How to carry out replacement: Springs 1.6 TDI Seat Toledo 4
Disclaimer
Change Seat Toledo 4 1.4 TSI Springs yourself – manuals and video tutorials

How to change rear coil springs on SEAT Toledo IV Hatchback (KG3) – replacement guide

downloads: 1
Views: 17
Download your free tutorial and fix SEAT Toledo IV Hatchback (KG3) 1.2 TSI problems yourself Download for free 2.06 MB Springs for Seat Toledo 4 Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
SEAT Toledo IV Hatchback (KG3) 1.2, SEAT Toledo IV Hatchback (KG3) 1.2 TSI, SEAT Toledo IV Hatchback (KG3) 1.2 TSI, SEAT Toledo IV Hatchback (KG3) 1.4 TSI, SEAT Toledo IV Hatchback (KG3) 1.6 TDI, SEAT Toledo IV Hatchback (KG3) 1.6, SEAT Toledo IV Hatchback (KG3) 1.6 TDI, SEAT Toledo IV Hatchback (KG3) 1.2 TSI, SEAT Toledo IV Hatchback (KG3) 1.2 TSI, SEAT Toledo IV Hatchback (KG3) 1.4 TSI, SEAT Toledo IV Hatchback (KG3) 1.4 TDI, SEAT Toledo IV Hatchback (KG3) 1.6 TDI, SEAT Toledo IV Hatchback (KG3) 1.6, SEAT Toledo IV Hatchback (KG3) 1.0 TSI, SEAT Toledo IV Hatchback (KG3) 1.0 TSI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Springs for Toledo IV Hatchback (KG3) and other SEAT models
Alternative products
How to change Coil spring on Seat Toledo 4 1.6 TDI – step-by-step instructions for straightforward car repair Coil spring
Tools
Replacement: coil springs – SEAT TOLEDO IV (KG3). List of the tools you'll need:
Wire brush
WD-40 spray
Copper grease
Combination spanner #16
Drive socket # 16
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Buy tools
Replacement: coil springs – SEAT TOLEDO IV (KG3). Tip from AUTODOC experts:
  • Both coil springs of the rear suspension should be replaced simultaneously.
  • The replacement procedure is identical for the left and right coil springs of the rear suspension.
  • All work should be done with the engine stopped.
Replacement: coil springs – SEAT TOLEDO IV (KG3). Take the following steps:
  1. Step 1
    How to change Springs on Seat Toledo 4 2012 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace SEAT Toledo IV Hatchback (KG3) 1.6 TDI 2013 Springs - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    Seat Toledo 4 1.6 (CFNA) 2014 Springs replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: coil springs – SEAT TOLEDO IV (KG3). Tip:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Springs on SEAT Toledo IV Hatchback (KG3) 1.4 TSI 2015 by yourself
    Remove the wheel.
  5. Step 6
    How to remove SEAT TOLEDO 1.4 TDI 2016 Springs - online easy-to-follow instructions
    Disconnect the ABS sensor wiring. Use a crowbar.
  6. Step 7
    How to replace Springs on SEAT Toledo IV Hatchback (KG3) 2017: download PDF manuals and video instructions
    Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
  7. Step 8
    How hard is it to do yourself: Springs replacement on Seat Toledo 4 1.6 (CFNA) 2018 - download illustrated guide
    Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a tap wrench.
  8. Step 9
    Need to know how to renew Springs on SEAT TOLEDO 2019? This free workshop manual will help you to do it yourself
    Support the rear suspension beam. Use a hydraulic transmission jack.
  9. Step 10
    Changing of Springs on Seat Toledo 4 2012 won't be an issue if you follow this illustrated step-by-step guide
    Remove the fastening bolt. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
  10. Step 11
    SEAT TOLEDO 1.4 TSI Springs replacement: online guides and video tutorials
    Remove the mounting from under the rear axle beam.
    AUTODOC recommends:
    Replacement: coil springs – SEAT TOLEDO IV (KG3). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
  11. Step 12
    Support the rear suspension beam. Use a hydraulic transmission jack.
    Step 13
    Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a tap wrench.
    Step 14
    Replacing Springs on Seat Toledo 4 2014 1.6 TDI by yourself
    Remove the fastening bolt. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
  12. Step 15
    Toledo IV Hatchback (KG3) 1.4 TDI 2015 Springs DIY replacement workshop manual
    Remove the mounting from under the rear axle beam.
    AUTODOC recommends:
    SEAT TOLEDO IV (KG3) – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car.
  13. Step 16
    How to change Springs on SEAT Toledo IV Hatchback (KG3) 2016 - tips and tricks
    Take out the spring.
    Replacement: coil springs – SEAT TOLEDO IV (KG3). AUTODOC recommends:
    Inspect the rubber mounts of the suspension spring. Replace if necessary.
  14. Step 17
    Step-by-step recommendations for DIY replacement Seat Toledo 4 2017 1.4 TDI Springs
    Remove the rubber spring spacer.
  15. Step 18
    DIY replacement of Springs on SEAT Toledo IV Hatchback (KG3) 1.2 TSI 2018 is not an issue anymore with our step-by-step tutorial
    Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray.
  16. Step 19
    How to change Springs on Seat Toledo 4 2012 - free PDF and video manuals
    Install the rubber spacer on the new coil spring.
  17. Step 20
    How to replace SEAT Toledo IV Hatchback (KG3) 1.6 TDI 2013 Springs - step-by-step manuals and video guides
    Install the coil spring together with the rubber mounts into the mounting seats.
  18. Step 21
    Support the rear suspension beam. Use a hydraulic transmission jack.
    Step 22
    Seat Toledo 4 1.6 (CFNA) 2014 Springs replacement: free workshop manuals
    Install the fastening bolt.
  19. Step 23
    Changing Springs on SEAT Toledo IV Hatchback (KG3) 1.4 TSI 2015 by yourself
    Screw in the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Toledo IV Hatchback (KG3) model

Seat Toledo 4 tyre size

Popular maintenance tutorials for Seat Toledo 4

More manuals for Seat Toledo 4

Complete guides for changing the Springs on different SEAT TOLEDO models

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY SEAT Toledo IV Hatchback (KG3) Springs replacement - online guide
Tips & tricks for your SEAT Toledo IV Hatchback (KG3)
View more
  • How to change Springs on SEAT Toledo IV Hatchback (KG3) 1.2 TSI - replacement tricks
    The Fast and Easy Way to Fix a Broken Wheel Stud | AUTODOC tips
    9K views
    Published on: 08/12/2020
  • Changing Coil springs Seat Toledo 4 1.6 TDI - Replacement Tips
    Top 5 car noises you shouldn't ignore
    7K views
    Published on: 10/04/2025
  • Maintenance Hacks - SEAT Toledo IV Hatchback (KG3) 1.6 (CFNA) Spring replacement guide
    Save Money on Fuel with These Easy Tips | AUTODOC
    5K views
    Published on: 27/09/2022
  • Replace Suspension spring on Seat Toledo 4 - free video tips
    5 possible reasons why your car heater isn't working
    7K views
    Published on: 21/11/2024

Most commonly replaced car parts on SEAT TOLEDO

Professional manuals for the most common SEAT models

ОЕ number
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
SEAT Toledo IV Hatchback (KG3) Springs replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME