Important!

This replacement procedure can be used for:
SEAT Toledo III (5P2) 1.6, SEAT Toledo III (5P2) 2.0 FSI, SEAT Toledo III (5P2) 1.9 TDI, SEAT Toledo III (5P2) 2.0 TDI 16V, SEAT Toledo III (5P2) 1.8 TFSI, SEAT Toledo III (5P2) 2.0 TDI, SEAT Toledo III (5P2) 2.0 TFSI, SEAT Toledo III (5P2) 2.0 TDI, SEAT Toledo III (5P2) 2.0 TDI, SEAT Toledo III (5P2) 1.4 16V, SEAT Toledo III (5P2) 1.4 TSI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Springs for Toledo III (5P2) and other SEAT models

Coil spring

        Coil spring for Toledo III (5P2) Petrol (102 hp)
      
        Coil spring for Toledo III (5P2) Petrol (150 hp)
      
        Coil spring for Toledo III (5P2) Diesel (105 hp)
      
        Coil spring for Toledo III (5P2) Diesel (140 hp)
      
        Coil spring for Toledo III (5P2) Petrol (160 hp)
      
        Coil spring for Toledo III (5P2) Diesel (170 hp)
      
        Coil spring for Toledo III (5P2) Petrol (200 hp)
      
        Coil spring for Toledo III (5P2) Diesel (140 hp)
      
        Coil spring for Toledo III (5P2) Diesel (136 hp)

Replacement: coil springs – SEAT TOLEDO III (5P2). List of the tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner
                      
                        Copper grease
                      
                        Combination spanner #18
                      
                        Drive socket # 18
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Crow bar
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: coil springs – SEAT TOLEDO III (5P2). AUTODOC recommends:

Both coil springs of the rear suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right coil springs of the rear suspension.
All work should be done with the engine stopped.

Replacement: coil springs – SEAT TOLEDO III (5P2). Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the rear of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: coil springs – SEAT TOLEDO III (5P2). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 7

Make a mark on the camber adjustment bolt.
Step 8

Unscrew the arm fastening to the beam. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
Step 9

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 10

Unscrew the fastener connecting the control arm to the rear knuckle. Use a combination spanner #18 (2 pieces).
Step 11

Support the arm. Use a hydraulic transmission jack.
Step 12

Remove the fastening bolt. Use a combination spanner #18. Use a crowbar.
Step 13

Remove the support from under the arm. Use a crowbar.

AUTODOC recommends:
Replacement: coil springs – SEAT TOLEDO III (5P2). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 14

Pull down the suspension control arm. Take out the spring.
Step 15

Remove the rubber spring spacer.
Step 16

Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray.
Step 17

Install the rubber spacer on the new coil spring.
Step 18

Install the coil spring together with the rubber mounts into the mounting seats.
Step 19

Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
Step 20

Support the arm. Use a hydraulic transmission jack. Use a crowbar.
Step 21

Install the fastening bolt.
Step 22

Adjust the position of the alignment bolt according to the mark.
Step 23

Screw in the fastener connecting the control arm to the subframe. Use a drive socket #18. Use a ratchet wrench.
Step 24

Remove the support from under the arm.

Replacement: coil springs – SEAT TOLEDO III (5P2). AUTODOC experts recommend:
Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
Step 25

Screw in the fastener connecting the control arm to the subframe. Use a combination spanner #18 (2 pieces).
Step 26

Support the arm. Use a hydraulic transmission jack.
Step 27

Screw in the fastener that connects the control arm to the rear knuckle. Use a combination spanner #18 (2 pieces).

Step 28

Tighten the fastener connecting the suspension arm to the rear knuckle. Use a combination spanner #18. Use a drive socket #18. Use a torque wrench. Tighten it to 90 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 29

Tighten the arm fastening to the beam. Use a combination spanner #18. Use a drive socket #18. Use a torque wrench. Tighten it to 95 nm torque.
Step 30

Remove the support from under the arm.

AUTODOC recommends:
SEAT TOLEDO III (5P2) – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car.
Step 31

Treat the shock absorber fasteners. Treat all joints of the arm. Use copper grease.
Step 32

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 33

Clean the brake disk surface. Use a brake cleaner.

Replacement: coil springs – SEAT TOLEDO III (5P2). Professionals recommend:
After applying the spray, wait a few minutes.
Step 34

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. SEAT TOLEDO III (5P2)
Step 35

Screw in the wheel bolts. Use wheel impact socket #17.
Step 36

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 Nm torque.
Step 37

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Toledo III (5P2) model.

Browse tyres

How to change rear shock absorbers on SEAT Toledo III (5P2) – replacement guide

Free download PDF
1.92 MB
How to change front suspension strut on SEAT Toledo III (5P2) – replacement guide

Free download PDF
3.88 MB
How to change front coil springs on SEAT Toledo III (5P2) – replacement guide

Free download PDF
3.82 MB
How to change front brake pads on SEAT Toledo III (5P2) – replacement guide

Free download PDF
1.63 MB
How to change rear brake pads on SEAT Toledo III (5P2) – replacement guide

Free download PDF
1.37 MB
How to change rear brake discs on SEAT Toledo III (5P2) – replacement guide

Free download PDF
2 MB

How to change front coil springs on SEAT Toledo IV Hatchback (KG3) – replacement guide

Free download PDF
3.74 MB
How to change rear coil springs on SEAT Toledo IV Hatchback (KG3) – replacement guide

Free download PDF
2.06 MB
How to change rear coil springs on SEAT Toledo II Saloon (1M2) – replacement guide

Free download PDF
2.06 MB
How to change front coil springs on SEAT Toledo III (5P2) – replacement guide

Free download PDF
3.82 MB
How to change front coil springs on SEAT TOLEDO I (1L) – replacement guide

Free download PDF
2.17 MB
How to change coil springs on a car – replacement tutorial

Universal

Free download PDF
1.91 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

TOP 5 mistakes during DIY oil change | AUTODOC tips

34K views

Published on: 17/06/2021
How to remove scratches from car plastic | AUTODOC tips

101K views

Published on: 15/12/2022
Petrol or diesel? What's the difference between these engines? | AUTODOC

4K views

Published on: 04/05/2021
How to replace the suspension on a BMW E30 Turbo | SUPERCAR AUTODOC

1K views

Published on: 04/03/2021