Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
TOYOTA Verso S (_P12_) 1.33 (NSP120_), TOYOTA Verso S (_P12_) 1.4 D4-D (NLP121_), TOYOTA Verso S (_P12_) 1.33 (NSP120_) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Verso S (_P12_) and other TOYOTA models

Alternative products

Brake pad set

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Combination spanner #14
                    
                      Combination spanner #17
                    
                      Drive socket # 14 
                    
                      Wheel impact socket #21
                    
                      Brake caliper wind back tool
                    
                      Torque wrench
                    
                      Water pump pliers
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Professionals recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Warning! Shut down the engine before starting any work – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_).

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #21.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Detach the parking brake cable from the bracket on the brake caliper. Use water pump pliers.
Step 9

Unscrew the brake caliper fastening. Use a combination spanner #14. Use a combination spanner #17.
Step 10

Spread the brake pads. Use a crowbar.

Step 11

Remove the brake caliper.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 12

Remove the brake pads.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 13

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). After applying the spray, wait a few minutes.
Step 14

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Tip:
Make sure the disc surface is clean before installing the pads.
Step 15

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 16

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 17

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 18

Install the brake caliper and fix it. Use a combination spanner #17. Use a drive socket #14. Use a torque wrench. Tighten it to 35 Nm torque.
Step 19

Install the parking brake cable into the brake caliper bracket.
Step 20

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 21

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). After applying the spray, wait a few minutes.
Step 22

Install the wheel.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Tip:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 23

Screw in the wheel bolts. Use wheel impact socket #21.
Step 24

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 103 Nm torque.
Step 25

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Check the brake fluid level in the reservoir and top up if necessary.
Step 26

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
TOYOTA VERSO S (NLP12_, NCP12_, NSP12_) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 27

Close the hood.

Replacement: brake pads – TOYOTA VERSO S (NLP12_, NCP12_, NSP12_). Tip from AUTODOC experts:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA Verso S (P120) model

Toyota Verso-S 120D tyre size

How to change front brake pads on TOYOTA Verso S (_P12_) – replacement guide

Free download PDF
1.56 MB
How to change front wheel bearing on TOYOTA Verso S (P120) – replacement guide

Free download PDF
3.91 MB
How to change front wheel bearing on TOYOTA Verso S (_P12_) – replacement guide

Free download PDF
3.7 MB
How to change spark plugs on TOYOTA Verso S (_P12_) – replacement guide

Free download PDF
1.06 MB
How to change rear windshield wipers on TOYOTA Verso S (_P12_) – replacement guide

Free download PDF
583.68 KB
How to change engine oil and filter on TOYOTA Verso S (P120) – replacement guide

Free download PDF
2.04 MB

How to change front brake pads on TOYOTA Verso S (_P12_) – replacement guide

Free download PDF
1.56 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on Toyota Prado J120 – replacement guide

Free download PDF
2.08 MB
How to change rear brake pads on Toyota Auris E15 – replacement guide

Free download PDF
1.53 MB
How to change rear brake pads on Toyota Prado J120 – replacement guide

Free download PDF
1.93 MB
How to change front brake pads on Toyota Aygo AB1 – replacement guide

Free download PDF
2.47 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How to Make a DIY Foam Sprayer | AUTODOC tips

351K views

Published on: 23/06/2022
Engine Overheating? Replace Your Cooling Fan to Fix It

6K views

Published on: 15/11/2020
#DIY guide: Changing your car's color with a spray can | AUTODOC tips

5K views

Published on: 25/03/2021
DIY starter repair | AUTODOC tips

131K views

Published on: 31/08/2023