Disclaimer
How to change rear coil springs on RENAULT MEGANE II (BM0/1_, CM0/1_) – replacement guide
downloads:
3
Views:
21
Important!
This replacement procedure can be used for:
RENAULT MEGANE II (BM0/1_, CM0/1_) 1.4 16V (BM0B, CM0B), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.6 16V (BM0C, CM0C), RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 16V (BM0U, CM0U), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM0F, BM0T, BM2B, CM0F, CM0T), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi (BM0G, CM0G), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM02, BM13, BM2A, CM02, CM13), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.4 16V, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 16V Turbo, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM1F, CM1F), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM1E, CM1E), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 dCi (BM1K, CM1K), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM16, CM16), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.6 16V, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi … View more
The steps may slightly vary depending on the car design.
RENAULT MEGANE II (BM0/1_, CM0/1_) 1.4 16V (BM0B, CM0B), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.6 16V (BM0C, CM0C), RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 16V (BM0U, CM0U), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM0F, BM0T, BM2B, CM0F, CM0T), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi (BM0G, CM0G), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM02, BM13, BM2A, CM02, CM13), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.4 16V, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 16V Turbo, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM1F, CM1F), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM1E, CM1E), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 2.0 dCi (BM1K, CM1K), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.5 dCi (BM16, CM16), RENAULT MEGANE II (BM0/1_, CM0/1_) 1.6 16V, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi, RENAULT MEGANE II (BM0/1_, CM0/1_) 1.9 dCi … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Springs for MEGANE II (BM0/1_, CM0/1_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 10
Drive socket # 18
Combination spanner #18
Wheel impact socket #19
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: coil springs – RENAULT MEGANE II (BM0/1_, CM0/1_). Tip from AUTODOC experts:
- Both coil springs of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right coil springs of the rear suspension.
- Please note: all work on the car – RENAULT MEGANE II (BM0/1_, CM0/1_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 3Raise the rear of the car and secure on supports.Step 4
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. RENAULT MEGANE II (BM0/1_, CM0/1_) - Step 5
Remove the wheel. - Step 6
Unscrew the fastener of the rear axle plastic protecting cover. Use a drive socket #10. Use a ratchet wrench. - Step 7
Detach the fastener of the rear axle plastic protecting cover. Use a crowbar. - Step 8
Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray. - Step 9
Secure the rear axle beam. Use a hydraulic transmission jack. - Step 10
Unscrew the lower fastener of the shock absorber. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench. Use a tap wrench. - Step 11
Detach the lower part of the shock absorber. Use a crowbar. - Step 12
Remove the mounting from under the rear axle beam.AUTODOC recommends:Replacement: coil springs – RENAULT MEGANE II (BM0/1_, CM0/1_). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms. - Step 13
Pull down the rear suspension beam. Use a crowbar. Take out the spring. - Step 14Inspect the rubber mounts of the suspension spring. Replace if necessary.Step 15
Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray. - Step 16
Install the coil spring together with the rubber mounts into the mounting seats.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Megane II Hatchback (BM, CM) model
Popular maintenance tutorials for Renault Megane 2
Complete guides for changing the Springs on different RENAULT MEGANE models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT MEGANE II (BM0/1_, CM0/1_)
View more
5 easy car repairs you can do without a garage visit
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide
5 mistakes made when washing the engine | AUTODOC tips
Can You Hear Your Brakes Squeaking? Learn the Causes and DIY Solutions! | AUTODOC Tips
Most commonly replaced car parts on RENAULT MEGANE
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



























