (M_) 1.6 16V (MBNFU), CITROËN Berlingo / Berlingo First Van (M_) 1.6 HDI, CITROËN Berlingo / Berlingo First Van (M_) Electric, CITROËN Berlingo / Berlingo First Van (M_) 1.6 HDI, CITROËN Berlingo / Berlingo First Van (M_) 1.9 D (MBDJY) … View more
The steps may slightly vary depending on the car design.
CITROËN Berlingo / Berlingo First Van (M_) 1.1 i (MAHDZ, MBHDZ, MBHFX), CITROËN Berlingo / Berlingo First Van (M_) 1.4 i (MBKFX, MBKFW), CITROËN Berlingo / Berlingo First Van (M_) 1.8 D (MBA9A, MCA9A), CITROËN Berlingo / Berlingo First Van (M_) 1.9 D 70 (MBWJZ, MCWJZ), CITROËN Berlingo / Berlingo First Van (M_) 1.9 D 70 4WD (MBWJZ, MCWJZ), CITROËN Berlingo / Berlingo First Van (M_) 2.0 HDI, CITROËN Berlingo / Berlingo First Van (M_) 1.4 i bivalent (MBKFW), CITROËN Berlingo / Berlingo First Van (M_) 1.4 bivalent, CITROËN Berlingo / Berlingo First Van (M_) 1.8 i, CITROËN Berlingo / Berlingo First Van (M_) 2.0 HDI 4WD, CITROËN Berlingo / Berlingo First Van (M_) 1.6 16V (MBNFU), CITROËN Berlingo / Berlingo First Van (M_) 1.6 HDI, CITROËN Berlingo / Berlingo First Van (M_) Electric, CITROËN Berlingo / Berlingo First Van (M_) 1.6 HDI, CITROËN Berlingo / Berlingo First Van (M_) 1.9 D (MBDJY) … View more
The steps may slightly vary depending on the car design.
How to change rear shock absorber on CITROËN BERLINGO M [TUTORIAL AUTODOC]

All the parts you need to replace – Shock Absorber for Berlingo / Berlingo First Van (M_) and other CITROËN models
Alternative products

Wire brush
WD-40 spray
Ceramic grease
Copper grease
Torque wrench
Combination spanner #24
Drive socket # 24
Wheel impact socket #19
Ratchet wrench
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – Citroën Berlingo M. Tip from AUTODOC:
- Both shock absorbers of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
- Please note: all work on the car – Citroën Berlingo M – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 3
Raise the car.Replacement: shock absorbers – Citroën Berlingo M. Professionals recommend:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands. - Step 4
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Citroën Berlingo M - Step 5
Remove the wheel. - Step 6
Support the rear suspension beam. Use a hydraulic transmission jack. - Step 7
Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the upper fastener of the shock absorber. Use a drive socket #24. Use a ratchet wrench. - Step 9
Unscrew the lower fastener of the shock absorber. Use a combination spanner #24. Use a drive socket #24. Use a ratchet wrench. - Step 10
Remove the fastening bolt. - Step 11
Remove the shock absorber. - Step 12
Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray. - Step 13
Treat the shock absorber mounting seats. Use copper grease. - Step 14
Place the shock absorber in the wheel arch and fasten it.Replacement: shock absorbers – Citroën Berlingo M. Tip from AUTODOC:Before installing a new shock absorber you should pump it manually 3-5 times.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the CITROËN Berlingo / Berlingo First I Van (M) model
Popular maintenance tutorials for Citroën Berlingo M
Complete guides for changing the Shock absorbers on different CITROËN BERLINGO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your CITROËN Berlingo / Berlingo First Van (M_)
View more
3 essential tips for choosing summer tyres | Get ready for warmer weather
Don’t Replace, Just Polish! Headlight Restoration with AUTODOC
Top 5 reasons why your car squeals | AUTODOC Tips
DIY alternator repair | AUTODOC tips
Most commonly replaced car parts on CITROËN BERLINGO
ОЕ number
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



























